Source author record

S. Polosatkin

S. Polosatkin appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

4works
5topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

4 published item(s)

preprint2014arXiv

Measurement of the ionization yield of nuclear recoils in liquid argon at 80 and 233 keV

The energy calibration of nuclear recoil detectors is of primary importance to rare-event experiments such as those of direct dark matter search and coherent neutrino-nucleus scattering. In particular, such a calibration is performed by measuring the ionization yield of nuclear recoils in liquid Ar and Xe detection media, using neutron elastic scattering off nuclei. In the present work, the ionization yield for nuclear recoils in liquid Ar has for the first time been measured in the higher energy range, at 80 and 233 keV, using a two-phase Cryogenic Avalanche Detector (CRAD) and DD neutron generator. The ionization yield in liquid Ar at an electric field of 2.3 kV/cm amounted to 7.8+/-1.1 and 9.7+/-1.3 e-/keV at 80 and 233 keV respectively. The Jaffe model for nuclear recoil-induced ionization, in contrast to that Thomas-Imel, can probably consistently describe the energy dependence of the ionization yield.

preprint2013arXiv

Study of Sublevel Population Mixing Effects in Hydrogen Neutral Beams

Intensities of hydrogen Balmer-series lines are sensitive to distribution of populations of sublevels of excited state due to difference of radiative decay branching ratio for sublevels with different orbital quantum number. Since these sublevels are degenerate transitions between sublevels and mixing of its population may be caused by very weak action of environment. A beam of fast hydrogen atoms is a system in which these fine effects of population mixing can be observed. Experimental data of H-alpha line radiation intensities in hydrogen neutral beams are compared with calculations assumed different models of sublevel population. The comparison most probably point out that population mixing effects cause transitions from long-lived 3s to 3p sublevel with corresponding changes in H-alpha radiation intensities. Discussed effects may influence to results of Doppler-shift spectroscopy measurements of the neutral beam parameters such as species and impurities content and neutralizing efficiency.

preprint2012arXiv

Effect of Sublevel Population Mixing on the Interpretation of Doppler-Shift Spectroscopy Measurements of Neutral Beam Content

Interpretation of Doppler-Shift spectroscopy measurement of neutral beams species content requires an assumption about distribution of populations of thin structure of excited state (hydrogen n=3). In the paper several effects caused mixing of sublevel population are discussed and correction factors for different models of thin structure population are calculated. Such mixing can lead to tens percent uncertainty of results of measurements of beam species content. A possible way for experimental verification of sublevel population mixing is proposed.

preprint2011arXiv

Neutral Particle Analyzer for Studies of Fast Ion Population in Plasma

Advanced neutral particles analyzer for plasma diagnostic with possibility of simultaneous measurements of energy distributions of D and H ions has developed in the Budker Institute of Nuclear Physics. The analyzer was used in two plasma facilities with injection of fast neutrals - on the MST reversed field pinch (University of Wisconsin) and the field reversed configuration C-2 (Tri Alpha Energy). In this paper, the design of the analyzer, calculation of efficiency of registration, results of analyzer calibration and experimental results from MST and C-2 experiments are presented