Source author record

Michael A. Scarpulla

Michael A. Scarpulla appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

7works
3topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

7 published item(s)

preprint2021arXiv

In-situ dielectric Al2O3/\b{eta}-Ga2O3 Interfaces Grown Using Metal-organic Chemical Vapor Deposition

High-quality dielectric-semiconductor interfaces are critical for reliable high-performance transistors. We report the in-situ metalorganic chemical vapor deposition (MOCVD) of Al$_2$O$_3$ on $β$-Ga$_2$O$_3$ as a potentially better alternative to the most commonly used atomic layer deposition (ALD). The growth of Al$_2$O$_3$ is performed in the same reactor as Ga$_2$O$_3$ using trimethylaluminum and O$_2$ as precursors without breaking the vacuum at a growth temperature of 600 $^0$C. The fast and slow near interface traps at the Al$_2$O$_3$/ $β$-Ga$_2$O$_3$ interface are identified and quantified using stressed capacitance-voltage (CV) measurements on metal oxide semiconductor capacitor (MOSCAP) structures. The density of shallow and deep level initially filled traps (D$_{it}$) are measured using ultra-violet (UV) assisted CV technique. The average D$_{it}$ for the MOSCAP is determined to be 7.8 $\times$ 10$^{11}$ cm$^{-2}$eV$^{-1}$. The conduction band offset of the Al$_2$O$_3$/ Ga$_2$O$_3$ interface is also determined from CV measurements and found out to be 1.7 eV which is in close agreement with the existing literature reports of ALD Al$_2$O$_3$/ Ga$_2$O$_3$ interface. The current-voltage characteristics are also analyzed and the average breakdown field is extracted to be approximately 5.8 MV/cm. This in-situ Al$_2$O$_3$ dielectric on $β$-Ga$_2$O$_3$ with improved dielectric properties can enable Ga$_2$O$_3$-based high performance devices.

preprint2020arXiv

Defect states and their electric field-enhanced electron thermal emission in heavily Zr-doped beta-Ga2O3 crystals

Performing deep level transient spectroscopy (DLTS) on Schottky diodes, we investigated defect levels below the conduction band minima (Ec) in Czochralski (CZ) grown unintentionally-doped (UID) and vertical gradient freeze (VGF)-grown Zr-doped beta-Ga2O3 crystals. In UID crystals with an electron concentration of 10^17 cm-3, we observe levels at 0.18 eV and 0.46 eV in addition to the previously reported 0.86 (E2) and 1.03 eV (E3) levels. For 10^18 cm-3 Zr-doped Ga2O3, signatures at 0.30 eV (E15) and 0.71 eV (E16) are present. For the highest Zr doping of 5*10^18 cm-3, we observe only one signature at 0.59 eV. Electric field-enhanced emission rates are demonstrated via increasing the reverse bias during measurement. The 0.86 eV signature in the UID sample displays phonon-assisted tunneling enhanced thermal emission and is consistent with the widely reported E2 (FeGa) defect. The 0.71 eV (E16) signature in the lower-Zr-doped crystal also exhibits phonon-assisted tunneling emission enhancement. Taking into account that the high doping in the Zr-doped diodes also increases the electric field, we propose that the 0.59 eV signature in the highest Zr-doped sample likely corresponds to the 0.71 eV signature in lower-doped samples. Our analysis highlights the importance of testing for and reporting on field-enhanced emission especially the electric field present during DLTS and other characterization experiments on beta-Ga2O3 along with the standard emission energy, cross-section, and lambda-corrected trap density. This is important because of the intended use of beta-Ga2O3 in high-field devices and the many orders of magnitude of possible doping.

preprint2020arXiv

Delta-doped \b{eta}-Ga2O3 thin films and \b{eta}-(Al0.26Ga0.74)2O3/\b{eta}-Ga2O3 heterostructures grown by metalorganic vapor-phase epitaxy

We report on silicon delta doping of metalorganic vapor-phase epitaxy-grown \b{eta}-Ga2O3 thin films using silane precursor. Delta-doped \b{eta}-Ga2O3 epitaxial films are characterized using capacitance-voltage profiling and secondary-ion mass spectroscopy. Electron sheet charge density in the range of 2.9e12 cm-2 to 8e12 cm-2 with a half width at half maximum ranging from 6.2 nm to 3.5 nm is measured. We also demonstrate a high density (6.4e12 cm-2) degenerate two-dimensional electron gas using a delta-doped \b{eta}-(Al0.26Ga0.74)2O3/\b{eta}-Ga2O3 heterostructure.The total charge could also include a contribution from a parallel channel in the \b{eta}-(Al0.26Ga0.74)2O3 alloy barrier.

preprint2020arXiv

Growth and Characterization of Metalorganic Vapor-Phase Epitaxy-Grown \b{eta}-(AlxGa1-x)2O3/\b{eta}-Ga2O3 Heterostructure Channels

