Source author record

Vidvuds Ozolins

Explore this author’s publications, collaborators and research topics. This catalog record has not been claimed by its author.

ResearcherUnclaimed source record

Catalog footprint

Research overview

10works
7topics
4close collaborators

Published work

10 publications

preprint2020arXiv

High Thermoelectric Performance and Defect Energetics of Multi-pocketed Full-Heusler Compounds

We report first-principles density-functional study of electron-phonon interactions and thermoelectric transport properties of full-Heusler compounds Sr2_{2}BiAu and Sr2_{2}SbAu. Our results show that ultrahigh intrinsic bulk thermoelectric performance across a wide range of temperatures is physically possible and point to the presence of multiply degenerate and highly dispersive carrier pockets as the key factor for achieving it. Sr2_{2}BiAu, which features ten energy-aligned low effective mass pockets (six along Γ−XΓ-X and four at LL), is predicted to deliver nn-type zT=0.4−4.9zT=0.4-4.9 at T=100−700T=100-700~K. Comparison with the previously investigated Ba2_{2}BiAu compound shows that the additional LL-pockets in Sr2_{2}BiAu significantly increase its low-temperature power factor to a maximum value of 1212~mW~m−1^{-1}~K−2^{-2} near T=300T=300~K. However, at high temperatures the power factor of Sr2_{2}BiAu drops below that of Ba2_{2}BiAu because the LL states are heavier and subject to strong scattering by phonon deformation as opposed to the lighter Γ−XΓ-X states that are limited by polar-optical scattering. Sr2_{2}SbAu is predicted to deliver lower nn-type of zT=3.4zT=3.4 at T=750T=750~K due to appreciable misalignment between the LL and Γ−XΓ-X carrier pockets, generally heavier scattering, and slightly higher lattice thermal conductivity. Soft acoustic modes, responsible for low lattice thermal conductivity, also increase vibrational entropies and high-temperature stability of the Heusler compounds, suggesting that their experimental synthesis may be feasible. The dominant intrinsic defects are found to be Au vacancies, which drive the Fermi level towards the conduction band and work in favor of nn-doping.

preprint2020arXiv

Microscopic Mechanisms of Glass-Like Lattice Thermal Transport in Cubic Cu12_{12}Sb4_{4}S13_{13} Tetrahedrites

Materials based on cubic tetrahedrites (Cu12_{12}Sb4_{4}S13_{13}) are useful thermoelectrics with unusual thermal and electrical transport properties, such as very low and nearly temperature-independent lattice thermal conductivity (κLκ_{L}). We explain the microscopic origin of the glass-like κLκ_{L} in Cu12_{12}Sb4_{4}S13_{13} by explicitly treating anharmonicity up to quartic terms for both phonon energies and phonon scattering rates. We show that the strongly unstable phonon modes associated with trigonally coordinated Cu atoms are anharmonically stabilized above approximately 100100 K and continue hardening with increasing temperature, in accord with experimental data. This temperature induced hardening effect reduces scattering of heat carrying acoustic modes by reducing the available phase space for three-phonon processes, thereby balancing the conventional ∝T\propto T increase in scattering due to phonon population and yielding nearly temperature-independent κLκ_{L}. Furthermore, we find that very strong phonon broadening lead to a qualitative breakdown of the conventional phonon-gas model and modify the dominant heat transport mechanism from the particle-like phonon wave packet propagation to incoherent tunneling described by off-diagonal terms in the heat-flux operator, which are typically prevailing in glasses and disordered crystals. Our work paves the way to a deeper understanding of glass-like thermal conductivity in complex crystals with strong anharmonicity.

preprint2014arXiv

Compressed Wannier modes found from an L1L_1 regularized energy functional

We propose a method for calculating Wannier functions of periodic solids directly from a modified variational principle for the energy, subject to the requirement that the Wannier functions are orthogonal to all their translations ("shift-orthogonality"). Localization is achieved by adding an L1L_1 regularization term to the energy functional. This approach results in "compressed" Wannier modes with compact support, where one parameter μμ controls the trade-off between the accuracy of the total energy and the size of the support of the Wannier modes. Efficient algorithms for shift-orthogonalization and solution of the variational minimization problem are demonstrated.

preprint2014arXiv

Lattice anharmonicity and thermal conductivity from compressive sensing of first-principles calculations

First-principles prediction of lattice thermal conductivity κLκ_L of strongly anharmonic crystals is a long-standing challenge in solid state physics. Making use of recent advances in information science, we propose a systematic and rigorous approach to this problem, compressive sensing lattice dynamics (CSLD). Compressive sensing is used to select the physically important terms in the lattice dynamics model and determine their values in one shot. Non-intuitively, high accuracy is achieved when the model is trained on first-principles forces in {\it quasi-random\/} atomic configurations. The method is demonstrated for Si, NaCl, and Cu12_{12}Sb4_4S13_{13}, an earth-abundant thermoelectric with strong phonon-phonon interactions that limit the room-temperature κLκ_L to values near the amorphous limit.

preprint2014arXiv

Non-Grotthuss Proton Diffusion Mechanism in Tungsten Oxide Dihydrate from First-Principles Calculations

