Source author record

K. Kamarás

K. Kamarás appears in the imported research catalog. Authorship, coauthor and topic links are available while profile ownership is still unclaimed.

ResearcherUnclaimed source record

cond-mat.mes-hall cond-mat.mtrl-sci cond-mat.str-el

Catalog footprint

What is connected

4works

3topics

4close collaborators

Actions

Connect this record

Open graph Browse works

Inspect adjacent papers, topics, institutions and collaborators without losing the researcher page.

Building this map preview

BZPEER is loading the nearby papers, people, topics and institutions for this page.

preprint2021arXiv

Ultrahigh nitrogen-vacancy center concentration in diamond

High concentration of negatively charged nitrogen-vacancy ($\text{NV}^{-}$) centers was created in diamond single crystals containing approximately 100 ppm nitrogen using electron and neutron irradiation and subsequent thermal annealing in a stepwise manner. Continuous wave electron paramagnetic resonance (EPR) was used to determine the transformation efficiency from isolated N atoms to $\text{NV}^{-}$ centers in each production step and its highest value was as high as 17.5 %. Charged vacancies are formed after electron irradiation as shown by EPR spectra, but the thermal annealing restores the sample quality as the defect signal diminishes. We find that about 25 % of the vacancies form NVs during the annealing process. The large $\text{NV}^{-}$ concentration allows to observe orientation dependent spin-relaxation times and also the determination of the hyperfine and quadrupole coupling constants with high precision using electron spin echo (ESE) and electron-nuclear double resonance (ENDOR). We also observed the EPR signal associated with the so-called W16 centers, whose spectroscopic properties might imply a nitrogen dimer-vacancy center for its origin.

preprint2016arXiv

Electronic and ionic conductivities in superionic Li$_4$C$_{60}$

The $10$ GHz microwave conductivity, $σ(T)$ and high field, $222$ GHz electron spin resonance (HF-ESR) of Li$_4$C$_{60}$ fulleride is measured in a wide temperature range. We suggest that the majority of ESR active sites and at least some of the charge carriers for $σ(T)$ are electrons bound to a small concentration of surplus or vacancy ions in the polymer phase. Both $σ(T)$ and the ESR line shape depend on ionic motion. A change of the activation energy of $σ(T)$ at $125$ K coincides with the onset of the ionic DC conductivity. The ESR line shape is determined mainly by Li ionic motion within octahedral voids below $150$ K. At higher temperatures, fluctuations due to ionic diffusion change the environment of defects from axial to effectively isotropic on the ESR time scale. $σ(T)$ data up to $700$ K through the depolymerization transition confirm that the monomeric phase of Li$_4$C$_{60}$ is a metal.

preprint2012arXiv

Pressure-induced transition from the dynamic to static Jahn-Teller effect in (Ph$_{4}$P)$_{2}$IC$_{60}$

High-pressure infrared transmission measurements on \PhC60 were performed up to 9 GPa over a broad frequency range (200 - 20000 cm$^{-1}$) to monitor the vibrational and electronic/vibronic excitations under pressure. The four fundamental T$_{1u}$ modes of \C60a\ are split into doublets already at the lowest applied pressure and harden with increasing pressure. Several cation modes and fullerene-related modes split into doublets at around 2 GPa, the most prominent one being the G$_{1u}$ mode. The splitting of the vibrational modes can be attributed to the transition from the dynamic to static Jahn-Teller effect, caused by steric crowding at high pressure. Four absorption bands are observed in the NIR-VIS frequency range. They are discussed in terms of transitions between LUMO electronic states in \C60a, which are split because of the Jahn-Teller distortion and can be coupled with vibrational modes. Various distortions and the corresponding symmetry lowering are discussed. The observed redshift of the absorption bands indicates that the splitting of the LUMO electronic states is reduced upon pressure application.

preprint2010arXiv

Mapping of functionalized regions on carbon nanotubes by scanning tunneling microscopy

Scanning tunneling microscopy (STM) gives us the opportunity to map the surface of functionalized carbon nanotubes in an energy resolved manner and with atomic precision. But this potential is largely untapped, mainly due to sample stability issues which inhibit reliable measurements. Here we present a simple and straightforward solution that makes away with this difficulty, by incorporating the functionalized multiwalled carbon nanotubes (MWCNT) into a few layer graphene - nanotube composite. This enabled us to measure energy resolved tunneling conductance maps on the nanotubes, which shed light on the level of doping, charge transfer between tube and functional groups and the dependence of defect creation or functionalization on crystallographic orientation.