Researcher profile

R. S. Meena

R. S. Meena contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

Trust snapshot

Quick read

Trust 21 - Emerging
9works
0followers
4topics
4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Research graph

See the researcher in context

Open full explorer

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

9 published item(s)

preprint2019arXiv

Hikami-Larkin-Nagaoka (HLN) Fitting of Magneto Transport of Bi2Se3 Single Crystal in Different Magnetic Field Ranges

We report the detailed study of structural micro-structuraland high magnetic field magneto transport propertiesof Bi2Se3single crystal. Bi2Se3 single crystal is grown through conventional solid-state reaction route via the self-flux method. Rietveld analysis on Powder X-ray Diffraction showed that the studied Bi2Se3 crystal is crystallized in single-phase without any impurity. The surface morphology analyzed through Scanning Electron Microscopy study which shows that as-grown single crystal exhibit layered type structure and the quantitative weight of the atomic constituents (Bi and Se) are found to be closeto the stoichiometric amount in energy-dispersive X-ray spectroscopy analysis. Low temperature (2.5K) magneto-resistance (MR) exhibited a v-type cusp around origin at lower magnetic field, which is the sign of weak anti-localization effect. Further, Bi2Se3 single crystal magneto conductivity data is fitted by well-known HLN equation in different magnetic field range of 2Tesla, 4Tesla and 6Tesla and the resultant found that the conduction mechanism of Bi2Se3 is dominated by WAL state.

preprint2016arXiv

A novel ZnO piezoelectric microcantilever energy scavenger: Fabrication and characterization

This novel piezoelectric zinc oxide (ZnO) thin film microcantilever was fabricated by micromachining technique. To release the cantilever, wet anisotropic etching of Silicon (Si) was performed by tetramethyl ammonium hydroxide (TMAH). The transverse piezoelectric coefficient d31 of the ZnO film, obtained from the deflection of the cantilever with influence of applied voltage, was calculated as 3.32 pC/N. The observed dynamic characterization of the novel piezoelectric microcantilever had linear response with the applied driving voltage. The obtained values of Young Modulus and Hardness were 208 +4 GPa and 4.84+ 0.1 GPa respectively. This inexpensive novel method provides additional design flexibility to fabricate vibrational energy harvesters. The easy steps of fabrication and cost effectiveness of this method may be preferred it over DRIE. The voltage induced due to deformation of ZnO cantilever were measured ~230mV. This microcantilever energy scavenger may be used to power the nano devices and sensors for medical and agricultural applications as a replacement of traditional bulky batteries.

preprint2015arXiv

Investigation of Magnetic Domain Structure in Bi0.7Dy0.3FeO3 thin films integrated with ZnO film

The magnetic domain structure of the multiferroic Bi1-xDyxFeO3 (BDFO) deposited on ZnO at the macroscopic level has been demonstrated in this paper. Magnetic properties are observed by saturated magnetic and ferroelectric hysteresis loops at room temperature. The coupling behaviour and magnetic transition are verified using Multimode Atomic Force Microscope by applying bias between sample and MFM tip. ZnO thin film of 300 nm was deposited by dielectric sputtering using a ZnO target on Si p-type conducting (.0001-0005 Ω cm) substrate. BDFO thin films of 300 nm were deposited on Si/ZnO using PLD (Pulsed laser deposition) technique. It is observed that BDFO thin films integrated with ZnO film shows the coexistence of ferromagnetic and ferroelectric ordering with significant coupling at room temperature. Integration of BDFO films with ZnO piezoelectric thin film shows the potential in MEMS applications as well as in Memory devices and strong history dependent systems.

preprint2015arXiv

Structural, Magnetic and Magneto-caloric studies of Ni50Mn30Sn20Shape Memory Alloy

We have synthesized a nominal composition of Ni50Mn30Sn20 alloy using arc melting technique. Rietveld refinement confirms the austenite L21 structure in Fm-3m space group. Electrical resistivity has been found to clearly exhibiting two different phenomena viz. a magnetic transition from paramagnetic to ferromagnetic and a structural transition from austenite to martensitic phase. Thermo-magnetization measurements M(T) confirms ferromagnetic transition temperature TC at 222 K and martensitic transition starting at 127 K(MS). Magnetization measurement M(H) at 10 K confirms the ferromagnetic state. Frequency dependence of ac susceptibility \c{hi}' at low temperature suggests spin glass behavior in the system. The isothermal magnetic entropy change values have been found to be 1.14 J/Kg.K, 2.69 J/Kg.K and 3.9 J/Kg.K, with refrigeration capacities of 19.6 J/kg, 37.8 J/kg and 54.6 J/kg for the field change of 1, 2 and 3 Tesla respectively at 227 K.

preprint2013arXiv

Magneto-transport and magnetic susceptibility of SmFeAsO1-xFx (x = 0.0 and 0.20)

