Researcher profile

M. Tomsic

M. Tomsic contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

cond-mat.supr-con cond-mat.mtrl-sci physics.app-ph

Trust snapshot

Quick read

Trust 15 - Baseline

3works

0followers

3topics

4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2022arXiv

Minimum Quench Energy Of Nb$_3$Sn Wires With High Specific Heat Tape

A major problem of state-of-the-art Nb$_3$Sn accelerator magnets is their long training due to thermo-mechanical perturbations. Increasing the specific heat, $C_p$, of the Rutherford cable would reduce and/or eliminate training by limiting the coils temperature rise. This paper studies feasibility of increasing the $C_p$ of Rutherford-type cables by using thin composite Cu/$Gd_2$O$_3$ and Cu/$Gd_2$O$_2$S tapes produced by Hyper Tech Research, Inc. The tape can be either wrapped around the cable, placed on the cable wide faces under the insulation, and/or inserted as a core. Wire samples outfitted with these high-$C_p$ ribbons, or tapes, were prepared and tested at FNAL for their Minimum Quench Energy (MQE). At 90%I$_c$ and 15 T, the average gain of MQE of the Nb$_3$Sn wire soldered to the Cu/$Gd_2$O$_2$S 55 micrometer thick ribbon was 2.5, and further increased at larger transport currents.

preprint2014arXiv

The high gas pressure HIP influence on structure and transport properties of $MgB_2$ superconductors of single and multicore composition

Superconducting $MgB_2$ wires in Cu, GlidCop or Monel sheath with Nb or Fe barrier are prepared. Wires vary by sheath material, number of superconducting cores and their chemical composition. Wires are HIP-ed (Hot Isostatic Pressing) at various temperatures ($600-800^oC$) and pressure (up to 1.4 GPa). SEM pictures of cross sections are investigated in order to investigate barrier reactivity and cracking, superconducting material density and grain sizes. Transport measurements are made in magnetic field up to 14 T leading to calculations of critical current density $j_c$ and global pinning force $F_p$. Improvement of transport properties due to higher density of superconducting material is shown.

preprint2011arXiv

Influence of Strand Design, Boron Type, and Carbon Doping Method on the Transport Properties of Powder-in-Tube MgB2-XCX Strands

The transport properties of a number of MgB2 strands have been investigated in terms of their response to strand design, starting B powder choice, and the approach to C doping used. The strands had various designs, specifically; (i) several chemical barriers were introduced, viz: Fe and Nb, (ii) the strands were encased in various outer-sheath materials, viz.: monel, Cu+monel, monel+glidcop, Nb+monel, (iii) the filament counts were varied (1, 18, and 36), and (iv) the final strand diameter was varied. In addition, for a subset of the strand designs several B powder and C-dopant types were investigated. Specifically, two types of amorphous B powder were used: (i) Moissan based "Tangshan boron" (ii) "SMI-boron" which is produced in a plasma torch by the reduction-by-hydrogen of BCl3. Two approaches to C doping were taken: (i) "malic-acid treatment" in which C is introduced into the B powder precursor by the moderate temperature drying out a slurry of B mixed in with a malic-acid-toluene solution (during which the malic acid decomposes leaving C as the only solid residue) before the Mg powder is mixed in; (ii) direct C doping of the SMI-produced B by introducing a known percentage of CH4 into the plasma flame. Critical current densities, Jc, were measured on 1.5 m long samples at 4.2 K in fields of up to 14 T; of all the strands measured, that doped with SMI-C at a nominal 4 mol% C (in relation B) yielded the highest Jc values e.g 1.1x105 A/cm2 at 7 T, 4.5x104 at 10 T, and 2.2x104 A/cm2 at 12 T. The n-values are given for all strands at 5 and 10 T, and for a certain set of strands the magnetic field dependencies of the n-values and the influence of C-doping is presented. Finally we demonstrate that, over a wide range of B, log(Jc) decreases linearly with B with a slope -α such that the Jc(B) of any strand can be parameterized in terms of α and its zero-field intercept Jc(B=0).