Researcher profile

Mark A. Itzler

Mark A. Itzler contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

Trust snapshot

Quick read

Trust 15 - Baseline
3works
0followers
2topics
4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Research graph

See the researcher in context

Open full explorer

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

3 published item(s)

preprint2015arXiv

Advances in InGaAs/InP single-photon detector systems for quantum communication

Single-photon detectors (SPDs) are the most sensitive instruments for light detection. In the near-infrared range, SPDs based on III-V compound semiconductor avalanche photodiodes have been extensively used during the past two decades for diverse applications due to their advantages in practicality including small size, low cost and easy operation. In the past decade, the rapid developments and increasing demands in quantum information science have served as key drivers to improve the device performance of single-photon avalanche diodes and to invent new avalanche quenching techniques. This Review aims to introduce the technology advances of InGaAs/InP single-photon detector systems in the telecom wavelengths and the relevant quantum communication applications, and particularly to highlight recent emerging techniques such as high-frequency gating at GHz rates and free-running operation using negative-feedback avalanche diodes. Future perspectives of both the devices and quenching techniques are summarized.

preprint2012arXiv

An Ultra-Low Noise Telecom Wavelength Free Running Single Photon Detector Using Negative Feedback Avalanche Diode

It is challenging to implement genuine free running single photon detectors for the 1550 nm wavelength range with simultaneously high detection efficiency (DE), low dark noise, and good time resolution. We report a novel read out system for the signals from a negative feedback avalanche diode (NFAD) which allows useful operation of these devices at a temperature of 193 K and results in very low dark counts (~100 CPS), good time jitter (~30 ps), and good DE (~10%). We characterized two NFADs with a time correlation method using photons generated from weak coherent pulses (WCP) and photon pairs produced by spontaneous parametric down conversion (SPDC). The inferred detector efficiencies for both types of photon sources agree with each other. The best noise equivalent power of the device is estimated to be 8.1 x 10^(-18) W Hz^(-1/2), more than 10 times better than typical InP/InGaAs SPADs show in free running mode. The afterpulsing probability was found to be less than 0.1% per ns at the optimized operating point. In addition, we studied the performance of an entanglement-based quantum key distribution (QKD) using these detectors and develop a model for the quantum bit error rate (QBER) that incorporates the afterpulsing coefficients. We verified experimentally that using these NFADs it is feasible to implement QKD over 400 km of telecom fibre. Our NFAD photon detector system is very simple, and is well suited for single-photon applications where ultra-low noise and free-running operation is required, and some afterpulsing can be tolerated.

preprint2012arXiv

Free Running Single Photon Detection based on a negative feedback InGaAs APD

InGaAs/InP-based semiconductor avalanche photodiode are usually employed for single-photon counting at telecom wavelength. However they are affected by afterpulsing which limits the diode performance. Recently, Princeton Lightwave has commercialised a diode integrating monolithically a feedback resistor. This solution effectively quenches the avalanche and drastically reduces afterpulsing. Here, we report the development and characterization of a detector module based on this diode, implementing an active hold-off circuit which further reduces the afterpulsing and notably improves the detector performances. We demonstrate free-running operation with 600 Hz dark count rate at 10% detection efficiency. We also improved the standard double-window technique for the afterpulsing characterization. Our algorithm implemented by a FPGA allows to put the APD in a well-defined initial condition and to measure the impact of the higher order afterpulses.