Researcher profile

Yoshiharu Asaki

Yoshiharu Asaki contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

Trust snapshot

Quick read

Trust 21 - Emerging
9works
0followers
4topics
4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Research graph

See the researcher in context

Open full explorer

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

9 published item(s)

preprint2020arXiv

ALMA Band-to-band Phase Referencing: Imaging Capabilities on Long Baselines and High Frequencies

High-frequency long-baseline experiments with the Atacama Large Millimeter/submillimeter Array were organized to test the high angular resolution imaging capabilities in the submillimeter wave regime using baselines up to 16 km. Four experiments were conducted, two Band 7 (289 GHz) and two Band 8 (405 GHz) observations. Phase correction using band-to-band (B2B) phase referencing was used with a phase calibrator only 0.7deg away observed in Band 3 (96 GHz) and Band 4 (135 GHz), respectively. In Band 8, we achieved the highest resolution of 14x11 mas. We compared the synthesis images of the target quasar using 20 and 60 s switching cycle times in the phase referencing. In Band 7, the atmosphere had good stability in phase rms (<0.5 rad over 2 minutes), and there was little difference in image coherence between the 20 and 60 s switching cycle times. One Band 8 experiment was conducted under a worse phase rms condition (>1 rad over 2 minutes), which led to a significantly reduced coherence when using the 60 s switching cycle time. One of our four experiments indicates that the residual phase rms error after phase referencing can be reduced to 0.16 rad at 289 GHz in using the 20 s switching cycle time. Such conditions would meet the phase correction requirement of image coherence of >70% in Band 10, assuming a similar phase calibrator separation angle, emphasizing the need for such B2B phase referencing observing at high frequencies.

preprint2020arXiv

ALMA High-frequency Long Baseline Campaign in 2017: Band-to-band Phase Referencing in Submillimeter Waves

In 2017, an Atacama Large Millimeter/submillimeter Array (ALMA) high-frequency long baseline campaign was organized to test image capabilities with baselines up to 16 km at submillimeter (submm) wavelengths. We investigated image qualities using ALMA receiver Bands 7, 8, 9, and 10 (285-875 GHz) by adopting band-to-band (B2B) phase referencing in which a phase calibrator is tracked at a lower frequency. For B2B phase referencing, it is expected that a closer phase calibrator to a target can be used, comparing to standard in-band phase referencing. In the first step, it is ensured that an instrumental phase offset difference between low- and high-frequency Bands can be removed using a differential gain calibration in which a phase calibrator is certainly detected while frequency switching. In the next step, comparative experiments are arranged to investigate the image quality between B2B and in-band phase referencing with phase calibrators at various separation angles. In the final step, we conducted long baseline imaging tests for a quasar at 289 GHz in Band 7 and 405 GHz in Band 8 and complex structure sources of HL Tau and VY CMa at ~670 GHz in Band 9. The B2B phase referencing was successfully applied, allowing us to achieve an angular resolution of 14x11 and 10x8 mas for HL Tau and VY CMa, respectively. There is a high probability of finding a low-frequency calibrator within 5.4 deg in B2B phase referencing, bright enough to use an 8 s scan length combined with a 7.5 GHz bandwidth.

preprint2020arXiv

ALMA High-frequency Long-baseline Campaign in 2017: A Comparison of the Band-to-band and In-band Phase Calibration Techniques and Phase-calibrator Separation Angles

The Atacama Large millimeter/submillimeter Array (ALMA) obtains spatial resolutions of 15 to 5 milli-arcsecond (mas) at 275-950GHz (0.87-0.32mm) with 16km baselines. Calibration at higher-frequencies is challenging as ALMA sensitivity and quasar density decrease. The Band-to-Band (B2B) technique observes a detectable quasar at lower frequency that is closer to the target, compared to one at the target high-frequency. Calibration involves a nearly constant instrumental phase offset between the frequencies and the conversion of the temporal phases to the target frequency. The instrumental offsets are solved with a differential-gain-calibration (DGC) sequence, consisting of alternating low and high frequency scans of strong quasar. Here we compare B2B and in-band phase referencing for high-frequencies ($>$289GHz) using 2-15km baselines and calibrator separation angles between $\sim$0.68 and $\sim$11.65$^{\circ}$. The analysis shows that: (1) DGC for B2B produces a coherence loss $<$7% for DGC phase RMS residuals $<$30$^{\circ}$. (2) B2B images using close calibrators ( $<$1.67$^{\circ}$ ) are superior to in-band images using distant ones ( $>$2.42$^{\circ}$ ). (3) For more distant calibrators, B2B is preferred if it provides a calibrator $\sim$2$^{\circ}$ closer than the best in-band calibrator. (4) Decreasing image coherence and poorer image quality occur with increasing phase calibrator separation angle because of uncertainties in the antenna positions and sub-optimal phase referencing. (5) To achieve $>$70% coherence for long-baseline (16 km) band 7 (289GHz) observations, calibrators should be within $\sim$4$^{\circ}$ of the target.

