Source author record

P. Ferrer

P. Ferrer appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.mtrl-sci cond-mat.other physics.app-ph

Catalog footprint

What is connected

3works

3topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2019arXiv

Experimental and simulated Performance of Hot Mirror Coatings in a Parabolic Trough Receiver

Thermal radiation is the dominant heat loss mechanism for receiver units on a parabolic solar collector plant at high temperatures. Reduction of these losses is traditionally achieved through the use of an optically selective coating on the absorber pipe, which absorbs visible light well but emits poorly in the IR region. Another possibility is the use of a hot mirror coating on the glass cover of the receiver, which reflects thermal radiation back onto the absorber pipe for reabsorption. In this paper, novel experimental results of a receiver unit operating with a hot mirror coating is presented, and the results between a developed model and a simulation are compared. It is seen that the correspondence is encouragingly close (Chi-squared test p-values between 0.995 and 0.80), where the simulation underestimates the experimental performance. Further, simulations to investigate the performance of various candidates for hot mirror coating (ITO, Gold and Silver) in solar through the receiver are presented, where it is seen that the hot mirror coating has access to higher temperature regions (above 700K). Lastly, simulation of the effects of variation of some optical parameters on overall plant efficiency, and comparison to existing selective coatings is presented.

preprint2012arXiv

Surface phase transitions in BiFeO3 below room temperature

We combine a wide variety of experimental techniques to analyze two heretofore mysterious phase transitions in multiferroic bismuth ferrite at low temperature. Raman spectroscopy, resonant ultrasound spectroscopy, EPR, X-ray lattice constant measurements, conductivity and dielectric response, specific heat and pyroelectric data have been collected for two different types of samples: single crystals and, in order to maximize surface/volume ratio to enhance surface phase transition effects, BiFeO3 nanotubes were also studied. The transition at T=140.3K is shown to be a surface phase transition, with an associated sharp change in lattice parameter and charge density at the surface. Meanwhile, the 201K anomaly appears to signal the onset of glassy behaviour.

preprint2011arXiv

Skin layer of BiFeO3 single crystals

A surface layer ("skin") that is functionally and structurally different from the bulk was found in single crystals of BiFeO3. Impedance analysis indicates that a previously reported anomaly at T* ~ 275 \pm 5 ^/circC corresponds to a phase transition confined at the surface of BiFeO3. X-ray photoelectron spectroscopy and X-ray diffraction as a function of both incidence angle and photon wavelength unambiguously confirm the existence of a skin with an estimated skin depth of few nanometres, elongated out-of-plane lattice parameter, and lower electron density. Temperature-dependent x-ray diffraction has revealed that the skin's out of plane lattice parameter changes abruptly at T*, while the bulk preserves an unfeatured linear thermal expansion. The distinct properties of the skin are likely to dominate in large surface to volume ratios scenarios such as fine grained ceramics and thin films, and should be particularly relevant for electronic devices that rely on interfacial couplings such as exchange bias.