Researcher profile

Valeri V. Laptev

Valeri V. Laptev contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

cond-mat.stat-mech cond-mat.dis-nn

Trust snapshot

Quick read

Trust 21 - Emerging

6works

0followers

2topics

4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2016arXiv

Electrical conductivity of a monolayer produced by random sequential adsorption of linear $k$-mers onto a square lattice

The electrical conductivity of a monolayer produced by the random sequential adsorption (RSA) of linear $k$-mers onto a square lattice was studied by means of computer simulation. Overlapping with pre-deposited $k$-mers and detachment from the surface were forbidden. The RSA continued until the saturation jamming limit, $p_j$. The isotropic and anisotropic depositions for two different models: of an insulating substrate and conducting $k$-mers (C-model) and of a conducting substrate and insulating $k$-mers (I-model) were examined. The Frank-Lobb algorithm was applied to calculate the electrical conductivity in both the $x$ and $y$ directions for different lengths ($k=1$ -- $128 $) and concentrations ($p=0$ -- $p_j$) of the $k$-mers. The `intrinsic electrical conductivity' and concentration dependence of the relative electrical conductivity $Σ(p)$ ($Σ=σ/ σ_m$ for the C-model and $Σ=σ_m /σ$ for the I-model, where $σ_m$ is the electrical conductivity of substrate) in different directions were analyzed. At large values of $k$ the $Σ(p)$ curves became very similar and they almost coincided at $k=128$. Moreover, for both models the greater the length of the $k$-mers the smoother the functions $Σ_{xy}(p)$, $Σ_{x}(p)$ and $Σ_{y}(p)$. For the C-model, the other interesting findings are: for large values of $k$ ($k=64, 128$), the values of $Σ_{xy}$ and $Σ_{y}$ increase rapidly with the initial increase of $p$ from 0 to 0.1; for $k \geq 16$, all the $Σ_{xy}(p)$ and $Σ_{x}(p)$ curves intersect with each other at the same iso-conductivity points; for anisotropic deposition, the percolation concentrations are the same in the $x$ and $y$ directions, whereas, at the percolation point the greater the length of the $k$-mers the larger the anisotropy of the electrical conductivity, i.e., the ratio $σ_y/σ_x$ ($>1$).

preprint2015arXiv

Jamming and percolation in generalized models of random sequential adsorption of linear $k$-mers on a square lattice

The jamming and percolation for two generalized models of random sequential adsorption (RSA) of linear $k$-mers (particles occupying $k$ adjacent sites) on a square lattice are studied by means of Monte Carlo simulation. The classical random sequential adsorption (RSA) model assumes the absence of overlapping of the new incoming particle with the previously deposited ones. The first model LK$_d$ is a generalized variant of the RSA model for both $k$-mers and a lattice with defects. Some of the occupying $k$ adjacent sites are considered as insulating and some of the lattice sites are occupied by defects (impurities). For this model even a small concentration of defects can inhibit percolation for relatively long $k$-mers. The second model is the cooperative sequential adsorption (CSA) one, where, for each new $k$-mer, only a restricted number of lateral contacts $z$ with previously deposited $k$-mers is allowed. Deposition occurs in the case when $z\leq (1-d)z_m$ where $z_m=2(k+1)$ is the maximum numbers of the contacts of $k$-mer, and $d$ is the fraction of forbidden NN contacts. Percolation is observed only at some interval $k_{min}\leq k\leq k_{max}$ where the values $k_{min}$ and $k_{max}$ depend upon the fraction of forbidden contacts $d$. The value $k_{max}$ decreases as $d$ increases. A logarithmic dependence of the type $\log(k_{max})=a+bd$, where $a=-4.03 \pm 0.22$, $b=4.93 \pm 0.57 $, is obtained.

preprint2015arXiv

Percolation and jamming of linear $k$-mers on square lattice with defects: effect of anisotropy

We study the percolation and jamming of rods ($k$-mers) on a square lattice that contains defects. The point defects are placed randomly and uniformly on the substrate before deposition of the rods. The general case of unequal probabilities for orientation of depositing of rods along different directions of the lattice is analyzed. Two different models of deposition are used. In the relaxation random sequential adsorption model (RRSA), the deposition of rods is distributed over different sites on the substrate. In the single cluster relaxation model (RSC), the single cluster grows by the random accumulation of rods on the boundary of the cluster. For both models, a suppression of growth of the infinite cluster at some critical concentration of defects $d_c$ is observed. In the zero defect lattices, the jamming concentration $p_j$ (RRSA) and the density of single clusters $p_s$ (RSC) decrease with increasing length rods and with a decrease in the order parameter. For the RRSA model, the value of $d_c$ decreases for short rods as the value of $s$ increases. For longer rods, the value of $d_c$ is almost independent of $s$. Moreover, for short rods, the percolation threshold is almost insensitive to the defect concentration for all values of $s$. For the RSC model, the growth of clusters with ellipse-like shapes is observed for non-zero values of $s$. The density of the clusters $p_s$ at the critical concentration of defects $d_c$ depends in a complex manner on the values of $s$ and $k$. For disordered systems, the value of $p_s$ tends towards zero in the limits of the very long rods and very small critical concentrations $d_c \to 0$. In this case, the introduction of defects results in a suppression of rods stacking and in the formation of `empty' or loose clusters with very low density. On the other hand, denser clusters are formed for ordered systems.

