Researcher profile

Federico Golmar

Federico Golmar contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

Trust snapshot

Quick read

Trust 15 - Baseline
3works
0followers
3topics
4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Research graph

See the researcher in context

Open full explorer

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

3 published item(s)

preprint2020arXiv

COTS MOS Dosimetry on the MeMOSat Board, Results After 2.5 Years in Orbit

We present the results after 2.5 years in or-bit of Total Ionizing Dose (TID) measurements done using Metal Oxide Semiconductor (MOS) dosimeters on the MeMOSat board. The MeMOSat board was launched on July 19th 2014 at the BugSat-1 "Tita" microsatellite developed by Satellogic to stay at LEO. We used as dosimeters p-channel Commercial Off The Shelf (COTS) MOS transistors with gate oxides of 250~nm. Before launch, a subset of transistors with similar drain current to voltage (I-V)curves where selected from a group of 100 devices. The temperature dependence of the (I-V) curves was studied to find the minimum temperature coefficient biasing point. Then, a calibration subgroup of sensors was irradiated using a $^{60}$Co gamma source to study their response to TID, showing responsivities of $\sim$75~mV/krad when the sensors are irradiated without gate bias. Also, the post irradiation response of the sensors was monitored, in order to include a correction for low dose rate irradiations, yielding 30~mV/krad. A biasing and reading circuit was developed in order to allow the reading of up to 4 sensors.The threshold voltage was monitored during different periods of the mission. After 2.5 years in orbit,the threshold voltage of the sensor mounted on the MeMOSat Board had a V$_\mathrm{T}$ shift of approximately 35~mV corresponds to a dose of 1.2~krads.

preprint2014arXiv

Spin Hall magnetoresistance at Pt/CoFe2O4 interfaces and texture effects

We report magnetoresistance measurements on thin Pt bars grown on epitaxial (001) and (111) CoFe2O4 (CFO) ferrimagnetic insulating films. The results can be described in terms of the recently discovered spin Hall magnetoresistance (SMR). The magnitude of the SMR depends on the interface preparation conditions, being optimal when Pt/CFO samples are prepared in situ, in a single process. The spin-mixing interface conductance, the key parameter governing SMR and other relevant spin-dependent phenomena such as spin pumping or spin Seebeck effect, is found to be different depending on the crystallographic orientation of CFO, highlighting the role of the composition and density of magnetic ions at the interface on spin mixing.

preprint2012arXiv

How reliable are Hanle measurements in metals in a three-terminal geometry?

We test the validity of Hanle measurements in three-terminal devices by using aluminum (Al) and gold (Au). The obtained Hanle and inverted Hanle-like curves show an anomalous behavior. First, we measure Hanle signals 8 orders of magnitude larger than those predicted by standard theory. Second, the temperature and voltage dependences of the signal do not match with the tunneling spin polarization of the ferromagnetic contact. Finally, the spin relaxation times obtained with this method are independent of the choice of the metallic channel. These results are not compatible with spin accumulation in the metal. Furthermore, a scaling of the Hanle signal with the interface resistance of the devices suggests that the measured signal is originated in the tunnel junction.