Source author record

J. Griffiths

J. Griffiths appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

6works
7topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

6 published item(s)

preprint2020arXiv

Radio-frequency reflectometry of a quantum dot using an ultra-low-noise SQUID amplifier

Fault-tolerant spin-based quantum computers will require fast and accurate qubit readout. This can be achieved using radio-frequency reflectometry given sufficient sensitivity to the change in quantum capacitance associated with the qubit states. Here, we demonstrate a 23-fold improvement in capacitance sensitivity by supplementing a cryogenic semiconductor amplifier with a SQUID preamplifier. The SQUID amplifier operates at a frequency near 200 MHz and achieves a noise temperature below 600 mK when integrated into a reflectometry circuit, which is within a factor 120 of the quantum limit. It enables a record sensitivity to capacitance of 0.07 aF/\sqrt{Hz}. The setup is used to acquire charge stability diagrams of a gate-defined double quantum dot in a short time with a signal-to-noise ration of about 38 in 1 microsecond of integration time.

preprint2016arXiv

A study of the optical and polarisation properties of InGaN/GaN multiple quantum wells grown on a-plane and m-plane GaN substrates

In this paper we report on a comparative study of the low temperature emission and polarisation properties of InGaN/GaN quantum wells (QWs) grown on nonpolar a-plane and m-plane free-standing bulk GaN substrates where the In content varied from 0.14 to 0.28 in the m-plane series and 0.08 to 0.21 for the a-plane series. The low temperature photoluminescence spectra from both sets of samples are very broad with full width at half-maximum height increasing from 81 to 330 meV as the In fraction increases. Comparative photoluminescence excitation spectroscopy indicates that the recombination mainly involves strongly localised carriers. At a temperature of 10 K the degree of linear polarisation of the a-plane samples is much smaller than of the m-plane counterparts and also varies across the spectrum. From polarisation-resolved photoluminescence excitation spectroscopy we measured the energy splitting between the lowest valence sub-band states to lie in the range of 23-54 meV for both a-and m-plane samples in which we could observe distinct exciton features in the polarised photoluminescence excitation spectroscopy. Thus, the thermal occupation of a higher valence subband cannot be responsible for the reduction of the degree of linear polarisation. Time-resolved spectroscopy indicates that in a-plane samples there is an extra emission component which at least partly responsible for the reduction in the degree of linear polarisation.

preprint2015arXiv

Radio-frequency capacitance spectroscopy of metallic nanoparticles

Recent years have seen great progress in our understanding of the electronic properties of nanomaterials in which at least one dimension measures less than 100 nm. However, contacting true nanometer scale materials such as individual molecules or nanoparticles remains a challenge as even state-of-the-art nanofabrication techniques such as electron-beam lithography have a resolution of a few nm at best. Here we present a fabrication and measurement technique that allows high sensitivity and high bandwidth readout of discrete quantum states of metallic nanoparticles which does not require nm resolution or precision. This is achieved by coupling the nanoparticles to resonant electrical circuits and measurement of the phase of a reflected radio-frequency signal. This requires only a single tunnel contact to the nanoparticles thus simplifying device fabrication and improving yield and reliability. The technique is demonstrated by measurements on 2.7 nm thiol coated gold nanoparticles which are shown to be in excellent quantitative agreement with theory.

preprint2015arXiv

Sensitive radio-frequency measurements of a quantum dot by tuning to perfect impedance matching

Electrical readout of spin qubits requires fast and sensitive measurements, but these are hindered by poor impedance matching to the device. We demonstrate perfect impedance matching in a radio-frequency readout circuit, realized by incorporating voltage-tunable varactors to cancel out parasitic capacitances. In the optimized setup, a capacitance sensitivity of $1.6~\mathrm{aF}/\sqrt{\mathrm{Hz}}$ is achieved at a maximum source-drain bias of $170~μ$V root-mean-square and with bandwidth above $15~$MHz. Coulomb blockade is measured via both conductance and capacitance in a quantum dot, and the two contributions are found to be proportional, as expected from a quasistatic tunneling model. We benchmark our results against the requirements for single-shot qubit readout using quantum capacitance, a goal that has so far been elusive.

preprint2013arXiv

A non-invasive electron thermometer based on charge sensing of a quantum dot

We present a thermometry scheme to extract the temperature of a 2DEG by monitoring the charge occupation of a weakly tunnel-coupled 'thermometer' quantum dot using a quantum point contact detector. Electronic temperatures between 97 mK and 307 mK are measured by this method with an accuracy of up to 3 mK, and agree with those obtained by measuring transport through a quantum dot. The thermometer does not pass a current through the 2DEG, and can be incorporated as an add-on to measure the temperature simultaneously with another operating device. Further, the tuning is independent of temperature.

preprint2013arXiv

Handbook of LHC Higgs Cross Sections: 3. Higgs Properties

This Report summarizes the results of the activities in 2012 and the first half of 2013 of the LHC Higgs Cross Section Working Group. The main goal of the working group was to present the state of the art of Higgs Physics at the LHC, integrating all new results that have appeared in the last few years. This report follows the first working group report Handbook of LHC Higgs Cross Sections: 1. Inclusive Observables (CERN-2011-002) and the second working group report Handbook of LHC Higgs Cross Sections: 2. Differential Distributions (CERN-2012-002). After the discovery of a Higgs boson at the LHC in mid-2012 this report focuses on refined prediction of Standard Model (SM) Higgs phenomenology around the experimentally observed value of 125-126 GeV, refined predictions for heavy SM-like Higgs bosons as well as predictions in the Minimal Supersymmetric Standard Model and first steps to go beyond these models. The other main focus is on the extraction of the characteristics and properties of the newly discovered particle such as couplings to SM particles, spin and CP-quantum numbers etc.