Source author record

C. Deibel

C. Deibel appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

11works
2topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

11 published item(s)

preprint2012arXiv

Charge density dependent nongeminate recombination in organic bulk heterojunction solar cells

Apparent recombination orders exceeding the value of two expected for bimolecular recombination have been reported for organic solar cells in various publications. Two prominent explanations are bimolecular losses with a carrier concentration dependent prefactor due to a trapping limited mobility, and protection of trapped charge carriers from recombination by a donor--acceptor phase separation until reemission from these deep states. In order to clarify which mechanism is dominant we performed temperature and illumination dependent charge extraction measurements under open circuit as well as short circuit conditions at poly(3-hexylthiophene-2,5-diyl):[6,6]-phenyl-C$_{61}$butyric acid methyl ester (P3HT:PC$_{61}$BM) and PTB7:PC$_{71}$BM (Poly[[4,8-bis[(2-ethylhexyl)oxy]benzo[1,2-b:4,5-b']dithiophene-2,6-diyl][3-fluoro-2-[(2-ethylhexyl)carbonyl]thieno[3,4-b]thiophenediyl]]) solar cells in combination with current--voltage characteristics. We show that the charge carrier density $n$ dependence of the mobility $μ$ and the recombination prefactor are different for PC$_{61}$BM at temperatures below 300K and PTB7:PC$_{71}$BM at room temperature. Therefore, in addition to $μ(n)$ a detrapping limited recombination in systems with at least partial donor--acceptor phase separation is required to explain the high recombination orders.

preprint2012arXiv

Shockley Equation Parameters of Organic Solar Cells derived by Transient Techniques

The Shockley equation (SE), originally derived to describe a p--n junction, was frequently used in the past to simulate current--voltage (j/V) characteristics of organic solar cells (OSC). In order to gain a more detailed understanding of recombination losses, we determined the SE parameters, i.e. the ideality factor and the dark saturation current, from temperature dependent static j/V-measurements on poly(3-hexylthiophene-2,5-diyl)(P3HT):[6,6]-phenyl-C$_{61}$ butyric acid methyl ester (PCBM) bulk heterojunction solar cells. As we show here, these parameters are directly related to charge carrier recombination and become also accessible by transient photovoltage and photocurrent methods in the case of field-independent charge carrier generation. Although determined in very different ways, both SE parameters were found to be identical. The good agreement of static and transient approaches over a wide temperature range demonstrates the validity of the Shockley model for OSC based on material systems satisfying the requirement of field-independent polaron-pair dissociation. In particular, we were able to reproduce the photocurrent at various light intensities and temperatures from the respective nongeminate recombination rates. Furthermore, the temperature dependence of the dark saturation current $j_0$ allowed determining the effective band gap of the photoactive blend perfectly agreeing with the literature values of the energy onset of the photocurrent due to charge transfer absorption. We also present a consistent model directly relating the ideality factor to recombination of free with trapped charge carriers in an exponential density of tail states. We verify this finding by data from thermally stimulated current measurements.

preprint2011arXiv

First principles calculations of anisotropic charge carrier mobilities in organic semiconductor crystals

The orientational dependence of charge carrier mobilities in organic semiconductor crystals and the correlation with the crystal structure are investigated by means of quantum chemical first principles calculations combined with a model using hopping rates from Marcus theory. A master equation approach is presented which is numerically more efficient than the Monte Carlo method frequently applied in this context. Furthermore, it is shown that the widely used approach to calculate the mobility via the diffusion constant along with rate equations is not appropriate in many important cases. The calculations are compared with experimental data, showing good qualitative agreement for pentacene and rubrene. In addition, charge transport properties of core-fluorinated perylene bisimides are investigated.

preprint2010arXiv

Comment on "Interface state recombination in organic solar cells"

In a recent paper, Street et al. [Phys. Rev. B 81, 205307 (2010)] propose first order recombination due to interface states to be the dominant loss mechanism in organic bulk heterojunction solar cells, based on steady-state current--voltage characteristics. By applying macroscopic simulations, we found that under typical solar cell conditions, monomolecular or bimolecular recombination cannot be inferred from the slope of the light intensity dependent photocurrent. In addition, we discuss the validity of calculating a mobility--lifetime product from steady-state measurements. We conclude that the experimental technique applied by Street et al. is not sufficient to unambiguously determine the loss mechanism.

preprint2010arXiv

Investigation of the Photocurrent in Bulk Heterojunction Solar Cells

We investigated the photocurrent in poly(3-hexylthiophene-2,5-diyl) (P3HT):[6,6]-phenyl-C$_{61}$ butyric acid methyl ester (PCBM) solar cells by applying a pulsed measurement technique. For annealed samples, a point of optimal symmetry (POS) with a corresponding voltage $V_\text{POS}$ of 0.52--0.64 V could be determined. Based on macroscopic simulations and results from capacitance--voltage measurements, we identify this voltage with flat band conditions in the bulk of the cell, but not the built-in voltage as proposed by [Ooi et al., J. Mater. Chem. 18 (2008) 1644]. We calculated the field dependent polaron pair dissociation after Onsager--Braun and the voltage dependent extraction of charge carriers after Sokel and Hughes with respect to this point of symmetry. Our analysis allows to explain the experimental photocurrent in both forward and reverse directions. Also, we observed a voltage--independent offset of the photocurrent. As this offset is crucial for the device performance, we investigated its dependence on cathode material and thermal treatment. From our considerations we gain new insight into the photocurrent`s voltage dependence and the limitations of device efficiency.

