Researcher profile

Loren Jørgensen

Loren Jørgensen contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

Trust snapshot

Quick read

Trust 13 - Baseline
2works
0followers
2topics
4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Research graph

See the researcher in context

Open full explorer

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

2 published item(s)

preprint2020arXiv

Deformation upon impact of a concentrated suspension drop

We study the impact between a plate and a drop of non-colloidal solid particles suspended in a Newtonian liquid, with a specific attention to the case when the particle volume fraction, $ϕ$, is close to - or even exceeds - the critical volume fraction, $ϕ_c$, at which the steady effective viscosity of the suspension diverges. We use a specific concentration protocol together with an accurate determination of $ϕ$ for each drop and we measure the deformation $β$ for different liquid viscosities, impact velocities and particle sizes. At low volume fractions, $β$ is found to follow closely an effective Newtonian behavior, which we determine by documenting the low deformation limit for a highly viscous Newtonian drop and characterizing the effective shear viscosity of our suspensions. By contrast, whereas the effective Newtonian approach predicts that $β$ vanishes at $ϕ_c$, a finite deformation is observed for $ϕ>ϕ_c$. This finite deformation remains controlled by the suspending liquid viscosity and increases with increasing particle size, which suggests that the dilatancy of the particle phase is a key factor of the dissipation process close to and above $ϕ_c$.

preprint2015arXiv

Yield stress and elasticity influence on surface tension measurements

We have performed surface tension measurements on carbopol gels of different concentrations and yield stresses. Our setup, based on the force exerted by a capillary bridge on two parallel plates, allows to measure an effective surface tension of the complex fluid and to investigate the influence of flow history. More precisely the effective surface tension measured after stretching the bridge is always higher than after compressing it. The difference between the two values is due to the existence of a yield stress in the fluid. The experimental observations are successfully reproduced with a simple elasto-plastic model. The shape of successive stretching-compression cycles can be described by taking into account the yield stress and the elasticity of the gel. We show that the surface tension $γ_{LV}$ of yield stress fluids is the mean of the effective surface tension values only if the elastic modulus is high compared to the yield stress. This work highlights that thermodynamical quantities measurements are challenged by the fluid out-of-equilibrium state implied by jamming, even at small scales where the shape of the bridge is driven by surface energy. Therefore setups allowing deformation in opposite directions are relevant for measurements on yield stress fluids.