Source author record

Gregory Salamo

Explore this author’s publications, collaborators and research topics. This catalog record has not been claimed by its author.

ResearcherUnclaimed source record

Catalog footprint

Research overview

2works
2topics
4close collaborators

Published work

2 publications

preprint2020arXiv

Electrically injected GeSn lasers on Si operating up to 100 K

The significant progress of GeSn material development has enabled a feasible solution to the long-desired monolithically integrated lasers on the Si platform. While there are many reports focused on optically pumped lasers, GeSn lasers through electrical injection have not been experimentally achieved yet. In this work, we report the first demonstration of electrically injected GeSn lasers on Si. A GeSn/SiGeSn heterostructure diode grown on a Si substrate was fabricated into ridge waveguide laser devices and tested under pulsed conditions. Special considerations were given for the structure design to ensure effective carrier confinement and optical confinement that lead to lasing. Lasing was observed at temperatures from 10 to 100 K with emission peaks at around 2300 nm. The minimum threshold of 598 A/cm2 was recorded at 10 K and the threshold increased to 842 A/cm2 at 77 K. The spectral linewidth of a single peak was measured as small as 0.13 nm (0.06 meV). The maximum characteristic temperature was extracted as 99 K over the temperature range of 10-77 K.

preprint2013arXiv

Advanced holographic nondestructive testing system for residual stress analysis

The design and operating of a portable holographic interferometer for residual stress analysis by creating a small scratch along with a new mathematical algorithm of calculations are discussed. Preliminary data of the stress investigations on aluminum and steel alloys have been obtained by the automatic processing of the interference pattern using a notebook computer. A phase-shift compensation technique in real-time reflection interferometry is used to measure the out-of-plane stress release surface displacement surrounding a small scratch (25 um depth and 0.5 mm width) in a plate with residual stress of around 50 MPa. Comparison between theoretical models for a rectangular and triangular shaped scratch with the experimental data are presented.

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.