Bulk polycrystalline samples, SmFeAsO and the iso-structural superconducting SmFeAsO0.80F0.20 are explored through resistivity with temperature under magnetic field ρ(T, H), AC and DC magnetization (M-T), and Specific heat (Cp) measurements. The Resistivity measurement shows superconductivity for x = 0.20 sample with Tc(onset) ~ 51.7K. The upper critical field, [Hc2(0)] is estimated ~3770kOe by Ginzburg-Landau (GL) theory. Broadening of superconducting transition in magneto transport is studied through thermally activated flux flow in applied field up to 130 kOe. The flux flow activation energy (U/kB) is estimated ~1215K for 1kOe field. Magnetic measurements exhibited bulk superconductivity with lower critical field (Hc1) of ~1.2kOe at 2K. In normal state, the paramagnetic nature of compound confirms no trace of magnetic impurity which orders ferromagnetically. AC susceptibility measurements have been carried out for SmFeAsO0.80F0.20 sample at various amplitude and frequencies of applied AC drive field. The inter-granular critical current density (Jc) is estimated. Specific heat [Cp(T)] measurement showed an anomaly at around 140K due to the SDW ordering of Fe, followed by another peak at 5K corresponding to the antiferromagnetic (AFM) ordering of Sm+3 ions in SmFeAsO compound. Interestingly the change in entropy (marked by the Cp transition height) at 5K for Sm+3 AFM ordering is heavily reduced in case of superconducting SmFeAsO0.80F0.20 sample.

preprint2012arXiv

High Field (14Tesla) Magneto Transport of Sm/PrFeAsO

We report high field magneto transport of Sm/PrFeAsO. Below spin density wave transition (TSDW), the magneto-resistance (MR) of Sm/PrFeAsO is positive and increasing with decreasing temperature. The MR of SmFeAsO, is found 16%, whereas the same is 21.5% in case of PrFeAsO, at 2.5 K under applied magnetic field of 14 Tesla (T). In case of SmFeAsO, the variation of isothermal MR with field below 20 K is nonlinear at lower magnetic fields (< 2 Tesla) and the same is linear at moderately higher magnetic fields (H \geq 3.5 T). On the other hand PrFeAsO shows almost linear MR at all temperatures below 20 K. The anomalous behavior of MR being exhibited in PrFeAsO is originated from Dirac cone states. The stronger interplay of Fe and Pr ordered moments is responsible for this distinct behavior. PrFeAsO also shows a hump in resistivity (R-T) with possible conduction band (FeAs) mediated ordering of Pr moments at around 12 K. However the same is absent in SmFeAsO even down to 2 K. Our results of high field magneto-transport of up to 14 Tesla brings about clear distinction between ground states of SmFeAsO and PrFeAsO.

preprint2012arXiv

Physical property characterization of single step synthesized NdFeAsO0.80F0.20 bulk 50K superconductor

We report an easy single step synthesis route of title compound NdFeAsO0.80F0.20 superconductor having bulk superconductivity below 50 K. The title compound is synthesized via solid-state reaction route by encapsulation in an evacuated (10-3 Torr) quartz tube. Rietveld analysis of powder X-ray diffraction data shows that compound crystallized in tetragonal structure with space group P4/nmm. R(T)H measurements showed superconductivity with Tc (R=0) at 48 K and a very high upper critical field (Hc2) of up to 345 Tesla. Magnetic measurements exhibited bulk superconductivity in terms of diamagnetic onset below 50 K. The lower critical field (Hc1) is around 1000 Oe at 5 K. In normal state i.e., above 60 K, the compound exhibited purely paramagnetic behavior and thus ruling out the presence of any ordered FeOx impurity in the matrix. In specific heat measurements a jump is observed in the vicinity of superconducting transition (Tc) along with an upturn at below T=4 K due to the AFM ordering of Nd+3 ions in the system. The Thermo-electric power (TEP) is negative down to Tc, thus indicating dominant carriers to be of n-type in NdFeAsO0.80F0.20 superconductor. The granularity of the bulk superconducting NdFeAsO0.8F0.2 sample is investigated and the intra and inter grain contributions have been individuated by looking at various amplitude and frequencies of the applied AC drive magnetic field.

preprint2012arXiv

Single step synthesis of Sr4V2O6Fe2As2: The blocking layer based potential future superconductor

We report synthesis, structural details and transport measurements on Sr4V2O6Fe2As2. Namely the stoichiometric amounts of V2O5 + SrO2 + Sr + 2FeAs are weighed mixed, ground thoroughly and palletized in rectangular form in a glove box in high purity Ar atmosphere. The pellet is further sealed in an evacuated (10-5 Torr) quartz tube and put for heat treatments at 750 and 1150 0C in a single step for 12 and 36 hours respectively. Finally the quartz ampoule is allowed to cool naturally to room temperature. The as synthesized sample is black in color. The compound crystallized in P4/nmm space group with lattice parameters a = b = 3.925A and c = 15.870A. Also seen are some small impurity lines. The compound did not exhibit superconductivity but instead a spin density wave (SDW) like metallic step at around 175 K is seen in R(T) measurements

preprint2012arXiv

Superconductivity at 14K in the Co-doped SmFe0.9Co0.1AsO

We report superconductivity in the SmFe0.9Co0.1AsO system being prepared by most easy and versatile single step solid-state reaction route. The parent compound SmFeAsO is non-superconducting but shows the spin density wave (SDW) like antiferromagnetic ordering at around 140K. To destroy the antiferromagnetic ordering and to induce the superconductivity in the parent system, the Fe2+ is substituted partially by Co3+. Superconductivity appears in SmFe0.9Co0.1AsO system at around 14K. The Co doping suppresses the SDW anomaly in the parent compound and induces the superconductivity. Magnetization measurements show clearly the onset of superconductivity with Tcdia at 14K. The isothermal magnetization measurements exhibit the lower critical fields (Hc1) to be around 200Oe at 2 K. The bulk superconductivity of the studied SmFe0.9Co0.1AsO sample is further established by open diamagnetic M(H) loops at 2, and 5K. Normal state (above Tc) linear isothermal magnetization M(H) plots excluded presence of any ordered magnetic impurity in the studied compound.