Source author record

Michael Schreier

Michael Schreier appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

Catalog footprint

What is connected

13works
3topics
4close collaborators

Actions

Connect this record

Log in to claim

Research graph

See the researcher in context

Open full explorer

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

13 published item(s)

preprint2016arXiv

Spin Seebeck effect at microwave frequencies

We experimentally study the transient voltage response of yttrium iron garnet/platinum bilayer samples subject to periodic heating up to gigahertz frequencies. We observe an intrinsic cutoff frequency of the induced thermopower voltage, which characteristically depends on the thickness of the yttrium iron garnet film. The cutoff frequency reaches values of up to 350 MHz in a 50 nm thick yttrium iron garnet film, but drops to below 1 MHz for several-micrometer-thick films. These data corroborate the notion that the magnon spectrum responsible for the spin current emission in the spin Seebeck effect can be shaped by tuning the thickness of the ferromagnetic layer.

preprint2015arXiv

An all-electrical torque differential magnetometer operating under ambient conditions

An all-electrical torque differential magnetometry (also known as cantilever magnetometry) setup employing piezoelectric quartz tuning forks is demonstrated. The magnetometer can be operated under ambient conditions as well as low temperatures and pressures. It extends the allowed specimen mass range up to several 10 $μ$g without any significant reduction in the sensitivity. Operation under ambient conditions and a simple all-electrical design of the magnetometer should allow for an easy integration with other experimental setups. The uniaxial magnetic anisotropy of a 25 $μ$m diameter iron wire, measured under ambient conditions with a high signal to noise ratio, was found to be in good agreement with its literature value. Further applications of the technique are discussed.

preprint2015arXiv

Antiferromagentic resonance detected by DC voltages in MnF$_2$/Pt bilayers

We performed coplanar waveguide-based broadband ferromagnetic resonance experiments on the antiferromagnetic insulator MnF$_2$, while simultaneously recording the DC voltage arising in a thin platinum film deposited onto the MnF$_2$. The antiferromagnetic resonance is clearly reflected in both the transmission through the waveguide as well as the DC voltage in the Pt strip. The DC voltage remains largely unaffected by field reversal and thus presumably stems from microwave rectification and/or heating effects. However, we identify a small magnetic field orientation dependent contribution, compatible with antiferromagnetic spin pumping theory.

preprint2015arXiv

Current-induced spin torque resonance of magnetic insulators affected by field-like spin-orbit torques and out-of-plane magnetizations

The spin-torque ferromagnetic resonance (ST-FMR) in a bilayer system consisting of a magnetic insulator such as Y3Fe5O12 and a normal metal with spin-orbit interaction such as Pt is addressed theoretically. We model the ST-FMR for all magnetization directions and in the presence of field-like spin-orbit torques based on the drift-diffusion spin model and quantum mechanical boundary conditions. ST-FMR experiments may expose crucial information about the spin-orbit coupling between currents and magnetization in the bilayers.

preprint2015arXiv

Sign of inverse spin Hall voltages generated by ferromagnetic resonance and temperature gradients in yttrium iron garnet|platinum bilayers

We carried out a concerted effort to determine the absolute sign of the inverse spin Hall effect voltage generated by spin currents injected into a normal metal. We focus on yttrium iron garnet (YIG)|platinum bilayers at room temperature, generating spin currents by microwaves and temperature gradients. We find consistent results for different samples and measurement setups that agree with theory. We suggest a right-hand-rule to define a positive spin Hall angle corresponding to with the voltage expected for the simple case of scattering of free electrons from repulsive Coulomb charges.

preprint2014arXiv

Current-induced spin torque resonance of a magnetic insulator

Pure spin currents transport angular momentum without an associated charge flow. This unique property makes them attractive for spintronics applications, such as torque induced magnetization control in nanodevices that can be used for sensing, data storage, interconnects and logics. Up to now, however, most spin transfer torque studies focused on metallic ferromagnets, while magnetic insulators were largely ignored, in spite of superior magnetic quality factors. Here, we report the observation of spin torque-induced magnetization dynamics in a magnetic insulator. Our experiments show that in ultrathin magnetic insulators the spin torque induced magnetization dynamics can be substantially larger than those generated by the Oersted field. This opens new perspectives for the efficient integration of ferro-, ferri-, and antiferromagnetic insulators into electronic devices.

preprint2014arXiv

Longitudinal spin Seebeck effect contribution in transverse spin Seebeck effect experiments in Pt/YIG and Pt/NFO

