Source author record

R. E. Lake

Explore this author’s publications, collaborators and research topics. This catalog record has not been claimed by its author.

ResearcherUnclaimed source record

cond-mat.mes-hall cond-mat.other physics.app-ph physics.ins-det quant-ph

Catalog footprint

Research overview

5works

5topics

4close collaborators

Actions

Is this your work?

Open graph Browse papers

preprint2020arXiv

Dielectric loss extraction for superconducting microwave resonators

The investigation of two-level-state (TLS) loss in dielectric materials and interfaces remains at the forefront of materials research in superconducting quantum circuits. We demonstrate a method of TLS loss extraction of a thin film dielectric by measuring a lumped element resonator fabricated from a superconductor-dielectric-superconductor trilayer. We extract the dielectric loss by formulating a circuit model for a lumped element resonator with TLS loss and then fitting to this model using measurements from a set of three resonator designs: a coplanar waveguide resonator, a lumped element resonator with an interdigitated capacitor, and a lumped element resonator with a parallel plate capacitor that includes the dielectric thin film of interest. Unlike other methods, this allows accurate measurement of materials with TLS loss lower than $10^{-6}$ . We demonstrate this method by extracting a TLS loss of $1.02 \times 10^{-3}$ for sputtered $\mathrm{Al_2O_3}$ using a set of samples fabricated from an $\mathrm{Al/Al_2O_3/Al}$ trilayer. We observe a difference of 11 $\%$ between extracted loss of the trilayer with and without the implementation of this method.

preprint2018arXiv

Nanobolometer with Ultralow Noise Equivalent Power

Since the introduction of bolometers more than a century ago, they have been applied in a broad spectrum of contexts ranging from security and the construction industry to particle physics and astronomy. However, emerging technologies and missions call for faster bolometers with lower noise. Here, we demonstrate a nanobolometer that exhibits roughly an order of magnitude lower noise equivalent power, $20\textrm{ zW}/\sqrt{\textrm{Hz}}$ , than previously reported for any bolometer. Importantly, it is more than an order of magnitude faster than other low-noise bolometers, with a time constant of 30 $μ$ s at $60\textrm{ zW}/\sqrt{\textrm{Hz}}$ . These results suggest a calorimetric energy resolution of $0.3\textrm{ zJ}=h\times 0.4$ THz with a time constant of 30 $μ$ s. Thus the introduced nanobolometer is a promising candidate for future applications requiring extreme precision and speed such as those in astronomy and terahertz photon counting.

preprint2016arXiv

Detection of zeptojoule microwave pulses using electrothermal feedback in proximity-induced Josephson junctions

We experimentally investigate and utilize electrothermal feedback in a microwave nanobolometer based on a normal-metal ($\mbox{Au}_{x}\mbox{Pd}_{1-x}$) nanowire with proximity-induced superconductivity. The feedback couples the temperature and the electrical degrees of freedom in the nanowire, which both absorbs the incoming microwave radiation, and transduces the temperature change into a radio-frequency electrical signal. We tune the feedback in situ and access both positive and negative feedback regimes with rich nonlinear dynamics. In particular, strong positive feedback leads to the emergence of two metastable electron temperature states in the millikelvin range. We use these states for efficient threshold detection of coherent 8.4 GHz microwave pulses containing approximately 200 photons on average, corresponding to $1.1 \mbox{ zJ} \approx 7.0 \mbox{ meV}$ of energy.

preprint2014arXiv

Energy and Charge Transfer for Na+ Ions Scattered from a Ag(001) Surface

We present energy- and charge-resolved measurements of low and hyperthermal energy Na+ ions scattered from a Ag(001) surface. With the primary ion beam oriented along the [110] crystal direction, distinct peaks in the energy distributions of the scattered beam flux that correspond to single or multiple collisions with target atoms are observed. A classical trajectory simulation reveals that these collisions can occur either at the surface or within the [110] channels, depending on incident beam energy. Within the simulation we probe the role of finite temperature and thermally displaced atoms on specific scattering events and show that contributions to the scattered distributions from single and double collisions dominate within the [110] channels. We also report velocity dependent measurements of the neutral/ion ratio of the scattered beam flux. A deviation between the data and simulated charge transfer results is observed for Na trajectories which penetrate the surface.

preprint2014arXiv

Microwave nanobolometer based on proximity Josephson junctions

We introduce a microwave bolometer aimed at high-quantum-efficiency detection of wave packet energy within the framework of circuit quantum electrodynamics, the ultimate goal being single microwave photon detection. We measure the differential thermal conductance between the detector and its heat bath, obtaining values as low as 5 fW/K at 50 mK. This is one tenth of the thermal conductance quantum and corresponds to a theoretical lower bound on noise-equivalent-power of order $10^{-20}$ $W/\sqrt{\mbox{Hz}}$ at 50 mK. By measuring the differential thermal conductance of the same bolometer design in qualitatively different environments and materials, we determine that electron--photon coupling dominates the thermalization of our nanobolometer.

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.