Researcher profile

K. Shastry

K. Shastry contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

cond-mat.mtrl-sci physics.atom-ph

Trust snapshot

Quick read

Trust 15 - Baseline

3works

0followers

2topics

4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2016arXiv

Positron surface state as a spectroscopic probe for characterizing surfaces of topological insulator materials

Topological insulators are attracting considerable interest due to their potential for technological applications and as platforms for exploring wide-ranging fundamental science questions. In order to exploit, fine-tune, control and manipulate the topological surface states, spectroscopic tools which can effectively probe their properties are of key importance. Here, we demonstrate that positrons provide a sensitive probe for topological states, and that the associated annihilation spectrum provides a new technique for characterizing these states. Firm experimental evidence for the existence of a positron surface state near Bi$_2$Te$_2$Se with a binding energy of $E_b = 2.7 \pm 0.2 \, \text{eV}$ is presented, and is confirmed by first-principles calculations. Additionally, the simulations predict a significant signal originating from annihilation with the topological surface states and shows the feasibility to detect their spin-texture through the use of spin-polarized positron beams.

preprint2014arXiv

Measurement of the background in Auger-photoemission coincidence spectra (APECS) associated with inelastic or multi-electron valence band photoemission processes

Auger Photoelectron Coincidence Spectroscopy (APECS), in which the Auger spectra is measured in coincidence with the core level photoelectron, is capable of pulling difficult to observe low energy Auger peaks out of a large background due mostly to inelastically scattered valence band (VB) photoelectrons. However the APECS method alone cannot eliminate the background due to valence band photoemission processes in which the initial photon energy is shared by two or more electrons and one of the electrons is in the energy range of the core level photoemission peak. Here we describe an experimental method to determine the contributions from these background processes and apply this method in the case of Copper M3VV Auger spectrum obtained in coincidence with the 3p3/2 photoemission peak. A beam of 200 eV photons was incident on a Cu(100) sample and a series of coincidence measurements were performed using a spectrometer equipped with two cylindrical mirror analyzers (CMAs). One CMA was set at series of fixed energies that ranged between the energy of the core and the VB peaks. The other CMA was scanned over a range corresponding to electrons leaving the surface between 0eV and 70eV. The set of measured spectra were then fit to a parameterized function which was extrapolated to determine the background in the APECS spectra due to multi-electron and inelastic VB photoemission processes. The extrapolated background was subtracted from the APECS spectrum to obtain the spectrum of electrons emitted solely as the result of the Auger process. A comparison of the coincidence spectrum with the same spectrum with background removed shows that in the case of Cu M3VV the background due to the inelastic scattering of VB electrons is negligible in the region of the Auger peak but is more than half the total signal down in the low energy tail of the Auger peak.

preprint2011arXiv

Background Free Measurement of the Spectra of Low Energy Electrons Emitted as a Result of Auger Transitions in Metals

Positron annihilation induced Auger electron spectroscopy was used to obtain Cu and Au Auger spectra that are free of primary beam induced background by impinging the positrons at energy below the secondary electron emission threshold. The removal of the core electron via annihilation in the PAES process resulted in the elimination of post-collision affects. The spectrum indicates that there is an intense low energy tail (LET) associated with the Auger peak that extends all the way to 0 eV. The LET has been interpreted as being due to processes in which the filling of the core by a valence electron results in the ejection of two or more valence electrons which share the energy of the otherwise Auger electron