Source author record

Xing

Xing appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

10works
3topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

10 published item(s)

preprint2020arXiv

Intra- and Inter-Conduction Band Optical Absorption Processes in $β$-Ga$_2$O$_3$

$β$-Ga$_2$O$_3$ is an ultra-wide bandgap semiconductor and is thus expected to be optically transparent to light of sub-bandgap wavelengths well into the ultraviolet. Contrary to this expectation, it is found here that free electrons in n-doped $β$-Ga$_2$O$_3$ absorb light from the IR to the UV wavelength range via intra- and inter-conduction band optical transitions. Intra-conduction band absorption occurs via an indirect optical phonon mediated process with a $1/ω^{3}$ dependence in the visible to near-IR wavelength range. This frequency dependence markedly differs from the $1/ω^{2}$ dependence predicted by the Drude model of free-carrier absorption. The inter-conduction band absorption between the lowest conduction band and a higher conduction band occurs via a direct optical process at $λ\sim 349$ nm (3.55 eV). Steady state and ultrafast optical spectroscopy measurements unambiguously identify both these absorption processes and enable quantitative measurements of the inter-conduction band energy, and the frequency dependence of absorption. Whereas the intra-conduction band absorption does not depend on light polarization, inter-conduction band absorption is found to be strongly polarization dependent. The experimental observations, in excellent agreement with recent theoretical predictions for $β$-Ga$_2$O$_3$, provide important limits of sub-bandgap transparency for optoelectronics in the deep-UV to visible wavelength range, and are also of importance for high electric field transport effects in this emerging semiconductor.

preprint2016arXiv

Intrinsic Electron Mobility Limits in beta-Ga2O3

By systematically comparing experimental and theoretical transport properties, we identify the polar optical phonon scattering as the dominant mechanism limiting electron mobility in beta-Ga2O3 to lower than 200 cm2/Vs at 300 K for donor doping densities lower than 1018 cm-3. In spite of similar electron effective mass of beta-Ga2O3 to GaN, the electron mobility is 10x lower because of a massive Frohlich interaction, due to the low phonon energies stemming from the crystal structure and strong bond ionicity. Based on the theoretical and experimental analysis, we provide an empirical expression for electron mobility in beta-Ga2O3 that should help calibrate its potential in high performance device design and applications.

preprint2014arXiv

Synthesized multiwall MoS2 nanotube and nanoribbon field-effect transistors

We report on the fabrication and characterization of synthesized multiwall MoS2 nanotube (NT) and nanoribbon (NR) field-effect transistors (FETs). The MoS2 NTs and NRs were grown by chemical transport, using iodine as a transport agent. Raman spectroscopy confirms the material as unambiguously MoS2 in NT, NR, and flake forms. Transmission electron microscopy was used to observe cross sections of the devices after electrical measurements and these were used in the interpretation of the electrical measurements allowing estimation of the current density. The NT and NR FETs demonstrate n-type behavior, with ON/OFF current ratios exceeding 10^3, and with current densities of 1.02 μA/μm, and 0.79 μA/μm at VDS = 0.3 V and VBG = 1 V, respectively. Photocurrent measurements conducted on a MoS2 NT FET, revealed short-circuit photocurrent of tens of nanoamps under an excitation optical power of 78 μW and 488 nm wavelength, which corresponds to a responsivity of 460 μA/W. A long channel transistor model was used to model the common-source characteristics of MoS2 NT and NR FETs and was shown to be consistent with the measured data.

preprint2013arXiv

A Surface-Potential Based Compact Model for GaN HEMTs Directly Incorporating Polarization Charges

A method to incorporate polarization charges at heterojunctions in compact models for transistors is presented. By including the polarization sheet charge as a Dirac delta function, the Poisson equation is solved to yield a closed equation for the surface potential. A compact model for transistors based on the surface potential incorporating polarization charges describes the on-state as well as the off-state regimes of device operation. The new method of incorporating polarization charges in compact models helps make a direct connection to the material properties of the transistor. The current-voltage (I-V) curves generated by this model are in good agreement with the experimental data for GaN HEMTs.

preprint2013arXiv

Comparative Study of Chemically Synthesized and Exfoliated Multilayer MoS2 Field-Effect Transistors

