Source author record

Alexandre Courac

Alexandre Courac appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.mtrl-sci

Catalog footprint

What is connected

3works

1topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2021arXiv

Heat capacities of nanostructured wurtzite and rock salt ZnO: challenges of ZnO nano-phase diagram

Low-temperature heat capacities (Cp) of nanostructured rock salt (rs-ZnO) and wurtzite (w-ZnO) polymorphs of zinc oxide were measured in the 2-315 K temperature range. No significant influence of nanostructuring on Cp of w-ZnO has been observed. The measured Cp of rock salt ZnO is lower than that of wurtzite ZnO below 100 K and is higher above this temperature. Using available thermodynamic data, we established that the equilibrium pressure between nanocrystalline w-ZnO and rs-ZnO is close to 4.6 GPa at 300 K (half as much as the onset pressure of direct phase transformation) and slightly changes with temperature up to 1000 K.

preprint2020arXiv

The effect of doping on the lattice parameter and properties of cubic boron nitride

The effect of doping of cubic boron nitride with beryllium, silicon, sulfur and magnesium on the lattice parameters, electrical conductivity and EPR spectra has been studied. It is established that the degree of doping increases significantly in the case of crystallization of cubic boron nitride from BN solutions in supercritical ammonia at 3.9-4.2 GPa and 1100°C in comparison with the conventional synthesis from melts of the Mg-B-N system at 4.2 GPa and 1400°C. Doping with silicon and beryllium results in semiconductor properties of cubic boron nitride.

preprint2019arXiv

Thermoelastic equation of state and melting of Mg metal at high pressure and high temperature

The p-V-T equation of state of magnesium metal has been measured up to 20 GPa and 1500 K using both multianvil and opposite anvil techniques combined with synchrotron X-ray diffraction. To fit the experimental data, the model of Anderson-Grüneisen has been used with fixed parameter δT. The 300-K bulk modulus of B0 = 32.5(1) GPa and its first pressure derivative, B0' = 3.73(2), have been obtained by fitting available data up to 20 GPa to Murnaghan equation of state. Thermal expansion at ambient pressure has been described using second order polynomial with coefficients a = 25(2)x10-6 K-1 and b = 9.4(4)x10-9 K-2. The parameter describing simultaneous pressure and temperature impact on thermal expansion coefficient (and, therefore, volume) is δT = 1.5(5). The good agreement between fitted and experimental isobars has been achieved to relative volumes of 0.75. The Mg melting observed by X-ray diffraction and in situ electrical resistivity measurements confirms previous results and additionally confirms the p-T estimations in the vicinity of melting.