Source author record

Ulrich Tutsch

Explore this author’s publications, collaborators and research topics. This catalog record has not been claimed by its author.

ResearcherUnclaimed source record

Catalog footprint

Research overview

6works
5topics
4close collaborators

Published work

6 publications

preprint2020arXiv

Characterization of the pressure coefficient of manganin and temperature evolution of pressure in piston-cylinder cells

We report measurements of the temperature- and pressure-dependent resistance, R(T,p)R(T,p), of a manganin manometer in a 4^4He-gas pressure setup from room temperature down to the solidification temperature of 4^4He (Tsolid∼T_\textrm {solid}\sim 50 K at 0.8 GPa) for pressures, pp, between 0 GPa and ∼\sim0.8 GPa. The same manganin wire manometer was also measured in a piston-cylinder cell from 300 K down to 1.8 K and for pressures between 0 GPa to ∼\sim2 GPa. From these data, we infer the temperature and pressure dependence of the pressure coefficient of manganin, α(T,p)α(T,p), defined by the equation Rp=(1+αp)R0R_p = (1+αp) R_0 where R0R_0 and RpR_p are the resistance of manganin at ambient pressure and finite pressure, respectively. Our results indicate that upon cooling αα first decreases, then goes through a broad minimum at ∼\sim120 K and increases again towards lower temperatures. In addition, we find that αα is almost pressure-independent for T≳T\gtrsim60 K up to p∼p\sim2 GPa, but shows a pronounced pp dependence for T≲T\lesssim60K. Using this manganin manometer, we demonstrate that pp overall decreases with decreasing temperature in the piston-cylinder cell for the full pressure range and that the size of the pressure difference between room temperature and low temperatures (T=1.8T=1.8 K), ΔpΔp, decreases with increasing pressure. We also compare the pressure values inferred from the magnanin manometer with the low-temperature pressure, determined from the superconducting transition temperature of elemental lead (Pb). As a result of these data and analysis we propose a practical algorithm to infer the evolution of pressure with temperature in a piston-cylinder cell.

preprint2016arXiv

Cooling through quantum criticality and many-body effects in condensed matter and cold gases

This article reviews some recent developments for new cooling technologies in the fields of condensed matter physics and cold gases, both from an experimental and theoretical point of view. The main idea is to make use of distinct many-body interactions of the system to be cooled which can be some cooling stage or the material of interest itself, as is the case in cold gases. For condensed matter systems, we discuss magnetic cooling schemes based on a large magnetocaloric effect as a result of a nearby quantum phase transition and consider effects of geometrical frustration. For ultracold gases, we review many-body cooling techniques, such as spin-gradient and Pomeranchuk cooling, which can be applied in the presence of an optical lattice. We compare the cooling performance of these new techniques with that of conventional approaches and discuss state-of-the-art applications.

preprint2016arXiv

Evidence for eight node mixed-symmetry superconductivity in a correlated organic metal

We report a combined theoretical and experimental investigation of the superconducting state in the quasi-two-dimensional organic superconductor κκ-(ET)2_2Cu[N(CN)2_2]Br. Applying spin-fluctuation theory to a low-energy material-specific Hamiltonian derived from ab initio density functional theory we calculate the quasiparticle density of states in the superconducting state. We find a distinct three-peak structure that results from a strongly anisotropic mixed-symmetry superconducting gap with eight nodes and twofold rotational symmetry. This theoretical prediction is supported by low-temperature scanning tunneling spectroscopy on in situ cleaved single crystals of κκ-(ET)2_2Cu[N(CN)2_2]Br with the tunneling direction parallel to the layered structure.

preprint2014arXiv

Magneto-elastic couplings in the distorted diamond-chain compound azurite

We present results of ultrasonic measurements on a single crystal of the distorted diamond-chain compound azurite Cu3_3(CO3_3)2_2(OH)2_2. Pronounced elastic anomalies are observed in the temperature dependence of the longitudinal elastic mode c22c_{22} which can be assigned to the relevant magnetic interactions in the system and their couplings to the lattice degrees of freedom. From a quantitative analysis of the magnetic contribution to c22c_{22} the magneto-elastic coupling GG = ∂J2\partial J_2/∂εb\partial ε_b can be determined, where J2J_2 is the intra-dimer coupling constant and εbε_b the strain along the intra-chain bb axis. We find an exceptionally large coupling constant of ∣G∣∼(|G| \sim (3650 ±\pm 150) K highlighting an extraordinarily strong sensitivity of J2J_2 against changes of the bb-axis lattice parameter. These results are complemented by measurements of the hydrostatic pressure dependence of J2J_2 by means of thermal expansion and magnetic susceptibility measurements performed both at ambient and finite hydrostatic pressure. We propose that a structural peculiarity of this compound, in which Cu2_2O6_6 dimer units are incorporated in an unusually stretched manner, is responsible for the anomalously large magneto-elastic coupling.

preprint2010arXiv

Synthesis, structural and physical properties of δ′δ'-FeSe1−x_{1-x}

We report on synthesis, structural characterization, resistivity, magnetic and thermal expansion measurements on the as yet unexplored δ′δ'-phase of FeSe1−x_{1-x}, here synthesized under ambient- (AP) and high-pressure (HP) conditions. We show that in contrast to ββ-FeSe1−x_{1-x}, monophasic superconducting δ′δ'-FeSe1−x_{1-x} can be obtained in off-stoichiometric samples with excess Fe atoms preferentially residing in the van der Waals gap between the FeSe layers. The AP δ′δ'-FeSe1−x_{1-x} sample studied here (TcT_c ≃\simeq 8.5\,K) possesses an unprecedented residual resistivity ratio RRR ≃\simeq 16. Thermal expansion data reveal a small feature around ∼\sim90\,K, which resembles the anomaly observed at the structural and magnetic transitions for other Fe-based superconductors, suggesting that some kind of "magnetic state" is formed also in FeSe. %indicative of a fluctuating magnetic ordering. For HP samples (RRR ≃\simeq 3), the disorder within the FeSe layers is enhanced through the introduction of vacancies, the saturated magnetic moment of Fe is reduced and only spurious superconductivity is observed.

preprint2005arXiv

Modulated-bath AC calorimetry using modified commercial Peltier-elements

We developed a new type of AC microcalorimeter based on a modulated-bath technique for measuring the specific heat of small microgram samples in the temperature range from 30-300 K, and tested it in magnetic fields up to 14 T. The device is built from a modified commercial Peltier element. The temperature of its top plate can be modulated periodically by Peltier effect, so that the oscillation is symmetrical about the temperature of the main bath. This avoids the problem of DC offsets which plagues conventional AC calorimeters. The sample is attached to a thin thermocouple cross, acting as a weak thermal link to a platform. The absence of a heater reduces the background heat capacity ('addenda') to a minimum. As an illustrative example of the performance of our device, the specific heat in fields up to 14 T of a small single crystal of the high-temperature superconductor Bi2.12Sr1.71Ca1.22Cu1.95Oy has been determined.

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.