preprint2014arXiv

Impact of defects on percolation in random sequential adsorption of linear k-mers on square lattice

The effect of defects on the percolation of linear $k$-mers (particles occupying $k$ adjacent sites) on a square lattice is studied by means of Monte Carlo simulation. The $k$-mers are deposited using a random sequential adsorption mechanism. Two models, $L_d$ and $K_d$, are analyzed. In the $L_d$ model, it is assumed that the initial square lattice is non-ideal and some fraction of sites, $d$, is occupied by non-conducting point defects (impurities). In the $K_d$ model, the initial square lattice is perfect. However, it is assumed that some fraction of the sites in the $k$-mers, $d$, consists of defects, i.e., are non-conducting. The length of the $k$-mers, $k$, varies from 2 to 256. Periodic boundary conditions are applied to the square lattice. The dependencies of the percolation threshold concentration of the conducting sites, $p_c$, vs the concentration of defects, $d$, were analyzed for different values of $k$. Above some critical concentration of defects, $d_m$, percolation is blocked in both models, even at the jamming concentration of $k$-mers. For long $k$-mers, the values of $d_m$ are well fitted by the functions $d_m \propto k_m^{-α}-k^{-α}$ ($α= 1.28 \pm 0.01$, $k_m = 5900 \pm 500$) and $d_m \propto \log (k_m/k)$ ($k_m = 4700 \pm 1000$ ), for the $L_d$ and $K_d$ models, respectively. Thus, our estimation indicates that the percolation of $k$-mers on a square lattice is impossible even for a lattice without any defects if $k\gtrapprox 6 \times 10^3$.

preprint2012arXiv

Percolation of linear $k$-mers on square lattice: from isotropic through partially ordered to completely aligned state

Numerical simulations by means of Monte Carlo method and finite-size scaling analysis have been performed to study the percolation behavior of linear $k$-mers (also denoted in the literature as rigid rods, needles, sticks) on two-dimensional square lattices $L \times L$ with periodic boundary conditions. Percolation phenomena are investigated for anisotropic relaxation random sequential adsorption of linear $k$-mers. Especially, effect of anisotropic placement of the objects on the percolation threshold has been investigated. Moreover, the behavior of percolation probability $R_L(p)$ that a lattice of size $L$ percolates at concentration $p$ has been studied in details in dependence on $k$, anisotropy and lattice size $L$. A nonmonotonic size dependence for the percolation threshold has been confirmed in isotropic case. We propose a fitting formula for percolation threshold $p_c = a/k^α+b\log_{10} k+ c$, where $a$, $b$, $c$, $α$ are the fitting parameters varying with anisotropy. We predict that for large $k$-mers ($k\gtrapprox 1.2\times10^4$) isotropic placed at the lattice, percolation cannot occur even at jamming concentration.

preprint2011arXiv

Random sequential adsorption of partially oriented linear $k$-mers on square lattice

Jamming phenomena on a square lattice are investigated for two different models of anisotropic random sequential adsorption (RSA) of linear $k$-mers (particles occupying $k$ adjacent adsorption sites along a line). The length of a $k$-mer varies from 2 to 128. Effect of $k$-mer alignment on the jamming threshold is examined. For completely ordered systems where all the $k$-mers are aligned along one direction (e.g., vertical), the obtained simulation data are very close to the known analytical results for 1d systems. In particular, the jamming threshold tends to the R{é}nyi's Parking Constant for large $k$. In the other extreme case, when $k$-mers are fully disordered, our results correspond to the published results for short $k$-mers. It was observed that for partially oriented systems the jamming configurations consist of the blocks of vertically and horizontally oriented $k$-mers ($v$- and $h$-blocks, respectively) and large voids between them. The relative areas of different blocks and voids depend on the order parameter $s$, $k$-mer length and type of the model. For small $k$-mers ($k\leqslant 4$), denser configurations are observed in disordered systems as compared to those of completely ordered systems. However, longer $k$-mers exhibit the opposite behavior.