preprint2014arXiv

Distance and proper motion measurement of water masers in Shapless 269 IRS 2w

We present astrometric analysis of archival data of water masers in the star-forming region Sharpless 269 (S269) IRS 2w, observed with the VLBI Exploration of Radio Astrometry. An annual parallax of one of the bright maser features in this region was previously reported to be 0.189+/-0.008 milliarcsecond (mas) using part of the same archival data as we used. However, we found that this maser feature is not the best to represent the annual parallax to S269 IRS 2w because the morphology is remarkably elongated in the east-west direction. For this study we have selected another maser feature showing simpler morphology. This makes the new annual parallax estimate more credible. Our newly obtained annual parallax is 0.247+/-0.034 mas, corresponding to 4.05+0.65-0.49 kpc. This value is well consistent with the 3.7-3.8 kpc obtained using the kinematic distance estimates and photometric distance modulus. We considered two hypotheses for the water maser spatial distribution, a bipolar outflow and an expanding ring, in a kinematic model fitting analysis with a radially expanding flow. At this stage, any conclusions about the systemic proper motion could not be drawn from the kinematic analysis. Alternatively, we evaluated the mean proper motion to be (0.39+/-0.92, -1.27+/-0.90) mas/yr eastward and northward, respectively, from the obtained proper motions of the detected water maser features. The newly obtained annual parallax and mean proper motion give the peculiar motion of S269 IRS 2w to be (Us, Vs, Ws) of (8+/-6, -21+/-17, 1+/-18) km/s.

preprint2014arXiv

No Microwave Flare of Sagittarius A* around the G2 Periastron Passing

In order to explore any change caused by the G2 cloud approaching, we have monitored the flux density of Sgr A* at 22 GHz from Feb. 2013 to Aug. 2014 with a sub-array of Japanese VLBI Network . The observation period included the expected periastron dates. The number of observation epochs was 283 days. We have observed no significant microwave enhancement of Sgr A* in the whole observation period. The average flux density in the period is $S=1.23+/-0.33$ Jy. The average is consistent with the usually observed flux density range of Sgr A* at 22 GHz.

preprint2014arXiv

Phase Characteristics of the ALMA 3 km Baseline Data

We present the phase characteristics study of the Atacama Large Millimeter/submillimeter Array (ALMA) long (up to 3 km) baseline, which is the longest baseline tested so far using ALMA. The data consist of long time-scale (10 - 20 minutes) measurements on a strong point source (i.e., bright quasar) at various frequency bands (bands 3, 6, and 7, which correspond to the frequencies of about 88 GHz, 232 GHz, and 336 GHz). Water vapor radiometer (WVR) phase correction works well even at long baselines, and the efficiency is better at higher PWV (>1 mm) condition, consistent with the past studies. We calculate the spatial structure function of phase fluctuation, and display that the phase fluctuation (i.e., rms phase) increases as a function of baseline length, and some data sets show turn-over around several hundred meters to 1 km and being almost constant at longer baselines. This is the first millimeter/submillimeter structure function at this long baseline length, and to show the turn-over of the structure function. Furthermore, the observation of the turn-over indicates that even if the ALMA baseline length extends to the planned longest baseline of 15 km, fringes will be detected at a similar rms phase fluctuation as that at a few km baseline lengths. We also calculate the coherence time using the 3 km baseline data, and the results indicate that the coherence time for band 3 is longer than 400 seconds in most of the data (both in the raw and WVR-corrected data). For bands 6 and 7, WVR-corrected data have about twice longer coherence time, but it is better to use fast switching method to avoid the coherence loss.

preprint2013arXiv

Distance and Proper Motion Measurement of the Red Supergiant, PZ Cas, in Very Long Baseline Interferometry H2O Maser Astrometry

