Source author record

David Berge

David Berge appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

astro-ph.IM astro-ph.HE hep-ex hep-ph physics.ins-det

Catalog footprint

What is connected

7works

5topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2022arXiv

Characterization of a CdZnTe detector for a low-power CubeSat application

We report spectral and imaging performance of a pixelated CdZnTe detector custom designed for the \emph{MeVCube} project: a small Compton telescope on a CubeSat platform. \emph{MeVCube} is expected to cover the energy range between $200\;\mathrm{keV}$ and $4\;\mathrm{MeV}$, with performance comparable to the last generation of larger satellites. In order to achieve this goal, an energy resolution of few percent in full width at half maximum (FWHM) and a $3$-D spatial resolution of few millimeters for the individual detectors are needed. The severe power constraints present in small satellites require very low power read-out electronics for the detector. Our read-out is based on the VATA450.3 ASIC developed by \emph{Ideas}, with a power consumption of only $0.25\;\mathrm{mW/channel}$, which exhibits good performance in terms of dynamic range, noise and linearity. A $2.0\;\mathrm{cm} \times 2.0\;\mathrm{cm} \times 1.5\;\mathrm{cm}$ CdZnTe detector, with a custom $8 \times 8$ pixel anode structure read-out by a VATA450.3 ASIC, has been tested. A preliminary read-out system for the cathode, based on a discrete \emph{Amptek} A250F charge sensitive pre-amplifier and a DRS4 ASIC, has been implemented. An energy resolution around $3\%$ FWHM has been measured at a gamma energy of $662\;\mathrm{keV}$; at $200\;\mathrm{keV}$ the average energy resolution is $6.5\%$, decreasing to $\lesssim 2\%$ at energies above $1\;\mathrm{MeV}$. A $3$-D spatial resolution of $\approx 2\,\mathrm{mm}$ is achieved.

preprint2022arXiv

Introducing the MeVCube concept: a CubeSat for MeV observations

Despite the impressive progress achieved both by X-ray and gamma-ray observatories in the last few decades, the energy range between $\sim200\;\mathrm{keV}$ and $\sim50\;\mathrm{MeV}$ remains poorly explored. COMPTEL, on-board the Compton Gamma-Ray Observatory (CGRO, $1991$-$2000$), opened the MeV gamma-ray band as a new window to astronomy, performing the first all-sky survey in the energy range from $0.75$ to $30\;\mathrm{MeV}$. More than $20$ years after the de-orbit of CGRO, no successor mission is yet operating. Over the past years many concepts have been proposed, for new observatories exploring different configurations and imaging techniques; a selection of the most recent ones includes AMEGO, ETCC, GECCO and COSI. We propose here a novel concept for a Compton telescope based on the CubeSat standard, named MeVCube, with the advantages of small cost and relatively short development time. The scientific payload is based on two layers of pixelated Cadmium-Zinc-Telluride (CdZnTe) detectors, coupled with low-power read-out electronics (ASIC, VATA450.3). The performance of the read-out electronics and CdZnTe custom designed detectors have been measured extensively at DESY. The performance of the telescope is accessed through simulations: despite a small effective area limited to a few $\mathrm{cm}^{2}$, MeVCube can reach an angular resolution of $1.5^{\circ}$ and a sensitivity comparable to the one achieved by the last generation of large-scale satellites like COMPTEL and INTEGRAL. Combined with a large field-of-view and a moderate cost, MeVCube can be a powerful instrument for transient observations and searches of electromagnetic counterparts of gravitational wave events.

preprint2020arXiv

A NECTAr-based upgrade for the Cherenkov cameras of the H.E.S.S. 12-meter telescopes

The High Energy Stereoscopic System (H.E.S.S.) is one of the three arrays of imaging atmospheric Cherenkov telescopes (IACTs) currently in operation. It is composed of four 12-meter telescopes and a 28-meter one, and is sensitive to gamma rays in the energy range ~30 GeV - 100 TeV. The cameras of the 12-m telescopes recently underwent a substantial upgrade, with the goal of improving their performance and robustness. The upgrade involved replacing all camera components except for the photomultiplier tubes (PMTs). This meant developing new hardware for the trigger, readout, power, cooling and mechanical systems, and new software for camera control and data acquisition. Several novel technologies were employed in the cameras: the readout is built around the new NECTAr digitizer chip, developed for the next generation of IACTs; the camera electronics is fully controlled and read out via Ethernet using a combination of FPGA and embedded ARM computers; the software uses modern libraries such as Apache Thrift, ZMQ and Protocol buffers. This work describes in detail the design and the performance of the upgraded cameras.

preprint2015arXiv

Studies towards an understanding of global array pointing for the Cherenkov Telescope Array

For the proposed Cherenkov Telescope Array (CTA), a post-calibration point-source location accuracy of 3 seconds of arc is aimed for under favorable observing conditions and for gamma-ray energies exceeding 100 GeV. In this contribution, results of first studies on the location accuracy are presented. These studies are based on a toy Monte Carlo simulation of a typical CTA-South array layout, taking into account the expected trigger rates of the different CTA telescope types and the gamma-ray spectrum of the simulated source. With this simulation code it is possible to study the location accuracy as a function of arbitrary telescope mis-orientations and for typical observing patterns on the sky. Results are presented for various scenarios, including one for which all individual telescopes are randomly mis-oriented within their specified limits. The study provides solid lower limits for the expected source location accuracy of CTA, and can be easily extended to include various other important effects like atmospheric refraction or partial cloud coverage.

preprint2013arXiv

Mono-everything: combined limits on dark matter production at colliders from multiple final states

Searches for dark matter production at particle colliders are complementary to direct-detection and indirect-detection experiments, and especially powerful for small masses, $m_χ<100$ GeV. An important collider dark matter signature is due to the production of a pair of these invisible particles with the initial-state radiation of a standard model particle. Currently, collider searches use individual and nearly orthogonal final states to search for initial-state jets, photons or massive gauge bosons. We combine these results across final states and across experiments to give the strongest current collider-based limits in the context of effective field theories, and map these to limits on dark matter interactions with nuclei and to dark matter self-annhiliation.

preprint2013arXiv

Sensitivity of future collider facilities to WIMP pair production via effective operators and light mediators

We present extrapolations of the current mono-jet searches at the LHC to potential future hadron collider facilities: LHC14, as well as $pp$ colliders with $\sqrt{s}=33$ or 100 TeV. We consider both the effective operator approach as well as one example of a light mediating particle.

preprint2007arXiv

The ATLAS Level-1 Trigger: Status of the System and First Results from Cosmic-Ray Data

The ATLAS detector at CERN's Large Hadron Collider (LHC) will be exposed to proton-proton collisions from beams crossing at 40 MHz. At the design luminosity of 10^34 cm^-2 s^-1 there are on average 23 collisions per bunch crossing. A three-level trigger system will select potentially interesting events in order to reduce the read-out rate to about 200 Hz. The first trigger level is implemented in custom-built electronics and makes an initial fast selection based on detector data of coarse granularity. It has to reduce the rate by a factor of 10^4 to less than 100 kHz. The other two consecutive trigger levels are in software and run on PC farms. We present an overview of the first-level trigger system and report on the current installation status. Moreover, we show analysis results of cosmic-ray data recorded in situ at the ATLAS experimental site with final or close-to-final hardware.