Source author record

Nikolai V. Vygornitskii

Explore this author’s publications, collaborators and research topics. This catalog record has not been claimed by its author.

ResearcherUnclaimed source record

cond-mat.stat-mech cond-mat.dis-nn cond-mat.soft

Catalog footprint

Research overview

6works

3topics

4close collaborators

Actions

Is this your work?

Open graph Browse papers

preprint2020arXiv

"Paris car parking problem" for partially ordered discorectangles on a line

The random sequential adsorption (RSA) of identical elongated particles (discorectangles) on a line ("Paris car parking problem") was studied numerically. An off-lattice model with continuous positional and orientational degrees of freedom was considered. The possible orientations of the discorectanles were restricted between $θ\in [-θ_\text{m}; θ_\text{m}]$ while the aspect ratio (length-to-width ratio) for the discorectangles was varied within the range $\varepsilon \in [1;100]$ . Additionally, the limiting case $\varepsilon=\infty$ (i.e., widthless sticks) was considered. We observed, that the RSA deposition for the problem under consideration was governed by the formation of rarefied holes (containing particles oriented along a line) surrounded by comparatively dense stacks (filled with almost parallel particles oriented in the vertical direction). The kinetics of the changes of the order parameter, and the packing density are discussed. Partial ordering of the discorectangles significantly affected the packing density at the jamming state, $φ_\text{j}$ , and shifted the cusps in the $φ_\text{j}(\varepsilon)$ dependencies. This can be explained by the effects on the competition between the particles' orientational degrees of freedom and the excluded volume effects.

preprint2020arXiv

Random sequential adsorption of partially ordered discorectangles onto a continuous plane

Computer simulation was used to study the random sequential adsorption of identical discorectangles onto a continuous plane . The problem was analyzed for a wide range of discorectangle aspect ratios ( $\varepsilon \in [1;100]$ ). We studied anisotropic deposition, i.e., the orientations of the deposited particles were uniformly distributed within some interval such that the particles were preferentially aligned along a given direction. The kinetics of the changes in the packing density $φ$ found at different values of $S_0$ are discussed. Partial ordering of the discorectangles significantly affected the packing density at the jamming state, $φ_\text{j}$ , and shifted the cusps in the $φ_\text{j}(\varepsilon)$ dependencies. The structure of the jammed state was analyzed using the adsorption of disks of different diameters into the porous space between the deposited discorectangles. The analysis of the connectivity between the discorectangles was performed assuming a core---shell structure of particles.

preprint2016arXiv

Monte Carlo Simulation of Evaporation Driven Self-Assembly in Suspension of Colloidal Rods

The vertical drying of a colloidal film containing rod-like particles was studied by means of kinetic Monte Carlo (MC) simulation. The problem was approached using a two-dimensional square lattice and the rods were represented as linear $k$ -mers (i.e., particles occupying $k$ adjacent sites). The initial state before drying was produced using a model of random sequential adsorption (RSA) with isotropic orientations of the $k$ -mers (orientation of the $k$ -mers along horizontal $x$ and vertical $y$ directions are equiprobable). In the RSA model, overlapping of the $k$ -mers is forbidden. During the evaporation, an upper interface falls with a linear velocity of $u$ in the vertical direction and the $k$ -mers undergo translation Brownian motion. The MC simulations were run at different initial concentrations, $p_i$ , ( $p_i \in [0, p_j]$ , where $p_j$ is the jamming concentration), lengths of $k$ -mers ( $k \in [1, 12]$ ), and solvent evaporation rates, $u$ . For completely dried films, the spatial distributions of $k$ -mers and their electrical conductivities in both $x$ and $y$ directions were examined. Significant evaporation-driven self-assembly and orientation stratification of the $k$ -mers oriented along the $x$ and $y$ directions were observed. The extent of stratification increased with increasing value of $k$ . The anisotropy of the electrical conductivity of the film can be finely regulated by changes in the values of $p_i$ , $k$ and $u$ .

preprint2015arXiv

Jamming and percolation in generalized models of random sequential adsorption of linear $k$ -mers on a square lattice

The jamming and percolation for two generalized models of random sequential adsorption (RSA) of linear $k$ -mers (particles occupying $k$ adjacent sites) on a square lattice are studied by means of Monte Carlo simulation. The classical random sequential adsorption (RSA) model assumes the absence of overlapping of the new incoming particle with the previously deposited ones. The first model LK $_d$ is a generalized variant of the RSA model for both $k$ -mers and a lattice with defects. Some of the occupying $k$ adjacent sites are considered as insulating and some of the lattice sites are occupied by defects (impurities). For this model even a small concentration of defects can inhibit percolation for relatively long $k$ -mers. The second model is the cooperative sequential adsorption (CSA) one, where, for each new $k$ -mer, only a restricted number of lateral contacts $z$ with previously deposited $k$ -mers is allowed. Deposition occurs in the case when $z\leq (1-d)z_m$ where $z_m=2(k+1)$ is the maximum numbers of the contacts of $k$ -mer, and $d$ is the fraction of forbidden NN contacts. Percolation is observed only at some interval $k_{min}\leq k\leq k_{max}$ where the values $k_{min}$ and $k_{max}$ depend upon the fraction of forbidden contacts $d$ . The value $k_{max}$ decreases as $d$ increases. A logarithmic dependence of the type $\log(k_{max})=a+bd$ , where $a=-4.03 \pm 0.22$ , $b=4.93 \pm 0.57$ , is obtained.

