Source author record

Joe C. Campbell

Joe C. Campbell appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

physics.optics cond-mat.mtrl-sci physics.app-ph physics.atom-ph physics.comp-ph physics.ins-det

Catalog footprint

What is connected

6works

6topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2022arXiv

Dynamic-quenching of a single-photon avalanche photodetector using an adaptive resistive switch

One of the most common approaches for quenching single-photon avalanche diodes is to use a passive resistor in series with it. A drawback of this approach has been the limited recovery speed of the single-photon avalanche diodes. High resistance is needed to quench the avalanche, leading to slower recharging of the single-photon avalanche diodes depletion capacitor. We address this issue by replacing a fixed quenching resistor with a bias-dependent adaptive resistive switch. Reversible generation of metallic conduction enables switching between low and high resistance states under unipolar bias. As an example, using a Pt/Al2O3/Ag resistor with a commercial silicon single-photon avalanche diodes, we demonstrate avalanche pulse widths as small as ~30 ns, 10x smaller than a passively quenched approach, thus significantly improving the single-photon avalanche diodes frequency response. The experimental results are consistent with a model where the adaptive resistor dynamically changes its resistance during discharging and recharging the single-photon avalanche diodes.

preprint2021arXiv

Biaxial Strain Modulated Valence Band Engineering in III-V Digital Alloys

Some III-V digital alloy avalanche photodiodes exhibit low excess noise. These alloys have low hole ionization coefficients due to presence of small 'minigaps', enhanced effective mass and large separation between light-hole and split-off bands in the valence band. In this letter, an explanation for the formation of the minigaps using a tight binding picture is provided. Furthermore, we demonstrate that decreasing substrate lattice constant can increase the minigap size and mass in the transport direction. This leads to reduced quantum tunneling and phonon scattering of the holes. Finally, we illustrate the band structure modification with substrate lattice constant for other III-V digital alloys.

preprint2020arXiv

Coherent Optical Clock Down-Conversion for Microwave Frequencies with 10-18 Instability

Optical atomic clocks are poised to redefine the SI second, thanks to stability and accuracy more than one hundred times better than the current microwave atomic clock standard. However, the best optical clocks have not seen their performance transferred to the electronic domain, where radar, navigation, communications, and fundamental research rely on less stable microwave sources. By comparing two independent optical-to-electronic signal generators, we demonstrate a 10 GHz microwave signal with phase that exactly tracks that of the optical clock phase from which it is derived, yielding an absolute fractional frequency instability of 1*10-18 in the electronic domain. Such faithful reproduction of the optical clock phase expands the opportunities for optical clocks both technologically and scientifically for time-dissemination, navigation, and long-baseline interferometric imaging.

preprint2015arXiv

Attosecond Timing in Optical-to-Electrical Conversion

The most frequency-stable sources of electromagnetic radiation are produced optically, and optical frequency combs provide the means for high fidelity frequency transfer across hundreds of terahertz and into the microwave domain. A critical step in this photonic-based synthesis of microwave signals is the optical-to-electrical conversion process. Here we show that attosecond (as) timing stability can be preserved across the opto-electronic interface of a photodiode, despite an intrinsic temporal response that is more than six orders of magnitude slower. The excess timing noise in the photodetection of a periodic train of ultrashort optical pulses behaves as flicker noise (1/f) with amplitude of 4 as/Sqrt(Hz) at 1 Hz offset. The corresponding fractional frequency fluctuations are 1.4x10-17 at 1 second and 5.5x10-20 at 1000 seconds. These results demonstrate that direct photodetection, as part of frequency-comb-based microwave synthesis, can support the timing performance of the best optical frequency standards, and thereby opens the possibility for generating microwave signals with significantly better stability than any existing source.

preprint2013arXiv

Optical amplification and pulse interleaving for low noise photonic microwave generation

We investigate the impact of pulse interleaving and optical amplification on the spectral purity of microwave signals generated by photodetecting the pulsed output of an Er:fiber-based optical frequency comb. It is shown that the microwave phase noise floor can be extremely sensitive to delay length errors in the interleaver, and the contribution of the quantum noise from optical amplification to the phase noise can be reduced ~10 dB for short pulse detection. We exploit optical amplification, in conjunction with high power handling modified uni-traveling carrier photodetectors, to generate a phase noise floor on a 10 GHz carrier of -175 dBc/Hz, the lowest ever demonstrated in the photodetection of a mode-locked fiber laser. At all offset frequencies, the photodetected 10 GHz phase noise performance is comparable to or better than the lowest phase noise results yet demonstrated with stabilized Ti:sapphire frequency combs.

preprint2005arXiv

Shot Noise Suppression in Avalanche Photodiodes

We identify a new shot noise suppression mechanism in a thin (~100 nm) heterostructure avalanche photodiode. In the low-gain regime the shot noise is suppressed due to temporal correlations within amplified current pulses. We demonstrate in a Monte Carlo simulation that the effective excess noise factors can be <1, and reconcile the apparent conflict between theory and experiments. This shot noise suppression mechanism is independent of known mechanisms such as Coulomb interaction, or reflection at heterojunction interfaces.