Researcher profile

Jason Hoffman

Jason Hoffman contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

cond-mat.mtrl-sci cond-mat.mes-hall cond-mat.str-el

Trust snapshot

Quick read

Trust 21 - Emerging

6works

0followers

3topics

4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2022arXiv

Nanoscale Thermal Imaging of VO$_2$ via Poole-Frenkel Conduction

We present a method for nanoscale thermal imaging of insulating thin films using atomic force microscopy (AFM), and we demonstrate its utility on VO$_2$. We sweep the applied voltage $V$ to a conducting AFM tip in contact mode and measure the local current $I$ through the film. By fitting the $IV$ curves to a Poole-Frenkel conduction model at low $V$, we calculate the local temperature with spatial resolution better than 50 nm using only fundamental constants and known film properties. Our thermometry technique enables local temperature measurement of \textit{any} insulating film dominated by the Poole-Frenkel conduction mechanism, and can be extended to insulators that display other conduction mechanisms.

preprint2015arXiv

Spin Seebeck devices using local on-chip heating

A micro-patterned spin Seebeck device is fabricated using an on-chip heater. Current is driven through a Au heater layer electrically isolated from a bilayer consisting of Fe$_3$O$_4$ (insulating ferrimagnet) and a spin detector layer. It is shown that through this method it is possible to measure the longitudinal spin Seebeck effect (SSE) for small area magnetic devices, equivalent to traditional macroscopic SSE experiments. Using a lock-in detection technique it is possible to more sensitively characterize both the SSE and the anomalous Nernst effect (ANE), as well as the inverse spin Hall effect in various spin detector materials. By using the spin detector layer as a thermometer, we can obtain a value for the temperature gradient across the device. These results are well matched to values obtained through electromagnetic/thermal modeling of the device structure and with large area spin Seebeck measurements.

preprint2014arXiv

Unambiguous separation of the inverse spin Hall and anomalous Nernst Effects within a ferromagnetic metal using the spin Seebeck effect

The longitudinal spin Seebeck effect is measured on the ferromagnetic insulator Fe$_3$O$_4$ with the ferromagnetic metal Co$_{0.2}$Fe$_{0.6}$B$_{0.2}$ (CoFeB) as the spin detector. By using a non-magnetic spacer material between the two materials (Ti), it is possible to decouple the two ferromagnetic materials and directly observe pure spin flow from Fe$_3$O$_4$ into CoFeB. It is shown, that in a single ferromagnetic metal the inverse spin Hall effect (ISHE) and anomalous Nernst effect (ANE) can occur simultaneously with opposite polarity. Using this and the large difference in the coercive fields between the two magnets, it is possible to unambiguously separate the contributions of the spin Seebeck effect from the ANE and observe the degree to which each effect contributes to the total response. These experiments show conclusively that the ISHE and ANE in CoFeB are separate phenomena with different origins and can coexist in the same material with opposite response to a thermal gradient.

preprint2013arXiv

Charge transfer and interfacial magnetism in (LaNiO3)n/(LaMnO3)2 superlattices

(LaNiO3)n/(LaMnO3)2 superlattices were grown using ozone-assisted molecular beam epitaxy, where LaNiO3 is a paramagnetic metal and LaMnO3 is an antiferromagnetic insulator. The superlattices exhibit excellent crystallinity and interfacial roughness of less than 1 unit cell. X-ray spectroscopy and dichroism measurements indicate that electrons are transferred from the LaMnO3 to the LaNiO3, inducing magnetism in LaNiO3. Magnetotransport measurements reveal a transition from metallic to insulating behavior as the LaNiO3 layer thickness is reduced from 5 unit cells to 2 unit cells and suggest a modulated magnetic structure within LaNiO3.

preprint2013arXiv

Non-volatile ferroelastic switching of the Verwey transition and resistivity of epitaxial Fe3O4/PMN-PT (011)

A central goal of electronics based on correlated materials or 'Mottronics' is the ability to switch between distinct collective states with a control voltage. Small changes in structure and charge density near a transition can tip the balance between competing phases, leading to dramatic changes in electronic and magnetic properties. In this work, we demonstrate that an electric field induced two-step ferroelastic switching pathway in (011) oriented 0.71Pb(Mg1/3Nb2/3)O3-0.29PbTiO3 (PMN-PT) substrates can be used to tune the Verwey metal-insulator transition in epitaxial Fe3O4 films in a stable and reversible manner. We also observe robust non-volatile resistance switching in Fe3O4 up to room temperature, driven by ferroelastic strain. These results provides a framework for realizing non-volatile and reversible tuning of order parameters coupled to lattice-strain in epitaxial oxide heterostructures over a broad range of temperatures, with potential device applications.

preprint2012arXiv

Angular dependence of the Hall effect of lsmo films

We find that the Hall effect resistivity ($ρ_{xy}$) of thin films of \lsmo\ varies as a function of the angle $θ$ between the applied magnetic field and the film normal as $ρ_{xy}=a\cos θ+ b\cos 3θ$, where $|b|$ increases with increasing temperature and decreases with increasing magnetic field. We find that the angular dependence of the longitudinal resistivity and the magnetization cannot fully explain the surprising term $b$, suggesting it is a manifestation of an intrinsic transport property.