Fast proton conduction mechanism is of key importance for achieving high performance in fuel cell membranes, batteries, supercapacitors, and electrochromic materials. Enhanced proton diffusion is often observed in hydrated materials where it is thought to occur via the famous Grotthuss mechanism through pathways formed by structural water. Using first-principles density-functional theory calculations, we demonstrate that proton diffusion in tungsten oxide dihydrate (WO3_{3}.2H2_{2}O), a known good proton conductor, takes place within the layers of corner-sharing WO6_{6} octahedra without direct involvement of structural water. The calculated proton migration barrier in WO3_{3}.2H2_{2}O (0.42 eV) is in good agreement with the experimental value inferred from the temperature dependence of conductivity (0.36 eV). The preferred proton diffusion path in WO3_{3}.2H2_{2}O is essentially the same as in γγ-WO3_{3}, and we find an activation energy of 0.35 eV for the latter, which agrees well with the experimental values. In contrast to the small intercalation voltages calculated for WO3_{3} and WO3_{3}.2H2_{2}O, we find that proton absorption in the monohydrate WO3_{3}.H2_{2}O is energetically highly favorable, corresponding to voltages in excess of 1 eV in the dilute limit. However, strong proton-proton repulsion limits the equilibrium H content at zero voltage. We find a fast one-dimensional diffusion channel in WO3_{3}.H2_{2}O with an activation energy of only 0.07 eV at dilute proton concentrations, but much higher barriers are expected at near-equilibrium concentrations due to strong repulsive interactions with other protons. Our results illustrate that low proton diffusion barriers and low insertion voltages both contribute to fast proton transport in bulk WO3_{3}.2H2_{2}O and γγ-WO3_{3}.

preprint2014arXiv

Projection to the Set of Shift Orthogonal Functions

This paper presents a fast algorithm for projecting a given function to the set of shift orthogonal functions (i.e. set containing functions with unit L2L^2 norm that are orthogonal to their prescribed shifts). The algorithm can be parallelized easily and its computational complexity is bounded by O(Mlog⁡(M))O(M\log(M)), where MM is the number of coefficients used for storing the input. To derive the algorithm, a particular class of basis called Shift Orthogonal Basis Functions are introduced and some theory regarding them is developed.

preprint2013arXiv

Cluster expansion made easy with Bayesian compressive sensing

Long-standing challenges in cluster expansion (CE) construction include choosing how to truncate the expansion and which crystal structures to use for training. Compressive sensing (CS), which is emerging as a powerful tool for model construction in physics, provides a mathematically rigorous framework for addressing these challenges. A recently-developed Bayesian implementation of CS (BCS) provides a parameterless framework, a vast speed up over current CE construction techniques, and error estimates on model coefficients. Here, we demonstrate the use of BCS to build cluster expansion models for several binary alloy systems. The speed of the method and the accuracy of the resulting fits are shown to be far superior than state-of-the-art evolutionary methods for all alloy systems shown. When combined with high throughput first-principles frameworks, the implications of BCS are that hundreds of lattice models can be automatically constructed, paving the way to high throughput thermodynamic modeling of alloys.

preprint2012arXiv

Compressive sensing as a new paradigm for model building

The widely-accepted intuition that the important properties of solids are determined by a few key variables underpins many methods in physics. Though this reductionist paradigm is applicable in many physical problems, its utility can be limited because the intuition for identifying the key variables often does not exist or is difficult to develop. Machine learning algorithms (genetic programming, neural networks, Bayesian methods, etc.) attempt to eliminate the a priori need for such intuition but often do so with increased computational burden and human time. A recently-developed technique in the field of signal processing, compressive sensing (CS), provides a simple, general, and efficient way of finding the key descriptive variables. CS is a new paradigm for model building-we show that its models are just as robust as those built by current state-of-the-art approaches, but can be constructed at a fraction of the computational cost and user effort.

preprint2012arXiv

Self-consistent density functional calculations of the crystal field levels in lanthanide and actinide dioxides

Using a recently developed method combining a nonspherical self-interaction corrected LDA+UU scheme and an on-site multi-body Hamiltonian [Phys.\ Rev.\ B 83, 085106 (2011)], we calculate the crystal field parameters and crystal field (CF) excitation levels of ff-element dioxides in the fluorite structure with fnf^{n} electronic configurations, including n=1n=1 (PaO2_{2}, PrO2_{2}), n=2n=2 (UO2_{2}), n=3n=3 (NpO2_{2}), and n=4n=4 (PuO2_{2}). It is shown that good agreement with experimental data (within approximately 10 to 20 meV) can be obtained in all cases. The properties of the multi-electron CF ground states are analyzed.

preprint2009arXiv

Obtaining correct orbital ground states in ff electron systems using a nonspherical self-interaction corrected LDA+UU method

The electronic structure of lanthanide and actinide compounds is often characterized by orbital ordering of localized ff-electrons. Density-functional theory (DFT) studies of such systems using the currently available LDA+UU method are plagued by significant orbital-dependent self-interaction, leading to erroneous orbital ground states. An alternative scheme that modifies the exchange, not Hartree, energy is proposed as a remedy. We show that our LDA+UU approach reproduces the expected degeneracy of f1f^1 and f2f^2 states in free ions and the correct ground states in solid PrO2_2. We expect our method to be useful in studying compounds of ff- and heavy-dd elements.

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.