Source author record

Till Walbaum

Till Walbaum appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

physics.optics

Catalog footprint

What is connected

4works

1topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2021arXiv

Measuring Thermal Load in Fiber Amplifiers in the Presence of Transversal Mode Instabilities

We report on detailed in-situ distributed temperature measurements inside a high power fiber amplifier. The deducted thermal load and the TMI-threshold of a commercial LMA fiber with 25 micron core and 400 micron cladding was measured at various seed wavelengths. By matching these results with detailed simulations we show that photodarkening has a negligible impact on the thermal load and, therefore, on the TMI threshold in this fiber.

preprint2021arXiv

Monolithic Thulium Fiber Laser with 567 W output power at 1970 nm

We report on a monolithic thulium fiber laser with 567 W output power at 1970 nm, which is the highest power reported so far directly from a thulium oscillator. This is achieved by optimization of the splice parameters for the active fiber (minimizing signal light in the fiber cladding) and direct water cooling. Dual transverse mode operation is visible from the optical spectrum and can also be deduced from the measured beam quality of M^2 = 2.6. \c{opyright} 2016 Optical Society of America under Open Access Publishing Agreement. Users may use, reuse, and build upon the article, or use the article for text or data mining, so long as such uses are for non-commercial purposes and appropriate attribution is maintained. All other rights are reserved.

preprint2014arXiv

Experimental realization of transverse mode conversion using optically induced transient long-period gratings

We present the experimental realization of transverse mode conversion in an optical fiber via an optically induced long-period grating. The transient gratings are generated by femtosecond laser pulses, exploiting the Kerr effect to translate intensity patterns emerging from multimode interference into a spatial refractive index modulation. Since these modulations exist only while the pump beam is present, they can be used for optical switching of transverse modes. As only a localized part of the grating was written at a time and the probe beam was co-propagating with the pump beam the required pulse energies could be reduced to 120\,nJ which is about a factor of 600 lower than in previous quasi-continuous-wave experiments. Accompanying numerical simulations allow a better understanding of the involved effects and show excellent agreement to the experimental results.

preprint2013arXiv

Optically induced mode conversion in graded-index fibers using ultra-short laser pulses

We propose the use of graded-index few-mode fibers for mode-conversion by long-period gratings (LPG) transiently written by ultrashort laser pulses using the optical Kerr effect. The mode inter- action is studied by numerically solving the multi-mode coupled nonlinear Schroedinger equations. We present highly efficient conversion of the LP 01 - into the LP 11 -mode preserving the pulse shape in contrast to previous results in step-index fibers. Furthermore, mode conversion using different wavelengths for inducing and probing the LPG is shown. Due to the flat phase-matching curve of the examined modes in the graded-index fiber, mode-conversion can be observed for probe center wavelengths of 1100nm up to 1800nm with a write beam centered around 1030nm. Therefore, a complete separation of the probe from the write beam should be possible as well as the application of optically induced guided mode conversion for all optical modulation across a broad wavelength range.