Source author record

R. Flukiger

R. Flukiger appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.supr-con cond-mat.mtrl-sci physics.acc-ph physics.ins-det

Catalog footprint

What is connected

5works

4topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2014arXiv

The behaviour of copper in view of radiation damage in the LHC luminosity upgrade

In view of the safe operation of the quadrupoles in the luminosity upgrade of the LHC accelerator, the response of the copper stabilizer at low temperatures to the various high energy radiation sources is of primary importance. The present study takes into account the expected high energy spectrum of the simultaneous radiation by neutrons, protons, pions, electrons and photons, calculated using the FLUKA code by F. Cerutti (CERN) as well as on literature values. It was found that proton irradiation causes a considerably higher damage than neutron irradiation: in spite of a 3.8% proton fraction, the measured damage is of the order of 20%, which fits with the calculations of N. Mokhov (Fermilab) on the contribution of protons to the dpa. The same calculations indicate that the total effect of protons, pions and electrons is at least as high as that of neutrons. Since recent neutron experiments of Nakamoto et al. show that the RRR of Cu is reduced from 200 to 50-120 for a fluence of 10^{21} n/cm^{2}, it follows that the inclusion of all high energy sources would lead to RRR values well below 50, thus endangering stability and protection. This result confirms the necessity of including a tungsten shield inside the quadrupoles.

preprint2009arXiv

Strong enhancement of Jc in binary and alloyed in-situ MgB2 wires by a new approach: Cold high pressure densification

Cold high pressure densification (CHPD) is presented as a new way to substantially enhance the critical current density of in situ MgB2 wires at 4.2 and 20 K at fields between 5 and 14 T. The results on two binary MgB2 wires and an alloyed wire with 10 wt.% B4C are presented The strongest enhancement was measured at 20K, where cold densification at 1.85 GPa on a binary Fe/MgB2 wire raised both Jcpara and Jcperp by more than 300% at 5T, while Birr was enhanced by 0.7 T. At 4.2K, the enhancement of Jc was smaller, but still reached 53% at 10 T. After applying pressures up to 6.5 GPa, the mass density dm of the unreacted (B+Mg) mixture inside the filaments reached 96% of the theoretical density. After reaction under atmospheric pressure, this corresponds to a highest mass density df in the MgB2 filaments of 73%. After reaction, the electrical resistance of wires submitted to cold densification was found to decrease, reflecting an improved connectivity. A quantitative correlation between filament mass density and the physical properties was established. Monofilamentary rectangular wires with aspect ratios a/b < 1.25 based on low energy ball milled powders exhibited very low anisotropy ratios, Gamma = Jcpara/Jcperp being < 1.4 at 4.2 K and 10T. The present results can be generalized to alloyed MgB2 wires, as demonstrated on a wire with B4C additives. Based on the present data, it follows that cold densification has the potential of further improving the highest Jcpara and Jcperp values reported so far for in situ MgB2 tapes and wires with SiC and C additives. Investigations are under work in our laboratory to determine whether the densification method CHPD can be applied to longer wire or tape lengths.

preprint2003arXiv

Transport Properties and Exponential n-values of Fe/MgB2 Tapes With Various MgB2 Particle Sizes

Fe/MgB2 tapes have been prepared starting with pre-reacted binary MgB2 powders. As shown by resistive and inductive measurements, the reduction of particle size to a few microns by ball milling has little influence on Bc2, while the superconducting properties of the individual MgB2 grains are essentially unchanged. Reducing the particle size causes an enhancement of Birr from 14 to 16 T, while Jc has considerably increased at high fields, its slope Jc(B) being reduced. At 4.2K, values of 5.3*10^4 and 1.2*10^3 A/cm^2 were measured at 3.5 and 10 T, respectively, suggesting a dominant role of the conditions at the grain interfaces. A systematic variation of these conditions at the interfaces is undertaken in order to determine the limit of transport properties for Fe/MgB2 tapes. The addition of 5% Mg to MgB2 powder was found to affect neither Jc nor Bc2. For the tapes with the highest Jc values, very high exponential n factors were measured: n = 148, 89 and 17 at 3.5, 5 and 10T, respectively and measurements of critical current versus applied strain have been performed. The mechanism leading to high transport critical current densities of filamentary Fe/MgB2 tapes based on MgB2 particles is discussed.

preprint2002arXiv

AC losses in Bi,Pb(2223) multifilamentary wires with square cross-section

We have fabricated prototype Bi,Pb(2223)/Ag superconduting multifilamentary wires with a square cross-section. The AC losses of these wires were measured, compared with those of tapes and also compared with the theory. Wires show largely reduced AC magnetic field losses at 47 Hz, compared to those of tapes in a perpendicular magnetic field. The effects of the twist pitch and of the use of the high resisitive barriers were also investigated. The results show that the use of a twist pitch of about 10 mm is sufficient for decoupling the filaments, and that the use of very short twist pitches does not further reduce the absolute value of the AC losses. The losses in the wires are still higher than those of tapes in a parallel magnetic field, but the results show that the square or round configurations are interesting for applications where a perpendicular component of the magnetic field cannot be avoided, or for applications in rotating magnetic fields.

preprint1997arXiv

New features in the microwave response of YBCO crystals: Evidence for a multi-component order parameter

New features are reported in precision measurements of the complex microwave conductivity of high quality $YBa_{2}Cu_{3}O_{6.95}$ crystals grown in $BaZrO_{3}$ crucibles. A third peak in the normal conductivity, $σ_{1}(T)$, at around $80K$, and enhanced pair conductivity $σ_{2}(T)$ below $\sim 65K$ are observed. The data are inconsistent with a single order parameter, and instead are indicative of multi-component superconductivity. Overall, these results point to the presence of multiple pairing interactions in $YBa_{2}Cu_{3}O_{6.95}$ and also provide a natural explanation to account for the low temperature $35K$ conductivity peak observed in all $YBa_{2}Cu_{3}O_{6.95}$ crystals.