Source author record

K. Lopez

K. Lopez appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

2works
3topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

2 published item(s)

preprint2012arXiv

Intrinsic spin noise in MgO magnetic tunnel junctions

We consider two intrinsic sources of noise in ultra-sensitive magnetic field sensors based on MgO magnetic tunnel junctions, coming both from $^{25}$Mg nuclear spins ($I=5/2$, 10% natural abundance), and S=1 Mg-vacancies. While nuclear spins induce noise peaked in the MHz frequency range, the vacancies noise peaks in the GHz range. We find that the nuclear noise in submicron devices has a similar magnitude than the $1/f$ noise, while the vacancy-induced noise dominates in the GHz range. Interestingly, the noise spectrum under a finite magnetic field gradient may provide spatial information about the spins in the MgO layer.

preprint2001arXiv

Upgrade of the Control System of the IFUNAM's Pelletron Accelerator

In 1995 a 9SDH-2 Pelletron from NEC was installed at IFUNAM (Instituto de Fisica, Universidad Nacional Autonoma de Mexico). Two beam lines have been operational since then and two new lines have been built. In order to perform the planned projects in this grown facility, an upgrading of the original manual control system is required. The proposed new control system takes advantage of the existing devices and incorporates the electronics needed for the newer beam lines. The control software from NEC, has been modified to accommodate the larger requirements. It runs on the same dedicated computer but receives commands from a new installed host. Both computers communicate through a local network sharing the accelerator database. The new host computer also handles all parameters related to the new lines. In the future, the old computer will be replaced in order to expand the possibilities of the system and use a friendlier graphical interface. In this work we present the changes made to the control software, the new acquisition and control devices installed and the integration of the old and new systems. Finally, the beam control procedure based on the analysis of the beam profile that is under development is also shown.