Source author record

Koichi Mayumi

Koichi Mayumi appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.soft cond-mat.mtrl-sci physics.chem-ph

Catalog footprint

What is connected

2works

3topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2022arXiv

Tri-branched gels: Rubbery materials with the lowest branching factor approach the ideal elastic limit

Unlike hard materials such as metals and ceramics, rubbery materials can endure large deformations due to the large conformational degree of freedom of the crosslinked three-dimensional polymer network. However, the effect of the branching factor of the network on the ultimate mechanical properties of rubbery materials has not yet been clarified. This study shows that tri-branching, which entails the lowest branching factor, results in a large elastic deformation near the theoretical upper bound. This ideal elastic limit is realized by reversible strain-induced crystallization, providing on-demand reinforcement. The findings indicate that the polymer chain is highly orientated along the stretching axis, whereat enhanced reversible strain-induced crystallization is observed in the tri-branched and not in the tetra-branched network. A mathematical theory of structural rigidity is used to explain the difference in the chain orientation. Although tetra-branched polymers have been preferred since the development of vulcanization, these findings highlighting the merits of tri-branching will prompt a paradigm shift in the development of rubbery materials.

preprint2016arXiv

Fracture of dual crosslink gels with permanent and transient crosslinks

We have carried out systematic fracture experiments in a single edge notch geometry over a range of stretch rates on dual crosslink hydrogels made from polyvinyl alcohol chains chemically crosslinked with glutaraldehyde and physically crosslinked with borate ions. If the energy release rate necessary for crack propagation was calculated conventionally, by using the work done to deform the sample to the critical value of stretch $λ_c$ where the crack propagates, we found that the fracture energy $Γ$ peaks around $λ\sim 0.001 s^{-1}$ before decreasing sharply with increasing stretch rate, in contradiction with the measurements of crack velocity. Combining simulations and experimental observations, we propose therefore here a general method to separate the energy dissipated during loading before crack propagation, from that which is dissipated during crack propagation. For fast loading rates (with a characteristic strain rate only slightly lower than the inverse of the typical breaking time of physical bonds), this improved method to estimate a local energy release rate $g_{local}$ at the onset of crack propagation, gives a value of the local fracture energy $Γ_{local}$ which is constant, consistent with the constant value of the crack propagation velocity measured experimentally. Using this improved method we also obtain the very interesting result that the dual crosslink gels have a much higher value of fracture energy at low loading rates than at high loading rates, contrary to the situation in classical chemically crosslinked elastic networks.