Source author record

Andrew Dane

Andrew Dane appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

5works
5topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

5 published item(s)

preprint2020arXiv

Large-area microwire MoSi single-photon detectors at 1550 nm wavelength

We demonstrate saturated internal detection efficiency at 1550 nm wavelengths for meander-shaped superconducting nanowire single-photon detectors made of 3 nm thick MoSi films with widths of 1 and 3 $μm$, and active areas up to 400 by 400 $μm^2$. Despite hairpin turns and a large number of squares (up to $10^4$) in the device, the dark count rate was measured to be ~10$^3$ cps at 99% of the switching current. This value is about two orders of magnitude lower than results reported recently for short MoSi devices with shunt resistors. We also found that 5 nm thick MoSi detectors with the same geometry were insensitive to single near-infrared photons, which may be associated with different levels of suppression of the superconducting order parameter. However, our results obtained on 3 nm thick MoSi devices are in a good agreement with predictions in the frame of a kinetic-equation approach.

preprint2020arXiv

Superconducting Nanowire Fabrication on Niobium Nitride using Helium Ion Irradiation

Superconducting devices are prone to reduced performance caused by impurities and defects along the edges of their wires, which can lead to local current crowding. In this study, we explored the use of helium ion irradiation to modify the lattice structure of the superconducting material to change its intrinsic properties. The process will allow us to directly pattern devices and potentially improve the quality of the nanowires. To achieve this, we used the ion beam from a scanning helium ion microscope (HIM) to localize damage on a superconducting material to create a nanowire. Two experiments were performed in this study. First, a range of helium ion doses was exposed on a niobium nitride (NbN) microwire to determine the estimated dose density to suppress superconductivity. Using the results of this first experiment, nanowires were patterned onto a microwire, and the current-voltage characteristics were measured for each sample. Our results showed that helium ion irradiation is an effective resistless fabrication method for superconducting nanowires.

preprint2016arXiv

Superconducting nanowire detector jitters limited by detector geometry

Detection jitter quantifies variance introduced by the detector in the determination of photon arrival time. It is a crucial performance parameter for systems using superconducting nanowire single photon detectors (SNSPDs). In this work, we have demonstrated that the detection timing jitter is limited in part by the spatial variation of photon detection events along the length of the wire. This distribution causes the generated electrical pulses to arrive at the readout at varied times. We define this jitter source as geometric jitter since it is related to the length and area of the SNSPD. To characterize the geometric jitter, we have constructed a novel differential cryogenic readout with less than 7 ps of electronic jitter that can amplify the pulses generated from the two ends of an SNSPD. By differencing the measured arrival times of the two electrical pulses, we were able to partially cancel out the difference of the propagation times and thus reduce the uncertainty of the photon arrival time. Our experimental data indicates that the variation of the differential propagation time was a few ps for a 3 μm x 3 μm device while it increased up to 50 ps for a 20 μm x 20 μm device. In a 20 μm x 20 μm large SNSPD, we achieved a 20% reduction in the overall detection timing jitter for detecting telecom-wavelength photons by using the differential cryogenic readout. The geometric jitter hypothesis was further confirmed by studying jitter in devices that consisted of long wires with 1-μm-long narrowed regions used for sensing photons.

preprint2014arXiv

Eight-fold signal amplification of a superconducting nanowire single-photon detector using a multiple-avalanche architecture

Superconducting nanowire avalanche single-photon detectors (SNAPs) with n parallel nanowires are advantageous over single-nanowire detectors because their output signal amplitude scales linearly with n. However, the SNAP architecture has not been viably demonstrated for n > 4. To increase n for larger signal amplification, we designed a multi-stage, successive-avalanche architecture which used nanowires, connected via choke inductors in a binary-tree layout. We demonstrated an avalanche detector with n = 8 parallel nanowires and achieved eight-fold signal amplification, with a timing jitter of 54 ps.

preprint2014arXiv

On-Chip Detection of Entangled Photons by Scalable Integration of Single-Photon Detectors

Photonic integrated circuits (PICs) have emerged as a scalable platform for complex quantum technologies using photonic and atomic systems. A central goal has been to integrate photon-resolving detectors to reduce optical losses, latency, and wiring complexity associated with off-chip detectors. Superconducting nanowire single-photon detectors (SNSPDs) are particularly attractive because of high detection efficiency, sub-50-ps timing jitter, nanosecond-scale reset time, and sensitivity from the visible to the mid-infrared spectrum. However, while single SNSPDs have been incorporated into individual waveguides, the system efficiency of multiple SNSPDs in one photonic circuit has been limited below 0.2% due to low device yield. Here we introduce a micrometer-scale flip-chip process that enables scalable integration of SNSPDs on a range of PICs. Ten low-jitter detectors were integrated on one PIC with 100% device yield. With an average system efficiency beyond 10% for multiple SNSPDs on one PIC, we demonstrate high-fidelity on-chip photon correlation measurements of non-classical light.