Researcher profile

Stephen K. Doorn

Stephen K. Doorn contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

cond-mat.mes-hall cond-mat.mtrl-sci

Trust snapshot

Quick read

Trust 21 - Emerging

6works

0followers

2topics

4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2016arXiv

Valence band electronic structure evolution of graphene oxide upon thermal annealing for optoelectronics

We report valence band electronic structure evolution of graphene oxide (GO) upon its thermal reduction. Degree of oxygen functionalization was controlled by annealing temperatures, and an electronic structure evolution was monitored using real-time ultraviolet photoelectron spectroscopy. We observed a drastic increase in density of states around the Fermi level upon thermal annealing at ~600 oC. The result indicates that while there is an apparent band gap for GO prior to a thermal reduction, the gap closes after an annealing around that temperature. This trend of band gap closure was correlated with electrical, chemical, and structural properties to determine a set of GO material properties that is optimal for optoelectronics. The results revealed that annealing at a temperature of ~500 oC leads to the desired properties, demonstrated by a uniform and an order of magnitude enhanced photocurrent map of an individual GO sheet compared to as-synthesized counterpart.

preprint2015arXiv

Influences of Exciton Diffusion and Exciton-Exciton Annihilation on Photon Emission Statistics of Carbon Nanotubes

Pump-dependent photoluminescence imaging and 2nd order photon correlation studies have been performed on individual single-walled carbon nanotubes (SWCNTs) at room temperature that enable the extraction of both the exciton diffusion constant and the Auger recombination coefficient. A linear correlation between these is attributed to the effect of environmental disorder in setting the exciton mean free-path and capture-limited Auger recombination at this lengthscale. A suppression of photon antibunching is attributed to creation of multiple spatially non-overlapping excitons in SWCNTs whose diffusion length is shorter than the laser spot size. We conclude that complete antibunching at room temperature requires an enhancement of exciton-exciton annihilation rate that may become realizable in SWCNTs allowing for strong exciton localization.

preprint2013arXiv

Intrinsic lineshape of the Raman 2D-mode in freestanding graphene monolayers

We report a comprehensive study of the two-phonon inter-valley (2D) Raman mode in graphene monolayers, motivated by recent reports of asymmetric 2D-mode lineshapes in freestanding graphene. For photon energies in the range $1.53 \rm eV - 2.71 \rm eV$, the 2D-mode Raman response of freestanding samples appears as bimodal, in stark contrast with the Lorentzian approximation that is commonly used for supported monolayers. The transition between the freestanding and supported cases is mimicked by electrostatically doping freestanding graphene at carrier densities above $2\times 10^{11} \rm cm^{-2}$. This result quantitatively demonstrates that low levels of charging can obscure the intrinsically bimodal 2D-mode lineshape of monolayer graphene, which can be utilized as a signature of a quasi-neutral sample. In pristine freestanding graphene, we observe a broadening of the 2D-mode feature with decreasing photon energy that cannot be rationalized using a simple one-dimensional model based on resonant \textit{inner} and \textit{outer} processes. This indicates that phonon wavevectors away from the high-symmetry lines of the Brillouin zone must contribute to the 2D-mode, so that a full two-dimensional calculation is required to properly describe multiphonon-resonant Raman processes.

preprint2013arXiv

Mechanism of Electrolyte-Induced Brightening in Single-Wall Carbon Nanotubes

While addition of electrolyte to sodium dodecyl sulfate suspensions of single-wall carbon nanotubes has been demonstrated to result in significant brightening of the nanotube photoluminescence (PL), the brightening mechanism has remained unresolved. Here, we probe this mechanism using time-resolved PL decay measurements. We find that PL decay times increase by a factor of 2 on addition of CsCl as the electrolyte. Such an increase directly parallels an observed near-doubling of PL intensity, indicating the brightening results primarily from changes in nonradiative decay rates associated with exciton diffusion to quenching sites. Our findings indicate that a reduced number of these sites results from electrolyte-induced reorientation of the surfactant surface structure that partially removes pockets of water from the tube surface where excitons can dissociate, and thus underscores the contribution of interfacial water in exciton recombination processes.

preprint2011arXiv

A New Route to Fluorescent SWNT/Silica Nanocomposites: Balancing Fluorescence Intensity and Environmental Sensitivity

We investigate the relationship between photoluminescence (PL) intensity and environmental sensitivity of surfactant-wrapped single walled carbon nanotubes (SWNTs). SWNTs were studied under a variety of conditions in suspension as well as encapsulated in silica nanocomposites, which were prepared by an efficient chemical vapor into liquids (CViL) sol-gel process. The dramatically improved silica encapsulation process described here has several advantages, including fast preparation and high SWNT loading concentration, over other encapsulation methods used to prepare fluorescent SWNT/silica nanocomposites. Further, addition of glycerol to SWNT suspensions prior to performing the CViL sol-gel process allows for the preparation of freestanding fluorescent silica xerogels, which to the best of our knowledge is the first report of such nanocomposites. Our spectroscopic data on SWNTs suspended in aqueous surfactants or encapsulated in silica show that achieving maximum PL intensity results in decreased sensitivity of SWNT emission response to changes imparted by the local environment. In addition, silica encapsulation can be used to "lock-in" a surfactant micelle structure surrounding SWNTs to minimize interactions between SWNTs and ions/small molecules. Ultimately, our work demonstrates that one should consider a balance between maximum PL intensity and the ability to sense environmental changes when designing new SWNT systems for future sensing applications.