We report the realization of field-effect transistors (FETs) made with chemically synthesized multilayer 2D crystal semiconductor MoS2. Electrical properties such as the FET mobility, subthreshold swing, on/off ratio, and contact resistance of chemically synthesized (s-) MoS2 are indistinguishable from that of mechanically exfoliated (x-) MoS2, however flat-band voltages are different, possibly due to polar chemical residues originating in the transfer process. Electron diffraction studies and Raman spectroscopy show the structural similarity of s-MoS2 to x-MoS2. This initial report on the behavior and properties of s-MoS2 illustrates the feasibility of electronic devices using synthetic layered 2D crystal semiconductors.

preprint2013arXiv

Graphene Nanoribbon Field-Effect Transistors on Wafer-Scale Epitaxial Graphene on SiC substrates

We report the realization of top-gated graphene nanoribbon field effect transistors (GNRFETs) of ~10 nm width on large-area epitaxial graphene exhibiting the opening of a band gap of ~0.14 eV. Contrary to prior observations of disordered transport and severe edge-roughness effects of GNRs, the experimental results presented here clearly show that the transport mechanism in carefully fabricated GNRFETs is conventional band-transport at room temperature, and inter-band tunneling at low temperature. The entire space of temperature, size, and geometry dependent transport properties and electrostatics of the GNRFETs are explained by a conventional thermionic emission and tunneling current model. Our combined experimental and modeling work proves that carefully fabricated narrow GNRs behave as conventional semiconductors, and remain potential candidates for electronic switching devices.

preprint2013arXiv

High-Voltage Field Effect Transistors with Wide-Bandgap β-Ga2O3 Nanomembranes

Nanoscale semiconductor materials have been extensively investigated as the channel materials of transistors for energy-efficient low-power logic switches to enable scaling to smaller dimensions. On the opposite end of transistor applications is power electronics for which transistors capable of switching very high voltages are necessary. Miniaturization of energy-efficient power switches can enable the integration with various electronic systems and lead to substantial boosts in energy efficiency. Nanotechnology is yet to have an impact in this arena. In this work, it is demonstrated that nanomembranes of the wide-bandgap semiconductor gallium oxide can be used as channels of transistors capable of switching high voltages, and at the same time can be integrated on any platform. The findings mark a step towards using lessons learnt in nanomaterials and nanotechnology to address a challenge that yet remains untouched by the field.

preprint2012arXiv

Transistors with Chemically Synthesized Layered Semiconductor WS2 Exhibiting 105 Room Temperature Modulation and Ambipolar Behavior

We report the realization of field-effect transistors (FETs) made with chemically- synthesized layered two dimensional (2D) crystal semiconductor WS2. The 2D Schottky-barrier FETs demonstrate ambipolar behavior and a high (~105x) on/off current ratio at room temperature with current saturation. The behavior is attributed to the presence of an energy bandgap in the 2D crystal material. The FETs show clear photo response to visible light. The promising electronic and optical characteristics of the devices combined with the layered 2D crystal flexibility make WS2 attractive for future electronic and optical devices.

preprint2012arXiv

Transport Properties of Graphene Nanoribbon Transistors on Transport Properties of Graphene Nanoribbon Transistors on Chemical-Vapor-Deposition Grown Wafer-Scale Graphene

Graphene nanoribbon (GNR) field-effect transistors (FETs) with widths down to 12 nm have been fabricated by electron beam lithography using a wafer-scale chemical vapor deposition (CVD) process to form the graphene. The GNR FETs show drain-current modulation of approximately 10 at 300 K, increasing to nearly 106 at 4 K. The strong temperature dependence of the minimum current indicates the opening of a bandgap for CVD-grown GNR-FETs. The extracted bandgap is estimated to be around 0.1 eV by differential conductance methods. This work highlights the development of CVD-grown large-area graphene and demonstrates the opening of a bandgap in nanoribbon transistors.

preprint2011arXiv

Unique prospects of graphene-based THz modulators

The modulation depth of 2-D electron gas (2DEG) based THz modulators using AlGaAs/GaAs heterostructures with metal gates is inherently limited to < 30%. The metal gate not only attenuates the THz signal (> 90%) but also severely degrades the modulation depth. The metal losses can be significantly reduced with an alternative material with tunable conductivity. Graphene presents a unique solution to this problem due to its symmetric band structure and extraordinarily high mobility of holes that is comparable to electron mobility in conventional semiconductors. The hole conductivity in graphene can be electrostatically tuned in the graphene-2DEG parallel capacitor configuration, thus more efficiently tuning the THz transmission. In this work, we show that it is possible to achieve a modulation depth of > 90% while simultaneously minimizing signal attenuation to < 5% by tuning the Fermi level at the Dirac point in graphene.