Source author record

Katalin Kamaras

Katalin Kamaras appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

4works
3topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

4 published item(s)

preprint2020arXiv

Polaritonic Enhancement of Near-field Scattering of Small Molecules Encapsulated in Boron Nitride Nanotubes

Near-field spectroscopy has been extensively applied recently to analyze collective optical properties of materials at the nanoscale. However, vibrations of small molecules were only recognizable in close proximity to a metallic resonator. We show that encapsulation in boron nitride nanotubes (BNNT) enhances the near-field vibrational spectra of C$_{60}$ fullerene, reaching a sensitivity limit of a few hundred molecules. Furthermore, products of chemical reactions inside the tubes can be identified, so long as their vibrational signatures lie in the polariton gap of the BNNT.

preprint2014arXiv

Breakdown of diameter selectivity in a reductive hydrogenation reaction of single-walled carbon nanotubes

Reductive hydrogenation was applied to two types of single-walled carbon nanotubes with different diameter range. Alkali metal intercalation, followed by reaction with methanol, led to hydrogenated products. Both yield and selectivity of this reaction showed strong dependence on diameter, contrary to expectation based on simple curvature effects. The observed yield, as detected by thermogravimetry-mass spectroscopy and 1H-NMR, is drastically reduced in small-diameter tubes where the alkali dopant does not reach the inside of the bundles. Wide range optical transmission measurements were employed to determine the selectivity and indicate that besides higher yield, lower diameter selectivity occurs above a critical diameter.

preprint2013arXiv

Mott localization in the correlated superconductor Cs3C60 resulting from the molecular Jahn-Teller effect

Cs3C60 is a correlated superconductor under pressure, but an insulator under ambient conditions. The mechanism causing this insulating behavior is the combination of Mott localization and the dynamic Jahn-Teller effect. We show evidence from infrared spectroscopy for the dynamic Jahn-Teller distortion. The continuous change with temperature of the splitting of infrared lines is typical Jahn-Teller behavior, reflecting the change in population of solid-state conformers. We conclude that the electronic and magnetic solid-state properties of the insulating state are controlled by molecular phenomena. We estimate the time scale of the dynamic Jahn-Teller effect to be above 10^(-11) s and the energy difference between the conformers less than 20 cm-1.

preprint2010arXiv

A general figure of merit for thick and thin transparent conductive carbon nanotube coatings

We suggest a wavelength-dependent figure of merit for transparent conducting nanotube networks, composed of the sheet resistance and the optical density. We argue that this would be more useful than other suggestions prevailing in the literature, because it relies on more realistic assumptions regarding the optical parameters of real nanotubes: it takes into account the fact that the dc resistivity depends on the concentration of free carriers, while the visible absorption is caused by bound carriers. Based on sheet resistance measurements and wide-range transmission spectra, we compare several commercial nanotube types and find correlation between metal enrichment and figure of merit. A simple graphical approach is suggested to determine if the required optical and transport properties can be achieved by varying the thickness of the nanotube layer or a more aggressive treatment is needed. The procedure can be extended to oxide coatings as well.