Analysis of Femoral Components of Cemented Total Hip- Arthroplasty
In cemented Total Hip Arthroplasty (THA), material chosen for femoral stem and cross section of stem itself, proved to be critical parameters for, stress distribution in the femoral components, interfacial stresses and micro movements. Titanium alloy (Ti6Al4V), when used as a material for femoral stem, recorded large displacement as compared to Chromium alloy (CoCrMo) stems. This large displacement in case of Ti6Al4V caused the stem to bend inside the cement mantle, thus destroying it. Thus, CoCrMo proved to be a better in cemented THA. Failure in THA may occur at cement-stem or cement-bone interface, thus interfacial stresses and micro movements were analysed in the present study. Comparison between trapezium and circular cross section showed that, femoral stem with trapezium cross section underwent lesser amount of sliding and debonding, at both interfaces, as compared to circular cross section. Moreover, trapezium cross section also generated lower peak stresses in femoral stem and cortical femur. The present study also took into account, effect of diameter of femur head. A 36mm diameter femur head generated lower peak stress in acetabulum liner and arrested dislocation. Metallic femur head was coupled with a liner made of cross linked polyethylene (XLPE). This material experiences almost negligible wear when compared to typical metallic and polyethylene liners, and unlike metallic liner, it is non-carcinogenic.
