Researcher profile

M. P. DeFeo

M. P. DeFeo contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

cond-mat.supr-con physics.ins-det quant-ph

Trust snapshot

Quick read

Trust 19 - Baseline

5works

0followers

3topics

4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2016arXiv

Transient dynamics of a superconducting nonlinear oscillator

We investigate the transient dynamics of a lumped-element oscillator based on a dc superconducting quantum interference device (SQUID). The SQUID is shunted with a capacitor forming a nonlinear oscillator with resonance frequency in the range of several GHz. The resonance frequency is varied by tuning the Josephson inductance of the SQUID with on-chip flux lines. We report measurements of decaying oscillations in the time domain following a brief excitation with a microwave pulse. The nonlinearity of the SQUID oscillator is probed by observing the ringdown response for different excitation amplitudes while the SQUID potential is varied by adjusting the flux bias. Simulations are performed on a model circuit by numerically solving the corresponding Langevin equations incorporating the SQUID potential at the experimental temperature and using parameters obtained from separate measurements characterizing the SQUID oscillator. Simulations are in good agreement with the experimental observations of the ringdowns as a function of applied magnetic flux and pulse amplitude. We observe a crossover between the occurrence of ringdowns close to resonance and adiabatic following at larger detuning from the resonance. We also discuss the occurrence of phase jumps at large amplitude drive. Finally, we briefly outline prospects for a readout scheme for superconducting flux qubits based on the discrimination between ringdown signals for different levels of magnetic flux coupled to the SQUID.

preprint2015arXiv

Coherent-State Storage and Retrieval Between Superconducting Cavities Using Parametric Frequency Conversion

In superconducting quantum information, machined aluminum superconducting cavities have proven to be a well-controlled, low-dissipation electromagnetic environment for quantum circuits such as qubits. They can possess large internal quality factors, $Q_{int}>10^8$, and present the possibility of storing quantum information for times far exceeding those of microfabricated circuits. However, in order to be useful as a storage element, these cavities require a fast "read/write" mechanism--- in other words, they require tunable coupling between other systems of interest such as other cavity modes and qubits, as well as any associated readout hardware. In this work, we demonstrate these qualities in a simple dual cavity architecture in which a low-Q "readout" mode is parametrically coupled to a high-Q "storage" mode, allowing us to store and retrieve classical information. Specifically, we employ a flux-driven Josephson junction-based coupling scheme to controllably swap coherent states between two cavities, demonstrating full, sequenced control over the coupling rates between modes.

preprint2012arXiv

Superconducting microstrip amplifiers with sub-Kelvin noise temperature near 4 GHz

We present measurements of an amplifier operating at 3.8 GHz with 150 MHz of bandwidth based on the microstrip input-coil resonance of a dc superconducting quantum interference device (SQUID) with submicron Josephson junctions. The noise temperature is measured using two methods: comparing the signal-to-noise ratio of the system with and without the SQUID in the amplifier chain, and using a modified Y-factor technique where calibrated narrowband noise is mixed up to the SQUID amplifier operating frequency. With the SQUID cooled to 0.35 K we observe a minimum system noise temperature of 0.55 $\pm~0.13$ K, dominated by the contribution from the SQUID amplifier.

preprint2010arXiv

Microstrip superconducting quantum interference device amplifiers with submicron Josephson junctions: enhanced gain at gigahertz frequencies

We present measurements of an amplifier based on a dc superconducting quantum interference device (SQUID) with submicron Al-AlOx-Al Josephson junctions. The small junction size reduces their self-capacitance and allows for the use of relatively large resistive shunts while maintaining nonhysteretic operation. This leads to an enhancement of the SQUID transfer function compared to SQUIDs with micron-scale junctions. The device layout is modified from that of a conventional SQUID to allow for coupling signals into the amplifier with a substantial mutual inductance for a relatively short microstrip coil. Measurements at 310 mK exhibit gain of 32 dB at 1.55 GHz.

preprint2009arXiv

Reducing microwave loss in superconducting resonators due to trapped vortices

Microwave resonators with high quality factors have enabled many recent breakthroughs with superconducting qubits and photon detectors, typically operated in shielded environments to reduce the ambient magnetic field. Insufficient shielding or pulsed control fields can introduce vortices, leading to reduced quality factors, although increased pinning can mitigate this effect. A narrow slot etched into the resonator surface provides a straightforward method for pinning enhancement without otherwise affecting the resonator. Resonators patterned with such a slot exhibited over an order of magnitude reduction in the excess loss due to vortices compared with identical resonators from the same film with no slot.