Source author record

U. Sassi

U. Sassi appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.mes-hall cond-mat.mtrl-sci physics.app-ph

Catalog footprint

What is connected

5works

3topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2019arXiv

Graphene Overcoats for Ultra-High Storage Density Magnetic Media

Hard disk drives (HDDs) are used as secondary storage in a number of digital electronic devices owing to low cost ($<$0.1\$/GB at 2016 prices) and large data storage capacity (10TB with a 3.5 inch HDD). Due to the exponentially increasing amount of data, there is a need to increase areal storage densities beyond$\sim$1Tb/in$^2$. This requires the thickness of carbon overcoats (COCs) to be$<$2nm. Friction, wear, corrosion, and thermal stability are critical concerns$<$2nm, where most of the protective properties of current COCs are lost. This limits current technology and restricts COC integration with heat assisted magnetic recording technology (HAMR), since this also requires laser irradiation stability. Here we show that graphene-based overcoats can overcome all these limitations. 2-4 layers of graphene enable two-fold reduction in friction and provide better corrosion and wear than state-of-the-art COCs. A single graphene layer is enough to reduce corrosion$\sim$2.5 times. We also show that graphene can withstand HAMR conditions. Thus, graphene-based overcoats can enable ultrahigh areal density HDDs$>$10Tb/in$^2$.

preprint2018arXiv

Tetrahedral amorphous carbon resistive memories with graphene-based electrodes

Resistive-switching memories are alternative to Si-based ones, which face scaling and high power consumption issues. Tetrahedral amorphous carbon (ta-C) shows reversible, non-volatile resistive switching. Here we report polarity independent ta-C resistive memory devices with graphene-based electrodes. Our devices show ON/OFF resistance ratios$\sim$4x$10^5$, ten times higher than with metal electrodes, with no increase in switching power, and low power density$\sim$14$μ$W/$μ$m$^2$. We attribute this to a suppressed tunneling current due to the low density of states of graphene near the Dirac point, consistent with the current-voltage characteristics derived from a quantum point contact model. Our devices also have multiple resistive states. This allows storing more than one bit per cell. This can be exploited in a range of signal processing/computing-type operations, such as implementing logic, providing synaptic and neuron-like mimics, and performing analogue signal processing in non-von-Neumann architectures

preprint2015arXiv

Surface plasmon polariton graphene photodetectors

The combination of plasmonic nanoparticles and graphene enhances the responsivity and spectral selectivity of graphene-based photodetectors. However, the small area of the metal-graphene junction, where the induced electron-hole pairs separate, limits the photoactive region to sub-micron length scales. Here, we couple graphene with a plasmonic grating and exploit the resulting surface plasmon polaritons to deliver the collected photons to the junction region of a metal-graphene-metal photodetector. This results into a 400% enhancement of responsivity and a 1000% increase in photoactive length, combined with tunable spectral selectivity. The interference between surface plasmon polaritons and the incident wave introduces new functionalities, such as light flux attraction or repulsion from the contact edges, enabling the tailored design of the photodetector's spectral response. This architecture can also be used for surface plasmon bio-sensing with direct-electric- readout, eliminating the need of complicated optics.

preprint2015arXiv

Ultrafast pseudospin dynamics in graphene

Interband optical transitions in graphene are subject to pseudospin selection rules. Impulsive excitation with linearly polarized light generates an anisotropic photocarrier occupation in momentum space that evolves at timescales shorter than 100fs. Here, we investigate the evolution of non-equilibrium charges towards an isotropic distribution by means of fluence-dependent ultrafast spectroscopy and develop an analytical model able to quantify the isotropization process. In contrast to conventional semiconductors, the isotropization is governed by optical phonon emission, rather than electron-electron scattering, which nevertheless contributes in shaping the anisotropic photocarrier occupation within the first few fs.

preprint2014arXiv

Doping dependence of the Raman spectrum of defected graphene

We investigate the evolution of the Raman spectrum of defected graphene as a function of doping. Polymer electrolyte gating allows us to move the Fermi level up to 0.7eV, as monitored by \textit{in-situ} Hall-effect measurements. For a given number of defects, we find that the intensities of the D and D' peaks decrease with increasing doping. We assign this to an increased total scattering rate of the photoexcited electrons and holes, due to the doping-dependent strength of electron-electron scattering. We present a general relation between D peak intensity and defects valid for any doping level