Source author record

Hiroaki Katsuragi

Hiroaki Katsuragi appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.soft physics.geo-ph astro-ph.EP cond-mat.stat-mech nlin.AO physics.ins-det

Catalog footprint

What is connected

10works

6topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2022arXiv

Decompaction-wave propagation in a vibrated fine powder bed

We experimentally study the crack formation and decompaction-wave propagating in a vibrated powder bed consisting of glass beads of 5 μm in diameter. The vibrated powder bed exhibits three distinct phases depending on the vibration conditions: consolidation (CS), static fracture (SF), and dynamic fracture (DF). Particularly, we found an upward wave propagation in the DF regime when the powder bed is strongly vibrated. As a remarkable feature, we found that in fine cohesive powders, the decompaction-wave propagation speed normalized to gravitational speed is independent of the shaking strength. This result implies that the wave propagation speed is governed by the balance between gravity and cohesion effect rather than vibration strength. We also explore the universality of wave propagation phenomenon in coarser and low-density granular powders.

preprint2021arXiv

Undulating compression and multi-stage relaxation in a granular column consisting of dust particles or glass beads

For fundamentally characterizing the effect of hierarchical structure in granular matter, a set of compression-relaxation tests for dust particles and glass beads confined in a cylindrical cell was performed. Typical diameter of both grains is approximately 1~mm. However, dust particles are produced by binding tiny ($\sim 5$~{\textmu}m) glass beads. The granular columns were compressed with a piston until reaching a maximum load force of 20~N with a constant compression rate $v$ ($0.17 \leq v \leq 2000$~{\textmu}m~s$^{-1}$). After that, the piston was stopped and the relaxation process was quantified. From the experimental results, we found that the compression force $F$ nonlinearly increases with the increase of compression stroke $z$ depending on particles. Besides, periodic undulation and sudden force drops were observed on $F(z)$ in dust particles and glass beads, respectively. The relaxation process was characterized by an exponential decay of stress followed by a logarithmic dependence one in both kinds of particles. These experimental findings are the main point in this study. To understand the underlying physics governing the compression mechanics, we assumed empirical forms of $F(z)$; $F\propto z^α$ for dust particles and $F \propto \exp(z/z_G)$ for glass beads ($α=2.4$ and $z_G=70$~{\textmu}m). Then, we found that the growing manners of periodic undulation and force drops were identical to those of mean compression forces, i.e., power law in dust particles and exponential in glass beads. In addition, the undulation amplitude and wavelength decreased as $v$ increased in dust-particles compression. On the basis of experimental results and the difference between dust particles and glass beads, we also discuss the origin of undulation and the physical meaning of granular-compression models used in engineering fields.

preprint2020arXiv

A novel experimental setup for an oblique impact onto an inclined granular layer

We develop an original apparatus of the granular impact experiment by which the incident angle of the solid projectile and inclination angle of the target granular layer can be systematically varied. Whereas most of the natural cratering events occur on inclined surfaces with various incident angles, there have not been any experiments on oblique impacts on an inclined target surface. To perform systematic impact experiments, a novel experimental apparatus has to be developed. Therefore, we build an apparatus for impact experiments where both the incident angle and the inclination angle can be independently varied. The projectile-injection unit accelerates a plastic ball (6~mm in diameter) up to $v_i\simeq 100$~m~s$^{-1}$ impact velocity. The barrel of the injection unit is made with a three-dimensional printer. The impact dynamics is captured by high-speed cameras to directly measure the impact velocity and incident angle. The rebound dynamics of the projectile (restitution coefficient and rebound angle) is also measured. The final crater shapes are measured using a line-laser profiler mounted on the electric stages. By scanning the surface using this system, a three-dimensional crater shape (height map) can be constructed. From the measured result, we can define and measure the characteristic quantities of the crater. The analyzed result on the restitution dynamics is presented as an example of systematic experiments using the developed system.

preprint2020arXiv

Centroid migration on an impacted granular slope due to asymmetric ejecta deposition and landsliding

For a fundamental understanding of terrain relaxation occurring on sloped surfaces of terrestrial bodies, we analyze the crater shape produced by an impact on an inclined granular (dry-sand) layer. Owing to asymmetric ejecta deposition followed by landsliding, the slope of the impacted inclined surface can be relaxed. Using the experimental results of a solid projectile impact on an inclined dry-sand layer, we measure the distance of centroid migration induced by asymmetric cratering. We find that the centroid migration distance $x_\mathrm{mig}$ normalized to the crater minor-axis diameter $D_\mathrm{cy}$ can be expressed as a function of the initial inclination of the target $\tanθ$, the effective friction coefficient $μ$, and two parameters $K$ and $c$ that characterize the asymmetric ejecta deposition and oblique impact effect: $x_\mathrm{mig}/D_\mathrm{cy}=K \tanθ/(1-(\tanθ/μ)^2)+c$, where $K=0.6$, $μ=0.8$, and $c=-0.1$ to $0.3$. This result is consistent with a previous study that considered the effect of asymmetric ejecta deposition. The obtained results provide fundamental information for analyzing the degradation of sloped terrain on planetary surfaces, such as crater-shape degradation due to the accumulation of micro-impacts.

preprint2016arXiv

Timescale of asteroid resurfacing by regolith convection resulting from the impact-induced global seismic shaking