preprint2015arXiv

Percolation and jamming of linear $k$ -mers on square lattice with defects: effect of anisotropy

We study the percolation and jamming of rods ( $k$ -mers) on a square lattice that contains defects. The point defects are placed randomly and uniformly on the substrate before deposition of the rods. The general case of unequal probabilities for orientation of depositing of rods along different directions of the lattice is analyzed. Two different models of deposition are used. In the relaxation random sequential adsorption model (RRSA), the deposition of rods is distributed over different sites on the substrate. In the single cluster relaxation model (RSC), the single cluster grows by the random accumulation of rods on the boundary of the cluster. For both models, a suppression of growth of the infinite cluster at some critical concentration of defects $d_c$ is observed. In the zero defect lattices, the jamming concentration $p_j$ (RRSA) and the density of single clusters $p_s$ (RSC) decrease with increasing length rods and with a decrease in the order parameter. For the RRSA model, the value of $d_c$ decreases for short rods as the value of $s$ increases. For longer rods, the value of $d_c$ is almost independent of $s$ . Moreover, for short rods, the percolation threshold is almost insensitive to the defect concentration for all values of $s$ . For the RSC model, the growth of clusters with ellipse-like shapes is observed for non-zero values of $s$ . The density of the clusters $p_s$ at the critical concentration of defects $d_c$ depends in a complex manner on the values of $s$ and $k$ . For disordered systems, the value of $p_s$ tends towards zero in the limits of the very long rods and very small critical concentrations $d_c \to 0$ . In this case, the introduction of defects results in a suppression of rods stacking and in the formation of `empty' or loose clusters with very low density. On the other hand, denser clusters are formed for ordered systems.

preprint2014arXiv

Impact of defects on percolation in random sequential adsorption of linear k-mers on square lattice

The effect of defects on the percolation of linear $k$ -mers (particles occupying $k$ adjacent sites) on a square lattice is studied by means of Monte Carlo simulation. The $k$ -mers are deposited using a random sequential adsorption mechanism. Two models, $L_d$ and $K_d$ , are analyzed. In the $L_d$ model, it is assumed that the initial square lattice is non-ideal and some fraction of sites, $d$ , is occupied by non-conducting point defects (impurities). In the $K_d$ model, the initial square lattice is perfect. However, it is assumed that some fraction of the sites in the $k$ -mers, $d$ , consists of defects, i.e., are non-conducting. The length of the $k$ -mers, $k$ , varies from 2 to 256. Periodic boundary conditions are applied to the square lattice. The dependencies of the percolation threshold concentration of the conducting sites, $p_c$ , vs the concentration of defects, $d$ , were analyzed for different values of $k$ . Above some critical concentration of defects, $d_m$ , percolation is blocked in both models, even at the jamming concentration of $k$ -mers. For long $k$ -mers, the values of $d_m$ are well fitted by the functions $d_m \propto k_m^{-α}-k^{-α}$ ( $α= 1.28 \pm 0.01$ , $k_m = 5900 \pm 500$ ) and $d_m \propto \log (k_m/k)$ ( $k_m = 4700 \pm 1000$ ), for the $L_d$ and $K_d$ models, respectively. Thus, our estimation indicates that the percolation of $k$ -mers on a square lattice is impossible even for a lattice without any defects if $k\gtrapprox 6 \times 10^3$ .

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Nikolai V. Vygornitskii

Research overview

Is this your work?

6 publications

"Paris car parking problem" for partially ordered discorectangles on a line

Random sequential adsorption of partially ordered discorectangles onto a continuous plane

Monte Carlo Simulation of Evaporation Driven Self-Assembly in Suspension of Colloidal Rods

Jamming and percolation in generalized models of random sequential adsorption of linear $k$ -mers on a square lattice

Percolation and jamming of linear $k$ -mers on square lattice with defects: effect of anisotropy

Impact of defects on percolation in random sequential adsorption of linear k-mers on square lattice

See the researcher in context

Building this map preview

Nikolai V. Vygornitskii

Research overview

Is this your work?

6 publications

"Paris car parking problem" for partially ordered discorectangles on a line

Random sequential adsorption of partially ordered discorectangles onto a continuous plane

Monte Carlo Simulation of Evaporation Driven Self-Assembly in Suspension of Colloidal Rods

Jamming and percolation in generalized models of random sequential adsorption of linear kkk-mers on a square lattice

Percolation and jamming of linear kkk-mers on square lattice with defects: effect of anisotropy

Impact of defects on percolation in random sequential adsorption of linear k-mers on square lattice

See the researcher in context

Building this map preview

Jamming and percolation in generalized models of random sequential adsorption of linear $k$ -mers on a square lattice

Percolation and jamming of linear $k$ -mers on square lattice with defects: effect of anisotropy