We investigate the inverse spin Hall voltage of a 10nm thin Pt strip deposited on the magnetic insulators Y3Fe5O12 (YIG) and NiFe2O4 (NFO) with a temperature gradient in the film plane. We observe characteristics typical of the spin Seebeck effect, although we do not observe a change of sign of the voltage at the Pt strip when it is moved from hot to cold side, which is believed to be the most striking feature of the transverse spin Seebeck effect. Therefore, we relate the observed voltages to the longitudinal spin Seebeck effect generated by a parasitic out-of-plane temperature gradient, which can be simulated by contact tips of different material and heat conductivities and by tip heating. This work gives new insights into the interpretation of transverse spin Seebeck effect experiments, which are still under discussion.

preprint2014arXiv

Theoretical model for torque differential magnetometry of single domain magnets

We present a generic theoretical model for torque differential magnetometry (TDM) - an experimental method for determining the magnetic properties of a magnetic specimen by recording the resonance frequency of a mechanical oscillator, on which the magnetic specimen has been mounted, as a function of the applied magnetic field. The effective stiffness change, and hence the resonance frequency shift, of the oscillator due to the magnetic torque on the specimen is calculated, treating the magnetic specimen as a single magnetic domain. Our model can deal with an arbitrary magnetic free energy density characterizing the specimen, as well as any relative orientation of the applied magnetic field, the specimen and the oscillator. Our calculations agree well with published experimental data. The theoretical model presented here allows to take full advantage of TDM as an efficient magnetometry method.

preprint2014arXiv

Time resolved spin Seebeck effect experiments

In this Letter, we present the results of transient thermopower experiments, performed at room temperature on yttrium iron garnet/platinum bilayers. Upon application of a time-varying thermal gradient, we observe a characteristic low-pass frequency response of the ensuing thermopower voltage with cutoff frequencies of up to 37 MHz. We interpret our results in terms of the spin Seebeck effect, and argue that small wavevector magnons are of minor importance for the spin Seebeck effect in our thin film hybrid structures.

preprint2013arXiv

Current heating induced spin Seebeck effect

A new measurement technique for the spin Seebeck effect is presented, wherein the normal metal layer used for its detection is exploited simultaneously as a resistive heater and thermometer. We show how the various contributions to the measured total signal can be disentangled, allowing to extract the voltage signal solely caused by the spin Seebeck effect. To this end we performed measurements as a function of the external magnetic field strength and its orientation. We find that the effect scales linearly with the induced rise in temperature, as expected for the spin Seebeck effect.

preprint2013arXiv

Experimental test of the spin mixing interface conductivity concept

We perform a quantitative, comparative study of the spin pumping, spin Seebeck and spin Hall magnetoresistance effects, all detected via the inverse spin Hall effect in a series of over 20 yttrium iron garnet/Pt samples. Our experimental results fully support present, exclusively spin current-based, theoretical models using a single set of plausible parameters for spin mixing conductance, spin Hall angle and spin diffusion length. Our findings establish the purely spintronic nature of the aforementioned effects and provide a quantitative description in particular of the spin Seebeck effect.

preprint2013arXiv

Magnon, phonon and electron temperature profiles and the spin Seebeck effect in magnetic insulator/normal metal hybrid structures

We calculate the phonon, electron and magnon temperature profiles in yttrium iron garnet/platinum bilayers by diffusive theory with appropriate boundary conditions, in particular taking into account interfacial thermal resistances. Our calculations show that in thin film hybrids, the interface magnetic heat conductance qualitatively affects the magnon temperature. Based on published material parameters we assess the degree of non-equilibrium at the yttrium iron garnet/platinum interface. The magnitude of the spin Seebeck effect derived from this approach compares well with experimental results for the longitudinal spin Seebeck effect. Additionally we address the temperature profiles in the transverse spin Seebeck effect.

preprint2013arXiv

Quantitative study of the spin Hall magnetoresistance in ferromagnetic insulator/normal metal hybrids

We experimentally investigate and quantitatively analyze the spin Hall magnetoresistance effect in ferromagnetic insulator/platinum and ferromagnetic insulator/nonferromagnetic metal/platinum hybrid structures. For the ferromagnetic insulator we use either yttrium iron garnet, nickel ferrite or magnetite and for the nonferromagnet copper or gold. The spin Hall magnetoresistance effect is theoretically ascribed to the combined action of spin Hall and inverse spin Hall effect in the platinum metal top layer. It therefore should characteristically depend upon the orientation of the magnetization in the adjacent ferromagnet, and prevail even if an additional, nonferromagnetic metal layer is inserted between Pt and the ferromagnet. Our experimental data corroborate these theoretical conjectures. Using the spin Hall magnetoresistance theory to analyze our data, we extract the spin Hall angle and the spin diffusion length in platinum. For a spin mixing conductance of $4\times10^{14}\;\mathrm{Ω^{-1}m^{-2}}$ we obtain a spin Hall angle of $0.11\pm0.08$ and a spin diffusion length of $(1.5\pm0.5)\;\mathrm{nm}$ for Pt in our thin film samples.