Researcher profile

N. P. Kulish

N. P. Kulish contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

Trust snapshot

Quick read

Trust 15 - Baseline
3works
0followers
1topics
4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Research graph

See the researcher in context

Open full explorer

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

3 published item(s)

preprint2015arXiv

Analysis of the attainable efficiency of a direct-bandgap betavoltaic element

Conversion of energy of beta-particles into electric energy in a p-n junction based on direct-bandgap semiconductors, such as GaAs, considering realistic semiconductor system parameters is analyzed. An expression for the collection coefficient, $Q$, of the electron-hole pairs generated by beta-electrons is derived taking into account the existence of the dead layer. We show that the collection coefficient of beta-electrons emitted by a \Tr-source to a GaAs p-n junction is close to 1 in a broad range of electron lifetimes in the junction, ranging from $10^{-9}$ to $10^{-7}$ s. For the combination \Pm/GaAs, $Q$ is relatively large ($\ge 0.4$) only for quite long lifetimes (about $10^{-7}$ s) and large thicknesses (about $100\,μ$m) of GaAs p-n junctions. For realistic lifetimes of minority carriers and their diffusion coefficients, the open-circuit voltage realized due to the irradiation of a GaAs p-n junction by beta-particles is obtained. The attainable beta-conversion efficiency $η$ in the case of a \Tr/GaAs combination is found to exceed that of the \Pm/GaAs combination.

preprint2013arXiv

A new approach to simulation of limiting photoconversion efficiency of tandem solar cells

We develop a new approach to calculate the obtainable limit of photoconversion efficiency of tandem solar cells (SCs) and applied it to SCs with both vertical and lateral designs at AM0 and AM1.5 conditions. To get the maximum efficiency, only radiative recombination has been considered using typical radiative recombination parameters of the direct band gap III-V semiconductors, and explicit energy dependence of light absorption. When simulating the efficiency, we selfconsistently took into account the fact that the amount of the heat dissipated by SC decreases as the number of current-matched sub-cells increases. As the operating SCs temperature decreases both the open-circuit voltage and the photoconversion efficiency increase. It is shown that the above effect is especially strong for SCs operating under AM0 conditions. As the number of subcells is increased, narrowing the spectral range for each subcell, the photocurrent is additionally reduced due to the energy dependent light absorption, the factor generally ignored in the standard approaches. Application of our formalism results in a maximum in the theoretical dependence of the efficiency on the number of subcells, which was indeed observed experimentally. Besides agreement with experiment, our theoretical results are also close to other efficiencies calculated using detailed balance based approaches.

preprint2013arXiv

Multijunction solar cells efficiency simulation

The radiative recombination, Shokley-Read recombination, frontal-surface and rear-surface recombination and the recombination at the heterojunction boundaries and the recombination in the space charge region are considered in the calculation of the multijunction solar cell (MSC) efficiency. The calculation is performed by a self-consistent solution of the equations for the photocurrent and photovoltage, as well as the heat balance equation. A cooling of MSC with the increase of the number of cells n and the improvement in the heat dissipation is regarded. It was found that, as the number of cells n is increased, narrowing of spectral range for each cell causes additional reduction of current. A substantial increase in the MSC efficiency can be achieved by improving the heat extraction using radiators and increasing emissivity. A comparison is made between the calculated and experimental efficiency values. A rather good agreement was found. A comparison between this calculation and other formalisms is given.