Researcher profile

K. Rott

K. Rott contributes to research discovery and scholarly infrastructure.

ResearcherAffiliation not importedOpen to collaborate

Trust snapshot

Quick read

Trust 15 - Baseline
3works
0followers
2topics
4close collaborators

Actions

Decide how to stay connected

Follow researcher0

Research graph

See the researcher in context

Open full explorer

Inspect adjacent work, topics, institutions and collaborators without jumping out to a separate graph page.

Building this graph slice

BZPEER is loading the nearby papers, people, topics and institutions for this page.

Published work

3 published item(s)

preprint2013arXiv

Magneto-thermoelectric figure of merit of Co/Cu multilayers

The switching of the magnetization configurations of giant magnetoresistance multilayer stacks not only changes the electric and thermal conductivities, but also the thermopower. We study the magnetotransport and the magneto-thermoelectric properties of Co/Cu multilayer devices in a lateral thermal gradient. We derive values of the Seebeck coefficient, the thermoelectric figure of merit, and the thermoelectric power factor. The Seebeck coefficient reaches values up to -18 microvolt/K at room temperature and shows a magnetic field dependence up to 28.6 % upon spin reversal. In combination with thermal conductivity data of the same Co/Cu stack, we find a spin dependence of the thermoelectric figure of merit of up to 65 %. Furthermore, a spin dependence of the power factor of up to 110 % is derived.

preprint2011arXiv

Determination of spin-dependent Seebeck coefficients of CoFeB/MgO/CoFeB magnetic tunnel junction nanopillars

We investigate the spin-dependent Seebeck coefficient and the tunneling magneto thermopower of CoFeB/MgO/CoFeB magnetic tunnel junctions (MTJ) in the presence of thermal gradients across the MTJ. Thermal gradients are generated by an electric heater on top of the nanopillars. The thermo power voltage across the MTJ is found to scale linearly with the heating power and reveals similar field dependence as the tunnel magnetoresistance. The amplitude of the thermal gradient is derived from calibration measurements in combination with finite element simulations of the heat flux. Based on this, large spin-dependent Seebeck coefficients of the order of (240 \pm 110) \muV/K are derived. From additional measurements on MTJs after dielectric breakdown, a tunneling magneto thermopower up to 90% can be derived for 1.5 nm MgO based MTJ nanopillars.

preprint2011arXiv

Tunneling magneto thermo power in magnetic tunnel junction nanopillars

We study the tunneling magneto thermo power (TMTP) in CoFeB/MgO/CoFeB magnetic tunnel junction nanopillars. Thermal gradients across the junctions are generated by a micropatterned electric heater line. Thermo power voltages up to a few tens of \muV between the top and bottom contact of the nanopillars are measured which scale linearly with the applied heating power and hence with the applied temperature gradient. The thermo power signal varies by up to 10 \muV upon reversal of the relative magnetic configuration of the two CoFeB layers from parallel to antiparallel. This signal change corresponds to a large spin-dependent Seebeck coefficient of the order of 100 \muV/K and a large TMTP change of the tunnel junction of up to 90%.