Researcher profile

Laurent Duraffourg

Laurent Duraffourg contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

Trust snapshot

Quick read

Trust 21 - Emerging
9works
0followers
5topics
4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Research graph

See the researcher in context

Open full explorer

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

9 published item(s)

preprint2020arXiv

Linear analytical approach to dispersive, external and intrinsic dissipative couplings in optomechanical systems

We present a theoretical study of optomechanical systems in which the mechanical resonator modulates both the resonant frequency (dispersive coupling) and the decay rates (dissipative coupling) of the optical cavity. We extend the generic dispersive framework to a more general case in which the dissipative coupling is split between its external and intrinsic contribution. We report a complete analysis of the influence of each kind of optical losses (intrinsic and external) on the three coupling mechanisms and highlight the interest of each external decay rate regime. The basic tools to experimentally identify the three couplings and their relative influence on the optical response are presented. We demonstrate the general expression of the optical spring effect and optomechanical damping. Comparison between experimental measurements in photonic crystal systems from the literature and our theoretical modal yields good agreement.

preprint2016arXiv

Frequency fluctuations in silicon nanoresonators

Frequency stability is key to performance of nanoresonators. This stability is thought to reach a limit with the resonator's ability to resolve thermally-induced vibrations. Although measurements and predictions of resonator stability usually disregard fluctuations in the mechanical frequency response, these fluctuations have recently attracted considerable theoretical interest. However, their existence is very difficult to demonstrate experimentally. Here, through a literature review, we show that all studies of frequency stability report values several orders of magnitude larger than the limit imposed by thermomechanical noise. We studied a monocrystalline silicon nanoresonator at room temperature, and found a similar discrepancy. We propose a new method to show this was due to the presence of frequency fluctuations, of unexpected level. The fluctuations were not due to the instrumentation system, or to any other of the known sources investigated. These results challenge our current understanding of frequency fluctuations and call for a change in practices.

preprint2015arXiv

Neutral particle Mass Spectrometry with Nanomechanical Systems

Current approaches to Mass Spectrometry (MS) require ionization of the analytes of interest. For high-mass species, the resulting charge state distribution can be complex and difficult to interpret correctly. In this article, using a setup comprising both conventional time-of-flight MS (TOF-MS) and Nano-Electro-Mechanical-Systems-based MS (NEMS-MS) in situ, we show directly that NEMS-MS analysis is insensitive to charge state: the spectrum consists of a single peak whatever the species charge state, making it significantly clearer than existing MS analysis. In subsequent tests, all charged particles are electrostatically removed from the beam, and unlike TOF-MS, NEMS-MS can still measure masses. This demonstrates the possibility to measure mass spectra for neutral particles. Thus, it is possible to envisage MS-based studies of analytes that are incompatible with current ionization techniques and the way is now open for the development of cutting edge system architectures with unique analytical capability.

preprint2015arXiv

Overcoming limitations of nanomechanical resonators with simultaneous resonances

Dynamic stabilization by simultaneous primary and superharmonic resonances for high order nonlinearity cancellation is demonstrated with an electrostatically-actuated, piezoresistively-transduced nanomechanical resonator. We prove experimentally how the combination of both the third-order nonlinearity cancellation and simultaneous resonances can be used to linearly drive a nanocantilever up to very large amplitudes compared to fundamental limits like pull-in occurrence, opening the way towards resonators with high frequency stability for high-performance sensing or time reference.

preprint2013arXiv

High Frequency top-down Junction-less Silicon Nanowire Resonators

We report here the first realization of top-down silicon nanowires (SiNW) transduced by both junction-less field effect transistor (FET) and the piezoresistive (PZR) effect. The suspended SiNWs are among the smallest top-down SiNWs reported to date, featuring widths down to ~20nm. This has been achieved thanks to a 200mm-wafer-scale, VLSI process fully amenable to monolithic CMOS co-integration. Thanks to the very small dimensions, the conductance of the silicon nanowire can be controlled by a nearby electrostatic gate. Both the junction-less FET and the previously demonstrated PZR transduction have been performed with the same SiNW. These self-transducing schemes have shown similar signal-to-background ratios, and the PZR transduction has exhibited a relatively higher output signal. Allan deviation AD of the same SiNW has been measured with both schemes, and we obtain AD~20ppm for the FET detection and AD~3ppm for the PZR detection at room temperature and low pressure. Orders of magnitude improvements are expected from tighter electrostatic control via changes in geometry and doping level, as well as from CMOS integration. The compact, simple topology of these elementary SiNW resonators opens up new paths towards ultra-dense arrays for gas and mass sensing, time keeping or logic switching systems in SiNW-CMOS platform.

preprint2012arXiv

Comparison of capacitive and frequential readout when scaling accelerometers down from Micro- to Nano- Electro Mechanical Systems

This paper shows the effect of scaling silicon accelerometers down from MEMS to NEMS. It models both electronics and Brownian noise sources for both capacitive and resonant devices, and computes the minimum detectable signal attainable. Computed results are remarkably close to published experimental results. It shows the relatively low influence of the quality factor and of the beam width in the resonant case. Different scaling rules are investigated, and it appears that resonant sensing may satisfy some new application requirements, in particular for critical dimensions below a few hundreds of nm, when it is better resolved than capacitive sensing.

preprint2010arXiv

Compact and explicit physical model for lateral metal-oxide-semiconductor field-effect transistor with nanoelectromechanical system based resonant gate

We propose a simple analytical model of a metal-oxide-semiconductor field-effect transistor with a lateral resonant gate based on the coupled electromechanical equations, which are self-consistently solved in time. All charge densities according to the mechanical oscillations are evaluated. The only input parameters are the physical characteristics of the device. No extra mathematical parameters are used to fit the experimental results. Theoretical results are in good agreement with the experimental data in static and dynamic operation. Our model is comprehensive and may be suitable for any electromechanical device based on the field-effect transduction.

preprint2010arXiv

In-plane nanoelectromechanical resonators based on silicon nanowire piezoresistive detection

We report an actuation/detection scheme with a top-down nano-electromechanical system for frequency shift-based sensing applications with outstanding performance. It relies on electrostatic actuation and piezoresistive nanowire gauges for in-plane motion transduction. The process fabrication is fully CMOS compatible. The results show a very large dynamic range (DR) of more than 100dB and an unprecedented signal to background ratio (SBR) of 69dB providing an improvement of two orders of magnitude in the detection efficiency presented in the state of the art in NEMS field. Such a dynamic range results from both negligible 1/f-noise and very low Johnson noise compared to the thermomechanical noise. This simple low-power detection scheme paves the way for new class of robust mass resonant sensor.

preprint2010arXiv

Self-oscillation conditions of a resonant-nano-electromechanical mass sensor

This article presents a comprehensive study and design methodology of co-integrated oscillators for nano mass sensing application based on resonant Nano-Electro-Mechanical-System (NEMS). In particular, it reports the capacitive with the piezoresistive transduction schemes in terms of the overall sensor performance. The developed model is clearly in accordance with the general experimental observations obtained for NEMS-based mass detection. The piezoresistive devices are much sensitive (up to 10 zg/?Hz) than capacitive ones (close to 100 zg/?Hz) since they can work at higher frequency. Moreover, the high doped silicon piezoresistive gauge, which is of a great interest for very large scale integration displays similar theoretical resolution than the metallic gauge already used experimentally.