Source author record

W. Gawalek

W. Gawalek appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.supr-con cond-mat.mtrl-sci

Catalog footprint

What is connected

4works

2topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2012arXiv

AC losses in high pressure synthesized MgB2 bulk rings measured by transformer method

The recently developed manufacturing technologies use high pressure and various doping additions to prepare bulk MgB2-based materials with a high critical current density measured by the magnetization methods. We use a contactless transformer method, which is based on studying the superconductor response to an induced transport current, to measure AC losses in bulk MgB2 rings synthesized under high pressure. The obtained dependence of the losses on the primary current (applied magnetic field) is fitted by the power law with the exponent ~2.1 instead of the cubic dependence predicted by Bean's model and power-law electric field-current density (E-J) characteristics with a large exponent. The unusually strong dependence of AC losses on the frequency was also observed. It was shown that the E-J characteristic of bulk MgB2 is well fitted by the dependence used in the extended critical state model based on account of the viscous vortex motion in the flux flow regime. Numerical simulation using this E-J characteristic gives the current and frequency AC loss dependencies which well agree with the experimental results.

preprint2010arXiv

Effects of high pressure on the physical properties of MgB2

The synthesis of MgB2-based materials under high pressure gave the possibility to suppress the evaporation of magnesium and to obtain near theoretically dense nanograined structures with high superconducting, thermal conducting, and mechanical characteristics: critical current densities of 1.8-1.0 \cdot 106 A/cm2 in the self field and 103 A/cm2 in a magnetic field of 8 T at 20 K, 5-3 \cdot 105 A/cm2 in self field at 30 K, the corresponding critical fields being HC2 = 15 T at 22 K and irreversible fields Hirr =13 T at 20 K, and Hirr =3.5 T at 30 K, thermal conduction of 53+/-2 W/(m \cdot κ), the Vickers hardness Hv=10.12+/-0.2 GPa under a load of 148.8 N and the fracture toughness K1C = 7.6+/-2.0 MPa m0.5 under the same load, the Young modulus E=213 GPa. Estimation of quenching current and AC losses allowed the conclusion that highpressure-prepared materials are promising for application in transformer-type fault current limiters working at 20-30 K.

preprint2009arXiv

Effect of higher borides and inhomogeneity of oxygen distribution on critical current density of undoped and doped magnesium diboride

The effect of doping with Ti, Ta, SiC in complex with synthesis temperature on the amount and distribution of structural inhomogeneities in MgB2 matrix of high-pressuresynthesized-materials (2 GPa) which can influence pining: higher borides (MgB12) and oxygen-enriched Mg-B-O inclusions, was established and a mechanism of doping effect on jc increase different from the generally accepted was proposed. Near theoretically dense SiC-doped material exhibited jc= 1000000 A/sq. cm in 1T field and Hirr =8.5 T at 20 K. The highest jc in fields above 9, 6, and 4 T at 10, 20, and 25 K, respectively, was demonstrated by materials synthesized at 2 GPa, 600 oC from Mg and B without additions (at 20 K jc= 100 A/sq. cm in 10 T field). Materials synthesized from Mg and B taken up to 1:20 ratio were superconductive. The highest jc (60000 A/sq. cm at 20 K in zero field, Hirr= 5 T) and the amount of SC phase (95.3 percents of shielding fraction), Tc being 37 K were demonstrated by materials having near MgB12 composition of the matrix. The materials with MgB12 matrix had a doubled microhardness of that with MgB2 matrix (25 GPa and 13.08 GPa, at a load of 4.9 N, respectively).

preprint2001arXiv

Growth-related inhomogeneities in bulk melt-grown YBaCuO crystals

The homogeneity of a large YBaCuO sample fabricated by top-seeded melt-growth has been studied in details. It was particularly shown how structural imperfections and superconducting properties are distributed along the growth front. These distributions are scarcely explicable within a suggestion that the a-growth fronts are flat. The obtained data testify to concave growth fronts.