Source author record

Greg Sun

Greg Sun appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

7works
3topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

7 published item(s)

preprint2020arXiv

Electrically injected GeSn lasers on Si operating up to 100 K

The significant progress of GeSn material development has enabled a feasible solution to the long-desired monolithically integrated lasers on the Si platform. While there are many reports focused on optically pumped lasers, GeSn lasers through electrical injection have not been experimentally achieved yet. In this work, we report the first demonstration of electrically injected GeSn lasers on Si. A GeSn/SiGeSn heterostructure diode grown on a Si substrate was fabricated into ridge waveguide laser devices and tested under pulsed conditions. Special considerations were given for the structure design to ensure effective carrier confinement and optical confinement that lead to lasing. Lasing was observed at temperatures from 10 to 100 K with emission peaks at around 2300 nm. The minimum threshold of 598 A/cm2 was recorded at 10 K and the threshold increased to 842 A/cm2 at 77 K. The spectral linewidth of a single peak was measured as small as 0.13 nm (0.06 meV). The maximum characteristic temperature was extracted as 99 K over the temperature range of 10-77 K.

preprint2020arXiv

Strain effects on Phase-Filling Singularities in Highly Doped n-Type Ge

Recently, Chi Xu et al. predicted the phase-filling singularities (PFS) in the optical dielectric function (ODF) of the highly doped $n$-type Ge and confirmed in experiment the PFS associated $E_{1}+Δ_{1}$ transition by advanced \textit{in situ} doping technology [Phys. Rev. Lett. 118, 267402 (2017)], but the strong overlap between $E_{1}$ and $E_{1}+Δ_{1}$ optical transitions made the PFS associated $E_{1}$ transition that occurs at the high doping concentration unobservable in their measurement. In this work, we investigate the PFS of the highly doped n-type Ge in the presence of the uniaxial and biaxial tensile strain along [100], [110] and [111] crystal orientation. Compared with the relaxed bulk Ge, the tensile strain along [100] increases the energy separation between the $E_{1}$ and $E_{1}+Δ_{1}$ transition, making it possible to reveal the PFS associated $E_{1}$ transition in optical measurement. Besides, the application of tensile strain along [110] and [111] offers the possibility of lowering the required doping concentration for the PFS to be observed, resulting in new additional features associated with $E_{1}+Δ_{1}$ transition at inequivalent $L$-valleys. These theoretical predications with more distinguishable optical transition features in the presence of the uniaxial and biaxial tensile strain can be more conveniently observed in experiment, providing new insights into the excited states in heavily doped semiconductors.

preprint2015arXiv

Impact of surface collisions on enhancement and quenching of the luminescence near the metal nanoparticles

The fact that surface-induced damping rate of surface plasmon polaritons (SPPs) in metal nanoparticles increases with the decrease of particle size is well known. We show that this rate also increases with the degree of the mode confinement, hence damping of the higher order nonradiative SPP modes in spherical particles is greatly enhanced relative to damping of the fundamental (dipole) SPP mode. Since higher order modes are the ones responsible for quenching of luminescence in the vicinity of metal surfaces, the degree of quenching increases resulting in a substantial decrease in the amount of attainable enhancement of the luminescence

preprint2013arXiv

Spasers, VCSELs, and Surface plasmon emitting diodes (SPED): their unique features and figures of merit

We compare fundamental characteristics of proposed electrically pumped subwavelength plasmonic lasers (spasers) with ubiquitous all-dielectric semiconductor micro-lasers (VCSEL) and indicate their close similarities as well as large differences in performance (threshold, efficiency, coherence and speed). These results should assist researchers in making informed choice of the emitter for each particular opto-electronic application.

preprint2012arXiv

Guided plasmon modes of triangular and inverted triangular cross section silver nanoridges

Propagating two-dimensional plasmon modes guided along silver nanoridge waveguides with triangular and inverted triangular cross sections are investigated in this paper. Mode field profiles, dispersion curves, propagation distances, and figure-of-merits of the plasmon ridge modes are calculated for silver nanoridge waveguides with various triangular and inverted triangular waveguide cross sections. It is found that the triangular cross section nanoridge waveguide, if designed properly, can have longer propagation distance and higher figure-of-merit than the flat-top nanoridge waveguide of the same width. When the triangle height of the nanoridge is high, the mode approaches to the small angle wedge mode. An inverted triangular cross section nanoridge mode can be considered as a hybrid mode of two metal wedge plasmon modes. When inverted triangle depth increases, the propagation distance and the figure-of-merit decrease dramatically, suggesting the poorer performance when compared to the flat-top nanoridge plasmon waveguide.

preprint2011arXiv

Mode Properties of Flat-top Silver Nano-ridge Surface Plasmon Waveguides

We investigate surface plasmon modes supported by flat-top silver nano-ridges. We calculate the mode electromagnetic field distribution, the dispersion curve, the travel range, and the figure-of-merit of the nano-ridge mode. We find that the nano-ridge surface plasmon modes are quasi-TEM modes with longitudinal field components three orders of magnitude smaller than the transverse field components. The quasi-TEM nature of mode profiles reveals that the propagation of free electron oscillations on the top of the nano-ridge contributes mainly to the tightly confined ridge mode. We also find that as the width of the nano-ridge decreases, the ridge mode becomes more tightly confined on the ridge top. As the width of the nano-ridge increases, the nano-ridge mode approaches two decoupled right-angle wedge plasmon modes.

preprint2011arXiv

Scaling of losses with size and wavelength in nanoplasmonics and metamaterials

We show that, for the resonant metal-dielectric structures with sub-wavelength confinement of light in all three dimensions, the loss cannot be reduced significantly below the loss of the metal itself unless one operates in the far IR and THz regions of the spectrum or below. Such high losses cannot be compensated by introducing gain due to Purcell-induced shortening of recombination times. The only way low loss optical metamaterials can be engineered is with as yet unknown low loss materials with negative permittivity.