Source author record

David Perez de Lara

David Perez de Lara appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.mes-hall cond-mat.mtrl-sci physics.app-ph

Catalog footprint

What is connected

4works

3topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2020arXiv

Polarization-sensitive and broadband photodetection based on a mixed-dimensionality TiS3/Si p-n junction

The capability to detect the polarization state of light is crucial in many day-life applications and scientific disciplines. Novel anisotropic two-dimensional materials such as TiS3 combine polarization sensitivity, given by the in-plane optical anisotropy, with excellent electrical properties. Here we demonstrate the fabrication of a monolithic polarization sensitive broadband photodetector based on a mixed-dimensionality TiS3/Si p-n junction. The fabricated devices show broadband responsivity up to 1050 nm, a strong sensitivity to linearly polarized illumination with difference between the two orthogonal polarization states up to 350 % and a good detectivity and fast response time. The discussed devices can be used as building blocks to fabricate more complex polarization sensitive systems such as polarimeters.

preprint2020arXiv

Tunable Photodetectors via in situ Thermal Conversion of TiS$_3$ to TiO$_2$

In two-dimensional materials research, oxidation is usually considered as a common source for the degradation of electronic and optoelectronic devices or even device failure. However, in some cases a controlled oxidation can open the possibility to widely tune the band structure of 2D materials. In particular, we demonstrate the controlled oxidation of titanium trisulfide (TiS$_3$), a layered semiconductor that has attracted much attention recently thanks to its quasi-1D electronic and optoelectronic properties and its direct bandgap of 1.1 eV. Heating TiS$_3$ in air above 300 °C gradually converts it into TiO$_2$, a semiconductor with a wide bandgap of 3.2 eV with ap-plications in photo-electrochemistry and catalysis. In this work, we investigate the controlled thermal oxidation of individual TiS$_3$ nanoribbons and its influence on the optoelectronic properties of TiS$_3$-based photodetectors. We observe a step-wise change in the cut-off wavelength from its pristine value ~1000 nm to 450 nm after subjecting the TiS$_3$ devices to subsequent thermal treatment cycles. Ab-initio and many-body calculations confirm an increase in the bandgap of titanium oxysulfide (TiO$_{2-x}$S$_x$) when increasing the amount of oxygen and reducing the amount of sulfur.

preprint2016arXiv

Highly responsive UV-photodetectors based on single electrospun TiO2 nanofibres

In this work we study the optoelectronic properties of individual TiO2 fibres produced through coupled sol-gel and electrospinning, by depositing them onto pre-patterned Ti/Au electrodes on SiO2/Si substrates. Transport measurements in the dark give a conductivity above 2*10^-5 S, which increases up to 8*10^-5 S in vacuum. Photocurrent measurements under UV-irradiation show high sensitivity (responsivity of 90 A/W for 375 nm wavelength) and a response time to illumination of ~ 5 s, which is superior to state-of-the-art TiO2-based UV photodetectors. Both responsivity and response speed are higher in air than in vacuum, due to oxygen adsorbed on the TiO2 surface which traps photoexcited free electrons in the conduction band, thus reducing the recombination processes. The photodetectors are sensitive to light polarization, with an anisotropy ratio of 12%. These results highlight the interesting combination of large surface area and low 1D transport resistance in electrospun TiO2 fibres. The simplicity of the sol-gel/electrospinning synthesis method, combined with a fast response and high responsivity makes them attractive candidates for UV-photodetection in ambient conditions. We anticipate their high (photo) conductance is also relevant for photocatalysis and dye-sensitized solar cells.

preprint2015arXiv

Enhanced Visibility of MoS2, MoSe2, WSe2 and Black Phosphorus: Making Optical Identification of 2D Semiconductors Easier

We explore the use of Si3N4/Si substrates as a substitute of the standard SiO2/Si substrates employed nowadays to fabricate nanodevices based on 2D materials. We systematically study the visibility of several 2D semiconducting materials that are attracting a great deal of interest in nanoelectronics and optoelectronics: MoS2, MoSe2, WSe2 and black phosphorus. We find that the use of Si3N4/Si substrates provides an increase of the optical contrast up to a 50%-100% and also the maximum contrast shifts towards wavelength values optimal for human eye detection, making optical identification of 2D semiconductors easier.