Researcher profile

Georgi Diankov

Georgi Diankov contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

Trust snapshot

Quick read

Trust 19 - Baseline
5works
0followers
3topics
4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Research graph

See the researcher in context

Open full explorer

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

5 published item(s)

preprint2016arXiv

Robust fractional quantum Hall effect and composite fermions in the $N=2$ Landau level in bilayer graphene

The fractional quantum Hall (FQH) effect is a canonical example of electron-electron interactions producing new ground states in many-body systems. Most FQH studies have focused on the lowest Landau level (LL), whose fractional states are successfully explained by the composite fermion (CF) model, in which an even number of magnetic flux quanta are attached to an electron and where states form the sequence of filling factors $ν= p/(2mp \pm 1)$, with $m$ and $p$ positive integers. In the widely-studied GaAs-based system, the CF picture is thought to become unstable for the $N \geq 2$ LL, where larger residual interactions between CFs are predicted and competing many-body phases have been observed. Here we report transport measurements of FQH states in the $N=2$ LL (filling factors $4 < ν< 8$) in bilayer graphene, a system with spin and valley degrees of freedom in all LLs, and an additional orbital degeneracy in the 8-fold degenerate $N=0$/$N=1$ LLs. In contrast with recent observations of particle-hole asymmetry in the $N=0$/$N=1$ LLs of bilayer graphene, the FQH states we observe in the $N=2$ LL are consistent with the CF model: within a LL, they form a complete sequence of particle-hole symmetric states whose relative strength is dependent on their denominators. The FQH states in the $N=2$ LL display energy gaps of a few Kelvin, comparable to and in some cases larger than those of fractional states in the $N=0$/$N=1$ LLs. The FQH states we observe form, to the best of our knowledge, the highest set of particle-hole symmetric pairs seen in any material system.

preprint2016arXiv

Unconventional Correlation between Quantum Hall Transport Quantization and Bulk State Filling in Gated Graphene Devices

We report simultaneous transport and scanning microwave impedance microscopy to examine the correlation between transport quantization and filling of the bulk Landau levels in the quantum Hall regime in gated graphene devices. Surprisingly, a comparison of these measurements reveals that quantized transport typically occurs below the complete filling of bulk Landau levels, when the bulk is still conductive. This result points to a revised understanding of transport quantization when carriers are accumulated by gating. We discuss the implications on transport study of the quantum Hall effect in graphene and related topological states in other two-dimensional electron systems.

preprint2010arXiv

An integrated capacitance bridge for high-resolution, wide temperature range quantum capacitance measurements

We have developed a highly-sensitive integrated capacitance bridge for quantum capacitance measurements. Our bridge, based on a GaAs HEMT amplifier, delivers attofarad (aF) resolution using a small AC excitation at or below kT over a broad temperature range (4K-300K). We have achieved a resolution at room temperature of 10aF per root Hz for a 10mV AC excitation at 17.5 kHz, with improved resolution at cryogenic temperatures, for the same excitation amplitude. We demonstrate the performance of our capacitance bridge by measuring the quantum capacitance of top-gated graphene devices and comparing against results obtained with the highest resolution commercially-available capacitance measurement bridge. Under identical test conditions, our bridge exceeds the resolution of the commercial tool by up to several orders of magnitude.

preprint2010arXiv

Facile Synthesis of High Quality Graphene Nanoribbons

Graphene nanoribbons have attracted attention for their novel electronic and spin transport properties1-6, and because nanoribbons less than 10 nm wide have a band gap that can be used to make field effect transistors. However, producing nanoribbons of very high quality, or in high volumes, remains a challenge. Here, we show that pristine few-layer nanoribbons can be produced by unzipping mildly gas-phase oxidized multiwalled carbon nanotube using mechanical sonication in an organic solvent. The nanoribbons exhibit very high quality, with smooth edges (as seen by high-resolution transmission electron microscopy), low ratios of disorder to graphitic Raman bands, and the highest electrical conductance and mobility reported to date (up to 5e2/h and 1500 cm2/Vs for ribbons 10-20 nm in width). Further, at low temperature, the nanoribbons exhibit phase coherent transport and Fabry-Perot interference, suggesting minimal defects and edge roughness. The yield of nanoribbons was ~2% of the starting raw nanotube soot material, which was significantly higher than previous methods capable of producing high quality narrow nanoribbons1. The relatively high yield synthesis of pristine graphene nanoribbons will make these materials easily accessible for a wide range of fundamental and practical applications.

preprint2010arXiv

Nanocrystal Growth on Graphene with Various Degrees of Oxidation

We show a general two-step method to grow hydroxide and oxide nanocrystals of the iron family elements (Ni, Co, Fe) on graphene with two degrees of oxidation. Drastically different nanocrystal growth behaviors were observed on low-oxidation graphene sheets (GS) and highly oxidized graphite oxide (GO) in hydrothermal reactions. Small particles pre-coated on GS with few oxygen-containing surface groups diffused and recrystallized into single-crystalline nickel hydroxide Ni(OH)2 hexagonal nanoplates or iron oxide Fe2O3 nanorods with well defined morphologies. In contrast, particles pre-coated on GO were pinned by the high-concentration oxygen groups and defects on GO without recrystallization into well-defined shapes. Adjusting reaction temperature can be combined to further control materials grown on graphene. For materials with weak interactions with graphene, increasing the reaction temperature can lead to diffusion and recrystallization of surface species into larger crystals even on highly oxidized and defective GO. Our results suggest an interesting new approach to controlling the morphology of nanomaterials grown on graphene by tuning the surface chemistry of graphene as substrates for crystal nucleation and growth.