We present the very long baseline interferometry H2O maser monitoring observations of the red supergiant, PZ Cas, at 12 epochs from 2006 April to 2008 May. We fitted maser motions to a simple model composed of a common annual parallax and linear motions of the individual masers. The maser motions with the parallax subtracted were well modeled by a combination of a common stellar proper motion and a radial expansion motion of the circumstellar envelope. We obtained an annual parallax of 0.356+/-0.026 mas and a stellar proper motion of μ*αcosδ=-3.7+/-0.2 and μ*δ=-2.0+/-0.3 mas/yr eastward and northward, respectively. The annual parallax corresponds to a trigonometric parallax of 2.81+0.22-0.19 kpc. By rescaling the luminosity of PZ Cas in any previous studies using our trigonometric parallax, we estimated the location of PZ Cas on a Hertzsprung-Russell diagram and found that it approaches a theoretically evolutionary track around an initial mass of ~25M(sun). The sky position and the distance to PZ Cas are consistent with the OB association, Cas OB5, which is located in a molecular gas super shell. The proper motion of PZ Cas is close to that of the OB stars and other red supergiants in Cas OB5 measured by the Hipparcos satellite. We derived the peculiar motion of PZ Cas of Us = 22.8+/-1.5, Vs = 7.1+/-4.4, and Ws = -5.7+/-4.4 km/s. This peculiar motion has rather a large Us component, unlike those of near high-mass star-forming regions with negatively large Vs motions. The uniform proper motions of the Cas OB5 member stars suggest random motions of giant molecular clouds moving into local potential minima in a time-dependent spiral arm, rather than a velocity field caused by the spiral arm density wave.

preprint2012arXiv

Analysis of H2O Masers in Sharpless 269 using VERA Archival data --- Effect of maser structures on astrometric accuracy

Astrometry using H2O maser sources in star forming regions is expected to be a powerful tool to study the structures and dynamics of our Galaxy. Honma et al. (2007) (hereafter H2007) claimed that the annual parallax of S269 is determined within an error of 0.008 milliarcsec (mas), concluding that S269 is located at 5.3 kpc +- 0.2 kpc from the sun, and R= 13.1 kpc. They claimed that the rotational velocity of S269 is equal to that of the sun within a 3% error. This small error, however, is hardly understood when taking into account the results of other observations and theoretical studies of galactic dynamics. We here reanalyzed the VERA archival data using the self-calibration method (hybrid mapping), and found that clusters of maser features of S269 are distributed in much wider area than that investigated in H2007. We confirmed that, if we make a narrow region image without considering the presence of multiple maser spots, and only the phase calibration is applied, we can reproduce the same maser structures in H2007. The distribution extent of maser spots in the feature differs 0.2 mas from east to west between our results and H2007. Moreover, we found that change of relative positions of maser spots in the cluster reaches 0.1 mas or larger between observational epochs. This suggests that if one simply assumes the time-dependent, widely distributed maser sources as a stable single point source, it could cause errors of up to 0.1 mas in the annual parallax of S269. Taking into account the internal motions of maser spot clusters, the proper motion of S269 cannot be determined precisely. We estimated that the peculiar motion of S269 with respect to a Galactic circular rotation is ~20 km/s. These results imply that the observed kinematics of maser emissions in S269 cannot give a strong constraint on dynamics of the outer part of the Galaxy, in contrast to the claim by H2007.

preprint2010arXiv

Verification of the Effectiveness of VSOP-2 Phase Referencing with a Newly Developed Simulation Tool, ARIS

The next-generation space VLBI mission, VSOP-2, is expected to provide unprecedented spatial resolutions at 8.4, 22, and 43GHz. In this report, phase referencing with VSOP-2 is examined in detail based on a simulation tool called ARIS. The criterion for successful phase referencing was to keep the phase errors below one radian. Simulations with ARIS reveal that phase referencing achieves good performance at 8.4GHz, even under poor tropospheric conditions. At 22 and 43GHz, it is recommended to conduct phase referencing observations under good or typical tropospheric conditions. The satellite is required to have an attitude-switching capability with a one-minute or shorter cycle, and an orbit determination accuracy higher than about 10cm at apogee; the phase referencing calibrators are required to have a signal-to-noise ratio larger than four for a single scan. The probability to find a suitable phase referencing calibrator was estimated by using VLBI surveys. From the viewpoint of calibrator availability, VSOP-2 phase referencing at 8.4GHz is promising. However, the change of finding suitable calibrators at 22 and 43GHz is significantly reduced; it is important to conduct specific investigations for each target at those frequencies.