A model for the asteroid resurfacing by regolith convection is built to estimate its timescale. In the model, regolith convection is driven by the impact-induced global seismic shaking. The model consists of three steps: (i) intermittent impact of meteoroids, (ii) impact-induced global vibration (seismic shaking), and (iii) vibration-induced regolith convection. In order to assess the feasibility of the resurfacing process driven by regolith convection, we estimate the resurfacing timescale as a function of the size of a target asteroid. In the estimate, a set of parameter values is assumed on the basis of previous works. However, some of them (e.g., seismic quality factor $Q$, seismic efficiency $η$, and seismic frequency $f$) are very uncertain. Although these parameter values might depend on asteroid size, we employ the standard values to estimate the representative behavior. To clarify the parameter dependences, we develop an approximated scaling form for the resurfacing timescale. According to the estimated result, we find that the regolith-convection-based resurfacing timescale is shorter than the mean collisional lifetime in most of the parameter uncertainty ranges. These parameter ranges are within those reported by previous works for small asteroids. This means that the regolith convection can be a possible mechanism for the asteroid resurfacing process.

preprint2015arXiv

Structural evolution of a granular pack under manual tapping

We experimentally study a two-dimensional (2D) granular pack of photoelastic disks subject to vertical manual tapping. Using bright and dark field images, we employ gradient-based image analysis methods to analyse various structural quantities. These include the packing fraction ($ϕ$), force per disk ($F_d$) and force chain segment length ($l$) as a function of the tapping number ($τ$). The increase in packing fraction with tapping number is found to exponentially approach an asymptotic value. An exponential distribution is observed for both the cumulative numbers of force per disk $F_d$ : $N_{cum}(F_d) = A_F \exp (-\frac{F_d}{F_0})$, and force chain segment length $l$ : $N_{cum}(l) = A_l \exp (-\frac{l}{l_0})$. Whereas the coefficient ${A_F}$ varies with $τ$ for force per disk, the force chain segment length shows no dependence on $τ$. The $τ$ dependence of $F_d$ and $ϕ$ allows us to posit a linear relation between the total force of the granular pack ($F_{tot}^*(τ)$) and $ϕ(τ)$.

preprint2015arXiv

Temporal analysis of acoustic emission from a plunged granular bed

The statistical property of acoustic emission (AE) events from a plunged granular bed is analyzed by means of actual time and natural time analyses. These temporal analysis methods allow us to investigate the details of AE events that follow a power-law distribution. In the actual time analysis, the calm time distribution and the decay of the event-occurrence density after the largest event (i.e., Omori-Utsu law) are measured. Although the former always shows a power-law form, the latter does not always obey a power law. Markovianity of the event-occurrence process is also verified using a scaling law by assuming that both of them exhibit power laws. We find that the effective shear strain rate is a key parameter to classify the emergence rate of power-law nature and Markovianity in the granular AE events. For the natural time analysis, the existence of self organized critical (SOC) states is revealed by calculating the variance of natural time $χ_k$, where $k$th natural time of N events is defined as $χ_k=k/N$. In addition, the energy difference distribution can be fitted by a $q$-Gaussian form, which is also consistent with the criticality of the system.

preprint2014arXiv

Scaling of convective velocity in a vertically vibrated granular bed

We experimentally study the velocity scaling of granular convection which is a possible mechanism of the regolith migration on the surface of small asteroids. In order to evaluate the contribution of granular convection to the regolith migration, the velocity of granular convection under the microgravity condition has to be revealed. Although it is hard to control the gravitational acceleration in laboratory experiments, scaling relations involving the gravitational effect can be evaluated by systematic experiments. Therefore, we perform such a systematic experiment of the vibration-induced granular convection. From the experimental data, a scaling form for the granular convective velocity is obtained. The obtained scaling form implies that the granular convective velocity can be decomposed into two characteristic velocity components: vibrational and gravitational velocities. In addition, the system size dependence is also scaled. According to the scaling form, the granular convective velocity $v$ depends on the gravitational acceleration $g$ as $v \propto g^{0.97}$ when the normalized vibrational acceleration is fixed.

preprint2011arXiv

Length and time scales of a liquid drop impact and penetration into a granular layer

Liquid drop impact and penetration into a granular layer are investigated with diverse liquids and granular materials. We use various size of SiC abrasives and glass beads as a target granular material. We also employ ethanol and glycerol aqueous solutions as well as distilled water to make a liquid drop. The liquid drop impacts the granular layer with a low speed (~ m/s). The drop deformation and penetration are captured by a high speed camera. From the video data, characteristic time scales are measured. Using a laser profilometry system, resultant crater morphology and its characteristic length scales are measured. Static strength of the granular layer is also measured by the slow pillar penetration experiment to quantify the cohesive force effect. We find that the time scales are almost independent of impact speed, but they depend on liquid drop viscosity. Particularly, the penetration time is proportional to the square root of the liquid drop viscosity. Contrastively, the crater radius is independent of the liquid drop viscosity. The crater radius is scaled by the same form as the previous paper, (Katsuragi, Phys. Rev. Lett. vol. 104, 2010, p. 218001).

preprint2005arXiv

Binomial multiplicative model of critical fragmentation

We report the binomial multiplicative model for low impact energy fragmentation. Impact fragmentation experiments were performed for low impact energy region, and it was found that the weighted mean mass is scaled by the pseudo control parameter multiplicity. We revealed that the power of this scaling is a non-integer (fractal) value and has a multi-scaling property. This multi-scaling can be interpreted by a binomial multiplicative (simple biased cascade) model. Although the model cannot explain the power-law of fragment-mass cumulative distribution in fully fragmented states, it can produce the multi-scaling exponents that agree with experimental results well.