Researcher profile

Hélène Delanoë-Ayari

Hélène Delanoë-Ayari contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

Cell Behavior cond-mat.soft

Trust snapshot

Quick read

Trust 15 - Baseline

3works

0followers

2topics

4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2022arXiv

Linear correlation between active and resistive stresses informs on force generation and stress transmission in adherent cells

Animal cells are active, contractile objects. While bioassays address the molecular characterization of cell contractility, the mechanical characterization of the active forces in cells remains challenging. Here by confronting theoretical analysis and experiments, we calculated both the resistive and the active components of the intracellular stresses that build up following cell adhesion. We obtained a linear relationship between the divergence of the resistive stress and the traction forces, which we show is the consequence of the cell adhering and applying forces on the surface only through very localized adhesion points (whose size is inferior to our best resolution, of 400 nm). This entails that there is no measurable forces outside of these active point sources, and also that the resistive and active stresses inside cells are proportional.

preprint2022arXiv

Quantifying active and resistive stresses in adherent cells

To understand cell migration, it is crucial to gain knowledge on how cells exert and integrate forces on/from their environment. A quantity of prime interest for biophysicists interested in cell movements modeling is the intracellular stresses. Up to now, three different methods have been proposed to calculate it, they are all in the regime of the thin plate approximation. Two are based on solving the mechanical equilibrium equation inside the cell material (Monolayer Stress Microscopy, and Bayesian Inference Stress Microscopy) and one is based on the continuity of displacement at the cell/substrate interface (Intracellular Stress Microscopy). We show here using 3D FEM modeling that these techniques do not calculate the same quantities (as was previously assumed), the first techniques calculate the sum of the active and resistive stresses within the cell, whereas the last one only calculate the resistive component. Combining these techniques should in principle permit to get access to the active stress alone.

preprint2015arXiv

Yield stress and elasticity influence on surface tension measurements

We have performed surface tension measurements on carbopol gels of different concentrations and yield stresses. Our setup, based on the force exerted by a capillary bridge on two parallel plates, allows to measure an effective surface tension of the complex fluid and to investigate the influence of flow history. More precisely the effective surface tension measured after stretching the bridge is always higher than after compressing it. The difference between the two values is due to the existence of a yield stress in the fluid. The experimental observations are successfully reproduced with a simple elasto-plastic model. The shape of successive stretching-compression cycles can be described by taking into account the yield stress and the elasticity of the gel. We show that the surface tension $γ_{LV}$ of yield stress fluids is the mean of the effective surface tension values only if the elastic modulus is high compared to the yield stress. This work highlights that thermodynamical quantities measurements are challenged by the fluid out-of-equilibrium state implied by jamming, even at small scales where the shape of the bridge is driven by surface energy. Therefore setups allowing deformation in opposite directions are relevant for measurements on yield stress fluids.