BZPEER
More

Discover

About BZPEERSearchGraph

Research tools

HomeCollectionsResearchCollaborationPublish

Network

ExpertsCommunities

Opportunities

Listings

Account

Log inCreate account
Log inCreate account

Source author record

Sebastian Lukas

Explore this author’s publications, collaborators and research topics. This catalog record has not been claimed by its author.

ResearcherUnclaimed source record
cond-mat.mes-hallcond-mat.mtrl-sciphysics.app-phphysics.optics

Catalog footprint

Research overview

4works
4topics
4close collaborators

Actions

Is this your work?

Log in to claim
Open graphBrowse papers

Published work

4 publications

preprint2022arXiv

Stacking polymorphism in PtSe2_2 drastically affects its electromechanical properties

PtSe2_2 is one of the most promising materials for the next generation of piezoresistive sensors. However, the large-scale synthesis of homogeneous thin films with reproducible electromechanical properties is challenging due to polycrystallinity. We show that stacking phases other than the AA-stacking in the 1T phase become thermodynamically available at elevated temperatures. We show that these can make up a significant fraction in a polycrystalline thin film and discuss methods to characterize these stacking phases. Lastly, we estimate their gauge factors, which vary strongly and significantly impact the performance of a nanoelectromechanical device.

Open access
preprint2022arXiv

Two-dimensional Platinum Diselenide Waveguide-Integrated Infrared Photodetectors

Low cost, easily integrable photodetectors (PDs) for silicon (Si) photonics are still a bottleneck for photonic integrated circuits (PICs), especially for wavelengths above 1.8 μμm. Multilayered platinum diselenide (PtSe2_2) is a semi-metallic two-dimensional (2D) material that can be synthesized below 450°°C. We integrate PtSe2_2 based PDs directly by conformal growth on Si waveguides. The PDs operate at 1550 nm wavelength with a maximum responsivity of 11 mA/W and response times below 8.4 μμs. Fourier transform infrared spectroscopy (FTIR) in the wavelength range from 1.25 μμm to 28 μμm indicates the suitability of PtSe2_2 for PDs far into the infrared wavelength range. Our PtSe2_2 PDs integrated by direct growth outperform PtSe2_2 PDs manufactured by standard 2D layer transfer. The combination of IR responsivity, chemical stability, selective and conformal growth at low temperatures, and the potential for high carrier mobility, make PtSe2_2 an attractive 2D material for optoelectronics and PICs.

Open access
preprint2020arXiv

Nanoelectromechanical Sensors based on Suspended 2D Materials

The unique properties and atomic thickness of two-dimensional (2D) materials enable smaller and better nanoelectromechanical sensors with novel functionalities. During the last decade, many studies have successfully shown the feasibility of using suspended membranes of 2D materials in pressure sensors, microphones, accelerometers, and mass and gas sensors. In this review, we explain the different sensing concepts and give an overview of the relevant material properties, fabrication routes, and device operation principles. Finally, we discuss sensor readout and integration methods and provide comparisons against the state of the art to show both the challenges and promises of 2D material-based nanoelectromechanical sensing.

Open access
preprint2019arXiv

Gate-tunable graphene-based Hall sensors on flexible substrates with increased sensitivity

We demonstrate a novel concept for operating graphene-based Hall sensors using an alternating current (AC) modulated gate voltage, which provides three important advantages compared to Hall sensors under static operation: 1) The sensor sensitivity can be doubled by utilizing both n- and p-type conductance. 2) A static magnetic field can be read out at frequencies in the kHz range, where the 1/f noise is lower compared to the static case. 3) The off-set voltage in the Hall signal can be reduced. This significantly increases the signal-to-noise ratio compared to Hall sensors without a gate electrode. A minimal detectable magnetic field Bmin down to 290 nT/sqrt(Hz) and sensitivity up to 0.55 V/VT was found for Hall sensors fabricated on flexible foil. This clearly outperforms state-of-the-art flexible Hall sensors and is comparable to the values obtained by the best rigid III/V semiconductor Hall sensors.

Open access

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.