A full-custom ASIC design of a 8-bit, 25 MHz, Pipeline ADC using 0.35 um CMOS technology
The purpose of this project was to design and implement a pipeline Analog-to-Digital Converter using 0.35um CMOS technology. Initial requirements of a 25-MHz conversion rate and 8-bits of resolution where the only given ones. Although additional secondary goals such as low power consumption and small area were stated. The architecture is based on a 1.5 bit per stage structure utilizing digital correction for each stage [12]. A differential switched capacitor circuit consisting of a cascade gm-C op-amp with 200MHz ft is used for sampling and amplification in each stage [12]. Differential dynamic comparators are used to implement the decision levels required for the 1.5-b per stage structure. Correction of the pipeline is accomplished by using digital correction circuit consist of D-latches and full-adders. Area and Power consumption of whole design was 0.24mm2 and 35mW respectively. The maximum sample rate at which the converter gave an adequate output was 33MHz.