Source author record

Kaigui Zhu

Kaigui Zhu appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.mtrl-sci physics.ins-det physics.optics

Catalog footprint

What is connected

4works

3topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2016arXiv

Effects of nickel doping on the preferred orientation and oxidation potential of Ti/Sb-SnO2 anodes prepared by spray pyrolysis

Nickel and antimony co-doped Ti/SnO2 (Ti/Ni-Sb-SnO2) anodes were prepared by spray pyrolysis. Effects of nickel concentration on the structure and onset potential for oxygen evolution of Ti/Ni-Sb-SnO2 anodes have been systematically investigated. XRD analyses suggest that SnO2 thin films grow in preferential orientation along (101) plane as the nickel concentration increases. The enhanced onset potential of oxygen is above 2.4 V vs NHE due to the introduction of nickel doping, and increases slightly with the nickel concentration. The calculated results show that work function of Ni/Sb co-doped SnO2 also increases with the Ni doping level, which contributes to the enhancement of onset potential for oxygen evolution.

preprint2016arXiv

Understanding effects of TCO work function on the performance of organic solar cells by numerical simulation

The influences of work function of transparent conducting oxides (TCO) on the per-formance of organic solar cells, including open circuit voltage, conversion efficiency and fill factor, has been simulated. It is obtained that for non-Ohmic contact the open circuit voltage and conversion efficiency increase monotonically with the TCO work function but keep constant for Ohmic contact. Fill factor decreases and increases with the electrode work function when the electrode work function is below and above a critical value (4.2 eV for TCO and 4.5 eV for back-contact), respectively. The results of this simulation are significant in the choice of TCO contacts to optimize organic planar heterojunction solar cells.

preprint2015arXiv

ZnO/a-Si Distributed Bragg Reflectors for Light Trapping in Thin Film Solar Cells from Visible to Infrared Range

Distributed bragg reflectors (DBRs) consisting of ZnO and amorphous silicon (a-Si) were prepared by magnetron sputtering method for selective light trapping. The quarter-wavelength ZnO/a-Si DBRs with only 6 periods exhibit a peak reflectance of above 99% and have a full width at half maximum that is greater than 347 nm in the range of visible to infrared. The 6-pair reversed quarter-wavelength ZnO/a-Si DBRs also have a peak reflectance of 98%. Combination of the two ZnO/a-Si DBRs leads to a broader stopband from 686 nm to 1354 nm. Using the ZnO/a-Si DBRs as the rear reflector of a-Si thin film solar cells significantly increases the photocurrent in the spectrum range of 400 nm to 1000 nm, in comparison with that of the cells with Al reflector. The obtained results suggest that ZnO/a-Si DBRs are promising reflectors of a-Si thin-film solar cells for light trapping.

preprint2013arXiv

A new investigation of oxygen flow influence on ITO thin films by magnetron sputtering

ITO thin films were deposited on glass substrates by d.c. magnetron sputtering with varied oxygen flow rates. It was found that the optical absorption decreases and optical absorption edge has blue shifts with the increasing oxygen flow rate. Oxygen vacancy concentration was characterized and analyzed by XPS. It is shown that the oxygen vacancy concentration increases with oxygen flow rates, which is a different observation from the current understanding. The energy band structures associated with different vacancy concentrations of ITO were calculated using the first-principle based on density functional theory. The calculation results show that the increase of oxygen vacancies induces the increase of bands below Fermi level as well as the presence of a second band gap, which accounts for effects of the oxygen vacancies on the blue shifts.