Source author record

J. Alnis

J. Alnis appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

5works
5topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

5 published item(s)

preprint2015arXiv

Observation of positronium annihilation in the 2S state: towards a new measurement of the 1S-2S transition frequency

We report the first observation of the annihilation of positronium from the 2S state. Positronium (Ps) is excited with a two-photon transition from the 1S to the 2S state where its lifetime is increased by a factor of eight compared to the ground state due to the decrease in the overlap of the positron electron wavefunction. The yield of delayed annihilation photons detected as a function of laser frequency is used as a new method of detecting laser-excited Ps in the 2S state. This can be considered the first step towards a new high precision measurement of the 1S-2S Ps line.

preprint2011arXiv

Low phase noise diode laser oscillator for 1S-2S spectroscopy in atomic hydrogen

We report on a low-noise diode laser oscillator at 972 nm actively stabilized to an ultra-stable vibrationally- and thermally compensated reference cavity. To increase the fraction of laser power in the carrier we designed a 20 cm long external cavity diode laser with an intra-cavity electro-optical modulator. The fractional power in the carrier reaches 99.9% which corresponds to a rms phase noise of $ϕ^2_\textrm{rms}=1\,\textrm{mrad}^2$ in 10\,MHz bandwidth. Using this oscillator we recorded 1S-2S spectra in atomic hydrogen and have not observed any significant loss of the excitation efficiency due to phase noise multiplication in the three consecutive 2-photon processes.

preprint2011arXiv

Thermal-noise limited laser stabilization to a crystalline whispering-gallery-mode resonator

We have stabilized an external cavity diode laser to a whispering gallery mode resonator formed by a protrusion of a single-crystal magnesiumdifluoride cylinder. The cylinder's compact dimensions (<1 cm^3) reduce the sensitivity to vibrations and simplify the stabilization of its temperature in a compact setup. In a comparison to an ultrastable laser used for precision metrology we determine a minimum Allan deviation of 20 Hz, corresponding to a relative Allan deviation of 6*10^-14, at an integration time of 100 ms. This level of instability is compatible with the limits imposed by fundamental fluctuations of the material's refractive index at room temperature.

preprint2009arXiv

New Measurement of the 2S Hyperfine Interval in Atomic Hydrogen

An optical measurement of the 2S hyperfine interval in atomic hydrogen using two-photon spectroscopy of the 1S-2S transition gives a value of 177 556 834.3(6.7) Hz. The uncertainty is 2.4 times smaller than achieved by our group in 2003 and more than 4 times smaller than for any independent radio-frequency measurement. The specific combination of the 2S and 1S hyperfine intervals predicted by QED theory $D_{21}=8 f_{\rm HFS}({2S}) - f_{\rm HFS}({1S})=48 953(3)$ Hz is in good agreement with the value of 48 923(54) Hz obtained from this experiment.

preprint2009arXiv

Testing the Stability of the Fine Structure Constant in the Laboratory

In this review we discuss the progress of the past decade in testing for a possible temporal variation of the fine structure constant $α$. Advances in atomic sample preparation, laser spectroscopy and optical frequency measurements led to rapid reduction of measurement uncertainties. Eventually laboratory tests became the most sensitive tool to detect a possible variation of $α$ at the present epoch. We explain the methods and technologies that helped make this possible.