preprint2010arXiv

Organic solar cell efficiencies under the aspect of reduced surface recombination velocities

The charge carrier mobility is a key parameter for the organic bulk heterojunction solar cell efficiency. It was recently shown that the interplay charge carrier transport and recombination, both depending on electron and hole mobilities, leads to a point of maximum power conversion efficiency at a finite mobility. Changes of bulk and surface recombination rate, however, can strongly influence this behavior. These processes were previously not considered adequately, as surface recombination velocities of infinity were implicitly assumed or bulk recombination parameters not discussed in detail. In this manuscript, using a macroscopic effective medium simulation, we consider how a reduced bulk recombination process in combination with finite surface recombination velocities affect the power conversion efficiency. Instead of a maximum efficiency at a specific charge carrier mobility, we show that with realistic assumptions and passivated surfaces the efficiency is increased further, saturating only at higher mobilities. Thus, a mobility optimisation is more important for the solar cell performance then previously shown.

preprint2010arXiv

Role of Polaron Pair Diffusion and Surface Losses in Organic Semiconductor Devices

By applying Monte Carlo simulations we found that the extraction of bound polaron pairs (PP) at the electrodes is an important loss factor limiting the efficiency of organic optoelectronic and photovoltaic devices. Based upon this finding, we developed a unified analytic model consisting of exact Onsager theory, describing the dissociation of PP in organic donor-acceptor heterojunctions, the Sokel-Hughes model for the extraction of free polarons at the electrodes, as well as of PP diffusion leading to the aforementioned loss mechanism, which was not considered previously. Our approach allows to describe the simulation details on a macroscopic scale and to gain fundamental insights, which is important in view of developing an optimized photovoltaic device configuration.

preprint2010arXiv

S-shaped current-voltage characteristics of organic solar devices

Measuring the current-voltage characteristic of organic bulk heterojunction solar devices sometimes reveals an s-shaped deformation. We qualitatively produce this behaviour by a numerical device simulation assuming a reduced surface recombination. Furthermore we show how to experimentally create these double diodes by applying an oxygen plasma etch on the indium tin oxide (ITO) anode. Restricted charge transport over material interfaces accumulates space charges and therefore creates s-shaped deformations. Finally we discuss the consequences of our findings for the open circuit voltage $V_{oc}$

preprint2010arXiv

Spectroscopic Signatures of Photogenerated Radical Anions in Polymer-[C70]Fullerene Bulk Heterojunctions

Light induced polarons in solid films of polymer-fullerene blends were studied by applying photoluminescence (PL), photo induced absorption (PIA) techniques as well as electron spin resonance (ESR). The materials used were poly(3-hexylthiophene) (P3HT) and poly-[2-methoxy, 5-(2'-ethyl-hexyloxy) phenylene vinylene] (MEH-PPV) as donors. As acceptors we used [6,6]-phenyl-C61-butyric acid methyl ester ([C60]PCBM) and various soluble C70-derivates: [C70]PCBM, diphenylmethano[70]fullerene oligoether (C70-DPM-OE), C70-DPM-OE2, and two fullerene dimers, C70-C70 and C60-C70 (all shown in figure 1). In all blends containing C70 we found typical signatures which were absent if [C60]PCBM was used as acceptor. Light-induced ESR revealed signals at g>=2.005, which we previously assigned to an electron localized on the C70 cage, the PIA measurements showed a new sub-bandgap absorption band at 0.92 eV, which we correspondingly ascribe to C70 radical anions formed in the course of photoinduced electron transfer from donor to acceptor.

preprint2009arXiv

Polaron Recombination in Pristine and Annealed Bulk Heterojunction Solar Cells

The major loss mechanism of photogenerated polarons was investigated in P3HT:PCBM solar cells by the photo-CELIV technique. For pristine and annealed devices, we find that the experimental data can be explained by a bimolecular recombination rate reduced by a factor of about ten (pristine) and 25 (annealed) as compared to Langevin theory. Aided by a macroscopic device model, we discuss the implications of the lowered loss rate on the characteristics of polymer:fullerene solar cells.

preprint2008arXiv

Influence of Charge Carrier Mobility on the Performance of Organic Solar Cells

The power conversion efficiency of organic solar cells based on donor--acceptor blends is governed by an interplay of polaron pair dissociation and bimolecular polaron recombination. Both processes are strongly dependent on the charge carrier mobility, the dissociation increasing with faster charge transport, with raised recombination losses at the same time. Using a macroscopic effective medium simulation, we calculate the optimum charge carrier mobility for the highest power conversion efficiency, for the first time accounting for injection barriers and a reduced Langevin-type recombination. An enhancement of the charge carrier mobility from $10^{-8}$m$^2$/Vs for state of the art polymer:fullerene solar cells to about $10^{-6}$m$^2$/Vs, which yields the maximum efficiency, corresponds to an improvement of only about 20% for the given parameter set.