Researcher profile

T. Hasler

T. Hasler contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

cond-mat.mes-hall

Trust snapshot

Quick read

Trust 15 - Baseline

3works

0followers

1topics

4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Open graph Browse works

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2015arXiv

Clean carbon nanotubes coupled to superconducting impedance-matching circuits

Coupling carbon nanotube devices to microwave circuits offers a significant increase in bandwidth and signal-to-noise ratio. These facilitate fast non-invasive readouts important for quantum information processing, shot noise and correlation measurements. However, creation of a device that unites a low-disorder nanotube with a low-loss microwave resonator has so far remained a challenge, due to fabrication incompatibility of one with the other. Employing a mechanical transfer method, we successfully couple a nanotube to a gigahertz superconducting matching circuit and thereby retain pristine transport characteristics such as the control over formation of, and coupling strengths between, the quantum dots. Resonance response to changes in conductance and susceptance further enables quantitative parameter extraction. The achieved near matching is a step forward promising high-bandwidth noise correlation measurements on high impedance devices such as quantum dot circuits.

preprint2015arXiv

Shot noise of a quantum dot measured with GHz stub impedance matching

The demand for a fast high-frequency read-out of high impedance devices, such as quantum dots, necessitates impedance matching. Here we use a resonant impedance matching circuit (a stub tuner) realized by on-chip superconducting transmission lines to measure the electronic shot noise of a carbon nanotube quantum dot at a frequency close to 3 GHz in an efficient way. As compared to wide-band detection without impedance matching, the signal to noise ratio can be enhanced by as much as a factor of 800 for a device with an impedance of 100 k$Ω$. The advantage of the stub resonator concept is the ease with which the response of the circuit can be predicted, designed and fabricated. We further demonstrate that all relevant matching circuit parameters can reliably be deduced from power reflectance measurements and then used to predict the power transmission function from the device through the circuit. The shot noise of the carbon nanotube quantum dot in the Coulomb blockade regime shows an oscillating suppression below the Schottky value of $2eI$, as well an enhancement in specific regions.

preprint2014arXiv

Electrolyte gate dependent high-frequency measurement of graphene field-effect transistor for sensing applications

We performed radiofrequency (RF) reflectometry measurements at 2.4 GHz on electrolyte-gated graphene field-effect transistors (GFETs) utilizing a tunable stub-matching circuit for impedance matching. We demonstrate that the gate voltage dependent RF resistivity of graphene can be deduced even in the presence of the electrolyte which is in direct contact with the graphene layer. The RF resistivity is found to be consistent with its DC counterpart in the full gate voltage range. Furthermore, in order to access the potential of high-frequency sensing for applications, we demonstrate time-dependent gating in solution with nanosecond time resolution.