We report on the growth and characterization of metalorganic vapor-phase epitaxy-grown \b{eta}-(AlxGa1-x)2O3/\b{eta}-Ga2O3 modulation-doped heterostructures. Electron channel is realized in the heterostructure by utilizing a delta-doped \b{eta}-(AlxGa1-x)2O3 barrier. Electron channel characteristics are studied using transfer length method, capacitance-voltage and Hall measurements. Hall sheet charge density of 1.06 x 1013 cm-2 and mobility of 111 cm2/Vs is measured at room temperature. Fabricated transistor showed peak current of 22 mA/mm and on-off ratio of 8 x 106. Sheet resistance of 5.3 kΩ/Square is measured at room temperature, which includes contribution from a parallel channel in \b{eta}-(AlxGa1-x)2O3.

preprint2020arXiv

On the origin of red luminescence from iron-doped beta-Ga2O3 bulk crystals

Currently, Fe doping in the ~10^18 cm-3 range is the most widely-available method for producing semi-insulating single crystalline beta-Ga2O3 substrates. Red luminescence features have been reported from multiple types of Ga2O3 samples including Fe-doped -Ga2O3, and attributed to Fe or N at O. Herein, however, we demonstrate that the high-intensity red luminescence from Fe-doped beta-Ga2O3 commercial substrates consisting of two sharp peaks at 689 nm and 697 nm superimposed on a broader peak centered at 710 nm originates from Cr impurities present at a concentration near 2 ppm. The red emission exhibits two-fold symmetry, peaks in intensity for excitation near absorption edge, seems to compete with Ga2O3 emission at higher excitation energy and appears to be intensified in the presence of Fe. Based on polarized absorption, luminescence observations and Tanabe-Sugano diagram analysis, we propose a resonant energy transfer of photogenerated carriers in beta-Ga2O3 matrix to octahedrally-coordinated Cr3+ to give red luminescence, possibly also sensitized by Fe3+.

preprint2020arXiv

Schottky Barrier Height Engineering In $β$-Ga$_2$O$_3$ Using SiO$_2$ Interlayer Dielectric

This paper reports on the modulation of Schottky barrier heights (SBH) on three different orientations of $β$-Ga$_2$O$_3$ by insertion of an ultra-thin SiO$_2$ dielectric interlayer at the metal-semiconductor junction, which can potentially lower the Fermi-level pinning (FLP) effect due to metal-induced gap states (MIGS). Pt and Ni metal-semiconductor (MS) and metal-interlayer-semiconductor (MIS) Schottky barrier diodes were fabricated on bulk n-type doped $β$-Ga$_2$O$_3$ single crystal substrates along the (010), (-201) and (100) orientations and were characterized by room temperature current-voltage (I-V) and capacitance-voltage (C-V) measurements. Pt MIS diodes exhibited 0.53 eV and 0.37 eV increment in SBH along the (010) and (-201) orientations respectively as compared to their respective MS counterparts. The highest SBH of 1.81 eV was achieved on the (010)-oriented MIS SBD using Pt metal. The MIS SBDs on (100)-oriented substrates exhibited a dramatic increment ($>$1.5$\times$) in SBH as well as reduction in reverse leakage current. The use of thin dielectric interlayers can be an efficient experimental method to modulate SBH of metal/Ga$_2$O$_3$ junctions.

preprint2016arXiv

Suppression of compensating native defect formation during semiconductor processing via excess carriers

In many semiconductors, compensating defects set doping limits, decrease carrier mobility, and reduce minority carrier lifetime thus limiting their utility in devices. Native defects are responsible in many cases, but extrinsic dopants may also act as their own compensation when occupying an alternate lattice site. Suppressing the concentrations of compensating defects during processing close to thermal equilibrium is difficult because formation enthalpies are lowered as the Fermi level moves towards the majority band edge. Excess carriers, introduced for example by photogeneration, modify the formation enthalpy of semiconductor defects and thus can be harnessed during crystal growth or annealing to suppress such defect populations. Herein we develop a rigorous and general model for defect formation in the presence of steady-state excess carrier concentrations by combining the standard quasi-chemical formalism with a detailed-balance description that is applicable for any defect state in the bandgap. Considering the quasi-Fermi levels as chemical potentials, we demonstrate that increasing the minority carrier concentration increases the formation enthalpy for typical compensating centers, thus suppressing their formation. This effect is illustrated for the specific example of native GaSb antisite acceptors in nominally un-doped and extrinsically n-type doped GaSb. The model also predicts reductions in the concentration of ionized scattering centers as well as increased mobility. While our treatment is generalized for excess carrier injection or generation in semiconductors by any means, we provide a set of guidelines for applying the concept in photoassisted physical vapor deposition.