Researcher profile

Pankaj Doshi

Pankaj Doshi contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

cond-mat.soft physics.flu-dyn physics.med-ph physics.soc-ph

Trust snapshot

Quick read

Trust 15 - Baseline

3works

0followers

4topics

4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2020arXiv

On the utility of cloth facemasks for controlling ejecta during respiratory events

The utility of wearing simple cloth face masks is analyzed using computational fluid dynamics simulations. We simulate the aerodynamic flow through the mask and the spatial spread of droplet ejecta resulting from respiratory events such as coughing or sneezing. Without a mask, a turbulent jet forms, and droplets with a broad size distribution are ejected. Large droplets (greater than about 125 μm in diameter) fall to the ground within about 2 m, while turbulent clouds transport a mist of small aerosolized droplets over significant distances (~ 5 m), consistent with reported experimental findings. A loosely fitted simple cotton cloth mask (with a pore size ~ 4 microns) qualitatively changes the propagation of the high velocity jet, and largely eliminates the turbulent cloud downstream of the mask. About 12\% of the airflow leaks around the sides of a mask, considering a uniform gap of only 1 mm all around, between the face and the mask. The spread of ejecta is also changed, with most large droplets trapped at the mask surface. We present the viral load in the air and deposited around the person, and show that wearing even a simple cloth mask substantially decreases the extent of spatial spread of virus particles when an infected person coughs or sneezes.

preprint2016arXiv

Fingering instability of a suspension film spreading on a spinning disk

The spreading of a thin film of suspension on a spinning disk and the accompanying contact line instability is studied through flow visualization experiments. The critical radius for the onset of instability shows an increase with increase in the particle fraction ($ϕ_{p}$) before decreasing slightly at the highest value of $ϕ_{p}$ studied, while the instability wavelength ($λ$) exhibits a non-monotonic dependence. The value of $λ$ is close to that for a partially wetting liquid at lower $ϕ_{p}$, it decreases with increasing $ϕ_{p}$ to a minimum before increasing again at largest $ϕ_{p}$. The non-monotonic trends observed for $λ$ are discussed in light of the linear stability analysis of thin film equations derived for suspensions by Cook {\it et al.} [Linear stability of particle-laden thin films, Eur. Phys. J.: Spec. Top. {\bf 166}, 77 (2009)] and Balmforth {\it et al.} [Surface tension driven fingering of a viscoplastic film, J. Non Newtonian Fluid Mech. {\bf 142}, 143 (2007)].

preprint2014arXiv

Flow of granular matter in a silo with multiple exit orifices: Jamming to mixing

We investigate the mixing characteristics of dry granular material while draining down a silo with multiple exit orifices. The mixing in the silo, which otherwise consists of noninteracting stagnant and flow regions, is observed to improve significantly when the flow through specific orifices is stopped intermittently. This momentary stoppage of flow through the orifice is either controlled manually or is chosen by the system itself when the orifice width is small enough to cause spontaneous jamming and unjamming. We observe that the overall mixing behavior shows a systematic dependence on the frequency of closing and opening of specific orifices. In particular, the silo configuration employing random jamming and unjamming of any of the orifices shows early evidence of chaotic mixing. When operated in a multipass mode, the system exhibits a practical and efficient way of mixing particles.